using the law below find the Value of In Zn-Zo Kn= Zn+zo Data - Kr=0₁4 | 45₁ Zo= 50 2 find Zs Zs=Zo Zu + Zo x tau Bd Zo +jZrtan B d tanBd=1.740 A

Q: Analyse the logic circuit of Fig. 11.2 and show that it can be replaced by a single NAND gate. Ao Bo…

A: Given: A logic circuit diagram having output as f=AB¯+A¯+B¯ we have to show that the given circuit…

Q: û (e) Insert the dc power supply (set to 2V) between the diode and ground as shown in Fig. Sketch…

A:

Q: 25k Ri va V2 100k. ± √b + lov + Vo -TOV Vout Rf vin RE

A:

Q: A DC A 0.5 m diameter pulley is attached to the motor. A force of 100 newtons is felt tangentially…

A:

Q: Estimate the percentage change of power for a DSB-SC AM system when the value of the modulation…

A: Given information: For a DSB-SC AM system, the initial value of the modulation index is 0.6 and the…

Q: For an inverting amplifier, R(i)= 100 killo ohm and R(f) = 600 killo ohm. What is the output voltage…

A: We need to find out output for inverting amplifier

Q: Create 10 pairs (x, y) of random numbers such that Ix-yl > 0.25 and either x + y > 0.7 or xy ≤ 0.4.…

A: Given  (x-y >0.25 ) and ((x+y)>0.7)or (xy≤0.4) Asked to generate 10 pairs of x and y values…

Q: An electric load operates at 100 V rms. The load absorbs 5 kW of power with lagging power factor of…

A: Given, Electrical load operating voltage, Vrms=100 V Load absorb power, P=5 kW Power factor,…

Q: Consider an electric motor that requires a 120 V rms power source and a current of 1.5 A rms. If the…

A: Given an electric motor that requires a, Source voltage, Vrms=120 V Current, Irms=1.5 A The…

Q: 3. A DC generator has no-load output voltage of 150 volts. It's armature circuit resistance IS 0.95…

A: Given data No load voltage(VN) = 150V Armature resistance(Ra) = 0.95 Ohms P = 3000W at V = 115V…

Q: Done + Estimate the percentage change of power for a DSB-SC AM system when the value of the…

A: Given: The modulation index of DSB-SC AM system changes from 0.6 to 0.9. The corresponding…

Q: Analyse the logic circuit of Fig. 11.2 and show that it can be replaced by a single NAND gate. Ao Bo…

A:

Q: The signal x(t) = cos2n70t+cos 27120t is input to the square-law modulator system given below with…

A: Given:xt=12cos2π.70t+13cos2π.120t, Ac=10 and fc=10 kHz.

Q: An alternating emf is represented by the equation e = 400 sin 377t. The following parameters are…

A: An alternating emf is represented by the equation e = 400 sin 377t.

Q: Electrical engineering Calculate the resistance of an annealed copper conductor, 2000 m long and…

A: We need to find out resistance of given wire

Q: Two parallel-connected impedance Z₁ = 8 + j 6 2 and Z₂ = 10 + j 2 2 are connected in series with 15…

A: Given:  two parallel impedance are connected in series with 15 Ω. Supply voltage is 50 V, 50 Hz we…

Q: 1) Compute the Fourier Transform of each of the following signal: a) [e-at cos wot]u(t), a > 0 b)…

A: Given:  a e-atcosω0tut,α>0be-3tsin2tcxt=1+cosπt,t≤10,                t>1

Q: A 3-phase induction motor runs at 3% slip and develops mechanical power equal to 10 kW. The air gap…

A:

Q: In Norton's equivalent IN is the a. Short circuit current between the load terminals O b. Short…

A:

Q: 3. Find the current value, V₁, V₂, and Vo. Vin = 10 V R₁ = 4.7 kQ I www A M - 5 V V₂ R2= 2.2 ΚΩ

A: Given:

Q: Use superposition to find the voltage vo 312 70 Vo $200 16 A 19

A:

Q: 1.22 1.23 12V Given the circuit in Figure resistor is: (a) 12 V (b) 6 V V₂ 12 V 6ΚΩ 10k2 |15ΚΩ…

A:

Q: Three impedances Z₁-5+j8 12, Za-4-j6 22 and Zc-7+j10 2 are connected in parallel to an ac supply. If…

A:

Q: Calculate the current I. 150 -jsn 4/60 20/45 V 80 30/75 j100 30/30* 70/60° V

A:

Q: An unmodulated AM signal produces a current of 5.4 A. If the modulation is 100 percent, calculate:…

A: Given information: The depth of amplitude modulation is 100% and the current corresponding to the…

Q: Example: By Using the superposition theorem find I in the circuit shown in figure? 100 www 20V 59 V…

A: In this question,  We need to determine the current I as shown the circuit using the super position…

Q: is (t) (* = 0 IF R{ v For the RC circuit above, the initial voltage across the capacitor is zero.…

A: Given a circuit with following data R = 2kΩ C = 25μF is(t) = 10mA Switch is closed at time t = 0…

Q: The conductors of a three phase transmission line are symmetrically arranged in a triangle. If the…

A:

Q: 2. Find the quiescent point of the PMOS transistor in Figure 1.2 given that V=-2V and 1/2μpCox (W/L)…

A:

Q: 1. A shunt generator supplies a load of 4,500 W at 120 V through a pair feeder conductors having a…

A:

Q: Managers at Walmart set daily goals of how many "red cards" need to be opened each hour, what type…

A: ANSWER      Proporional Derivative Controller Or PD Controller…

Q: Find the value of R, and the maximum power that can be delivered to it. 2.4 ks) m 60 V 1.6 k SARAD…

A:

Q: Each of the three insulators forming a string has a self capacitance of C farad. The shunt…

A: String efficiency is the ratio of the voltage across the entire string to the sum of the voltages…

Q: The resistance of 125 strain gauge changes by 1 Q for 4000 micro- strain. The gauge factor for…

A: Given: Resistance, R=125 Ω Change in resistance, ∆R=1 Ω Strain, ∆ll=4000×10-6 strain

Q: Find the Laplace transform of

A: In this case, the Laplace transform of the following function needs to be determined: xt=-e-atu-t

Q: For a FM signal v(t) = 20 cos ( 10 * 108t + 30 sin 3000t), calculate the power dissipated by

A:

Q: An npn BJT operating in the active region with B=100 and VA =250 V, and V₁ =25 mV, If Ic=1 mA then:…

A: Given data, A npn BJT operating in the active region has β=100VA=250 VVT=25 mVIC=1 mA

Q: Question 2 A circuit has a voltage of 5020 V and a current of 52-10 A. The angle of the circuit's…

A: Given: Circuit voltage, V=50∠0° V Circuit current, I=5∠-10° A

Q: Calculate the current flowing in the 5 2 resistor for the network shown below using Thevenin's…

A:

Q: 1. A FREECAD model for a 20x20x20 mm block with a 10 mm dia hole can be downloaded. Find the…

A: Q-1   Given, Boundary conditions: Heat flux, q = 100,000,000W/m^2 (one face) T1 = 300K (opposite…

Q: A thermocouple has a linear voltage response over a wide temperature range. If the thermocouple…

A:

Q: Give brief properties of High resistivity conducting material. (1) Carbon (2) Tungsten (3)…

A: As name it self indicates, the conducting material which have high resistivity are known as high…

Q: Find the Unknown resistance 138 ΚΩ Ω O b. +0 a. 9KOHM None of the Above Ο c. 11KOHM Μ O d. 27KOHM R…

A:

Q: A 220 V, 7 A, 1100 rpm DC shunt motor has armature and field resistance of 1.75 02 and 250 n…

A:

Q: A three phase 250 hp induction motor operates at 0.8 lagging power factor on 440 V, 50 Hz supply.…

A: We have been given induction motor with, HP = 250 Hp Power factor (Cosϕ1) = 0.8 lagging Supply…

Q: 3. The three bus-bar conductors in consists of a stack of 3-pin ins insulator is 8-45 kV and that ac

A:

Q: A process is producing a particular product. The recorded product output length are as follows. - А…

A:

Q: The total power in an Amplitude Modulated signal if the carrier of an AM transmitter is 800 W and it…

A: This question belongs to electronics and communication system . It is based on the concept of…

Q: For the diode network of Fig. 2.30, sketch v₁, va and id if the input is sinusoidal of 50 Hz. Ideal…

A: We have an diode network as shown in figure. diode is ideal. We have been asked to sketch, vi vd id…

Q: 2.28 Find V, in the network in Fig. P2.28. 12 V + ww 402 Figure P2.28 L + 4 V, 202 1+ 2 VA Vo 10

A: Given data, Circuit diagram is given as,