Using logic gates, design an active low chip select for the memory a 256 K memory device starting at address 38000016 in a 16 Megabyte memory space.
Q: The zeros of the transfer function * s²+2s+2 s4 +6s3 +4s²+7s+12
A: Given transfer function: F(s)=s2+2s+2s4+6s3+4s2+7s+12
Q: A workshop 100 m x 50 m is to be illuminated with intensity of illumination being 50 lux. Determine…
A: Given: The workshop is dimension is 100 m x 50 m The illumination is 50 lux The coefficient of…
Q: A self-inductance of 10 mH and its resistance 5 connect to AC source of voltage 200 V, and frequency…
A: The impedance of the circuit is, Z=R+jωLR=5 ΩL=10 mHω=2πfω=120πZ=5+j120π×10×10-3 ΩZ=5+j3.77…
Q: Determine and sketch the spectrum of the DSB-SC signal 2m(t) cos 4000rt for the following message…
A: Given,The DSB-SC signal is,DSB-SC=2mtcos4000πtThe message signal is,mt=sinc2100πt-50π
Q: 5. Deterime the total current I if terminals A and B is shorted. 100 V 12 ohms a b 28 ohms 20 ohms…
A: 5) To determine the total current I in the circuit if the terminals A and B are shorted
Q: Determine the total parallel inductance for the following coils in parallel: 75 μH, 50 μΗ, 25 μΗ,…
A:
Q: 5. Determine the following: a. Total Current and currents passing through each of the resistance. b.…
A:
Q: V₁ R₁ www 4₁ R₂ www R3 12 www R4 www 12 (↓) i
A:
Q: Convert the number -3410 to IEEE-754 floating point. Include only the first 6 bits of
A: The floating point numbers are represented by IEEE-754 standard format. It can be single precision…
Q: Problem-4) Two-watt meters, which are connected to measure the total power on a three-phase system…
A: Given data- 2 watt meters, Readings=10.5 kW & 2.5 kW. To Find- The power factor of the circuit.
Q: A gain of 11 is required from a noninverting constant- multiplier op-amp circuit. If the input…
A: Given Gain = 11 and R = 10k ohm Rf = ?
Q: 7. A battery with an internal resistance of 1.5 ohm is connected in series with resistors R₁ = 3 ohm…
A:
Q: The numbers are placed in the memory locations 2501 to 2504H. The sum is to be stored in the memory…
A: Solution !!
Q: A receiver is tuned to an RF signal of 96 MHz and the LO frequency is 100 104 MHz O 108 MHz 98 MHz…
A: Given data, RF signal frequency, fs=96 MHz. Local oscillator frequency, fl=100 MHz.
Q: Find and sketch c(t) = x₁(t) * x₂(t) for the pairs of functions illustrated below. A x₁(1) 461- (a)…
A:
Q: 1. A. Hoover dam is located 275 miles from Los Angeles and it supplies 60 Hz power to the city. Can…
A: Given that: The circuit is shown below. Find: Write equations Ohm’s law and Kirchhoff's law.…
Q: Two equal vectors have an angle of 22° and 48°, respectively, with respect to the positive x axis.…
A:
Q: QUESTION 3 A coil has an ac voltage of 120 V. The current through the coil is 10 4-85° A What is the…
A: (3) It is given that: Vac=120 VI=10∠-85° A
Q: (a) A 4-pole generator, with wave wound armature, has 51 slots, each having 24 conductors. The flux…
A:
Q: For the closed-loop system shown, and given: 5 G(s) 20 8²+ 2.938+ 5 Pref + C(s) control G(s) plant…
A:
Q: Simplify the following boolean expression: F = a + (c'ab'd)
A: Given: The Boolean expression is, F=a+c'ab'd.
Q: a. b. Y(s) 2 X(s) S-6 Y(s) 2 X(s) S+6 = = Input X (s) 572 C. d. 4 Output Y(s) Y(s) 2 X(s) s-10 Y(s)…
A: Given, A closed loop system is shown below,
Q: A 110V d.c. generator supplies a lighting load of forty 100W bulbs, a heating load of 10kW and other…
A: It is given that: Vd.c.=100 VPbulb=100WPheating=10kWI15=15 A
Q: The equivalent resistance of a series- parallel circuit shown in Fig. 1.7 is
A: It is given that:
Q: 3. The voltage source in the circuit of Figure C has a current of 1A flowing out of its positive…
A:
Q: Transform each of the following into phasor form: (a) 28 cos (20t) (b) 32 sin (2t-90°) (c) sin…
A:
Q: For a two pole-pairs, 50 Hz, 3-phase synchronous motor, the speed of rotor is 1450 rpm 1500 rpm 2450…
A: Given: A 3-phase synchronous motor has, Number of pole pair is 2. Frequency, f=50 Hz.
Q: Sine-wave generator + 1.0 kHz 1.0 V TISS Voltage across R1, VR Total current, I www 1.0 k Voltage…
A:
Q: Sine-wave www 1.0 k generator 1.0 kHz 1.0 V Voltage across R1, VR Total current, I Voltage across L,…
A: In the given questions, we need to calculate the calculated and measured value of voltage across…
Q: For the given logic circuit, find the following: a. Logic Equation or Output b. Simplified logic…
A: It is given that:
Q: What voltage would a code of 190 belong to on a step of 3.9mV?
A:
Q: Your turn: Determine V3 employing voltage division 6 Volt + 5 102 202 + V3 +51 402 202 www + Sª V₂
A: We need to find out the voltage for given circuit by using of voltage division rule
Q: A circular loop of area 5 x 10²m² rotates in a uniform magnetic field of 0.2 T. If the loop rotates…
A: Solution !!
Q: b) If the base current is 100 mA and the current gain is 30, the emitter current is?
A: Given, Current gain, β=30. Base current, IB=100 mA=100×10-3 A. Emitter current, IE=?
Q: 2.14 Calculate the value of I in the circuit in Fig. P2.14. m
A:
Q: Identify applications of the RCM-RCA methodology in our daily life and in the industry.
A: SOLUTION RCM stand for RELIABILITY CENTERED MAINTENANCE and RCA stand…
Q: B-5-8. Referring to the system shown in Figure 5-75, de- termine the values of K and k such that the…
A:
Q: In a two-terminal network, the open-circuit voltage measured at the given terminals by an electronic…
A: Given data- 2 terminal network, Open circuit voltage- Voc=100 V, Ammeter reading I=5 A, Load…
Q: Question 10 Not yet answered Marked out of The results from the DC test of a single phase…
A: Given the result from dc test of single phase transformer, DC Volatge, Vdc=14 V.DC Current, Idc=1.5…
Q: Assuming that a 4-bit ADC accepts analog input ranging from 0 to 6 volts, solve the following: a)…
A: ADC stands for analog to digital converter. It convert analog signal in to digital form . Digital…
Q: Question 2 For a two pole-pairs, 50 Hz, 3-phase synchronous motor, the speed of rotor is 1450 rpm…
A: Given: A 3-phase synchronous motor has, Number of pole pair is 2. Frequency, f=50 Hz.
Q: 3. Calculate the value of voltage in the circuit. = U=? 1=3 mA www R1 600 Ω
A: Given data, Circuit diagram is given as,
Q: Draw the logic diagram and logic equation of the followings: NAND IMPLEMENTATION: A. NOT B. AND…
A: As per company guidelines, we are supposed to answer the first 3 subparts of the question. Kindly…
Q: In order to measure the power taken by a small 120-V 60-Hz single-phase induction motor, it is…
A: Given data: The voltage VS=220 V, 60 Hz The resistor current, IR=3 A The motor current,IL=4.2 A…
Q: 13 The following details are known about a 250 hp, 230 V, 435 r/min de shunt motor: nominal…
A: NOTE: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts…
Q: In the transformer shown in the below figure, the inductance measured across the terminal 1 and 2…
A: When two inductance L1 and L2 are connected in series and coupled through mutual inductance M then…
Q: Solve for I1, 12, 13, and Vx. 4ΚΩ 220V Hilt M 11 12 a 4ΚΩ 8kΩ 13 Vx Μ 4ΚΩ ΣΚΩ
A: Given that: The circuit is shown below. Find: Using KCL and KVL find I1, I2, I3, and Vx.
Q: An analog signal is to be coded by an ADC. The signal contains significant frequencies up to 3.2kHz.…
A: We need to analyse the given sampled signal , we need to find out sampling frequency and number of…
Q: A signal with 60 milliwatts power passes through a device with an average noise of 6 microwatts.…
A: We need to find out the SNR for given power for given signal power and noise power .
Q: Question 7: A 415V, three-phase, 50 Hz, 4-pole, star-connected induction motor runs at 24 rev/s on…
A: Given: The motor rating is 415 V, 50 Hz and 4 pole The resistances and reactance per phase are 0.35…
Using logic gates, design an active low chip select for the memory a 256 K memory device starting at address 38000016 in a 16 Megabyte memory space.
Step by step
Solved in 2 steps
- Draw the figure for memory segments with 8086 microprocessor software model. Explain the logical address structure used for each segment (Explain which registers are used in logical address presentation of each segment; segment address : offset address). Give an example solution to find the physical address in a segment from the logical address for 8086 microprocessor.Write an assembly language program for 8085 microprocessor to add 2 digit BCD numbers stored in memory location C050H and C051H respectively and store the result in memory location C052H.Construct a bus system using tri state buffer for 2 registers having 4 bits each.
- Microprocessor , For a data segments for an 8086 µP memory system has 64 kB size, with segment address is 1234 H. Find the offset for a memory address 125FC H.Eight memory chips of 32*4 bit size have their address buses connected together. What is the size of the memory system ?Microprocessors; Draw the figure for flag-bits allocation in an 8086 microprocessor. Explain shortly the meanings of letters used for each flag statues in Assembler.
- Discuss the evolution of memory technologies, from early magnetic core memory to modern NAND flash and 3D XPoint, and their implications for storage capacity and speed.A 4 bit binary count have terminal count of?How much leakage is permitted per memory cellin a 256-Mb static CMOS memory chip if the totalstandby current of the memory is to be less than1 mA? (b) Repeat for a 4-Gb memory.
- Select a suitable logic family, which has extremely low power consumption. (a) CMOS logic family (b) Emitter coupled family (c) Transistor – Transistor logic (d) None of the aboveA memory chip from a digital camera has 25 bistable (ON-OFF) memory elements. What is the total number of ON-OFF configurations?Draw the the basic logic diagram of decimal to BCD Encoder .