Using the rate equation k = 96 lit/hr kg cat, determine the amount of catalyst needed in a packed bed reactor (assume plug flow) for 35% conversion of A→ 4 R for feed of 2000 mol/hr of pure A at 3.2 atm and 117°C.

Q: 2) The absolute pressure within a 45.0-liter gas cylinder should not exceed 58.0 atm. Suppose the…

A: Write the SRK equation as follows: P = RTV-b-aVV+b        .......1 Where, a = 0.42748RTc2Pc1+m1-Tr2m…

Q: Chemical reactions are independent if we can get one in terms of the other by adding, subtracting…

A: we need to verify if the above statement is True or False: Chemical reactions are independent if we…

Q: Depending on the temperature and pressure, ice can have different types of crystal structure…

A: Given that- Ice has hexagonal structure on earth, cubic struture for temperature between 700C to…

Q: eprint to print an object la cells and biomaterials, crea

A:

Q: Natural gas composed of 60. mol% methane, 30. mol% ethane, and 10. mol% propane at 25 C and 500.…

A: Given that, for natural gas- Methane, CH4= 60 mol% Ethane, C2H6= 30 mol% Propane, C3H8= 10 mol%…

Q: A heat exchanger uses medium pressure steam at 10 bar and 350 C to heat cyclohexane vapor from 100 C…

A: Given, the mass flow rate of steam, m3 = 32 kg/h The pressure of steam, P3 = 10 bar The temperature…

Q: Using AfGO given below at 25°C for the reactants and products to calculate the standard Gibbs energy…

A: Write the reaction as follows: SO2g + 12O2g ↔ SO3g   One mole of SO2 reacts with half mole of O2 and…

Q: ( Acetylene is produced from methane in the reaction: 2CH4 (g) → C₂H₂ (g) + 3 H₂ (g) An undesired…

A: Write the reaction as follows: 2CH4g → C2H2g +3H2g Two moles of CH4 is decomposed into 1 mole of…

Q: 2.1. Determine the amount of energy released (in calories) when steam at 110°C (constant pressure)…

A: Given: Steam is condensed from 110oC to 50oC to produce 500 L of water. At 50oC, the density of…

Q: An evaporator is used to concentrated 4536 kg/h (10 000 lb/h) of a 20% solution of NaOH in water…

A:

Q: In a plug flow reactor, a gaseous feed of pure A (2 mol/L, 100 mol/min) decomposes to give a variety…

A: Write the reaction as follows: A→2.5 products   The concentration of pure A, CA0 = 2 mol/L The molar…

Q: Determine the density of steam at 200 bar and 400 °C. a) Use the ideal gas law b) Use the…

A:

Q: Calculate the theoretical flame temperature of a gas having 20% CO and 80% N2 when burnt with 150%…

A:

Q: 2SO2 + O2 ⇌ 2SO2 equilibrium reaction with 21% SO2, 10% O2 oxygen and the remainder SO3 It is fed…

A: T = 301 0C P = 200 kPa

Q: 59: A metal wire of 0.01m diameter and thermal conductivity 200 W/(m.K) is exposed to a fluid stream…

A:

Q: If 240 mol/s CO is produced according to the following reaction equation: 2C4H10(g) + 13O2(g) →…

A: Givent that 2C4H10 (g)   +    13O2    →  8CO2g   +    10  H2O (l) temperature = 25 C

Q: How diffusivity is dependent on temperature and pressure

A: gIVEN THAT we have to write how diffusivity is dependent on temperature and pressure

Q: The thermal efficiency of an Otto cycle is 0.69%. What is the ratio of the minimum volume over the…

A: Given data: Thermal efficiency of Otto cycle = 0.69 Gas = diatomic

Q: 1. A carbohydrate (S) decomposes in the presence of an enzyme (E). The reaction follows…

A: Given data: M-M kinetic parameter area, Km= 200 mol/m3 Vmax= 100 mol/m3.min CS0 = 300 mol/m3

Q: Q.2: The combustion analysis using ORSAT apparatus, where the analysis indicated as 15% CO2, and…

A: Given data: Composition of CO2 in the dry stack gas = 15 %

Q: 49. Air initially at 95 kPaa and 310 K, occupies 0.75 m³. It is compressed isothermally until the…

A: It is asked to solved question 49 only

Q: onsider a solution containing two similar liquids which are miscible in all proportions over a wide…

A: Azeotrope mixture is that in which vapour and fluids have similar concentrations. Given that for a…

Q: A standard galvanic cell is constructed with Cl₂|CI and Cu²+ | Cu* half cell compartments connected…

A:

Q: 68. The mineral manganosite is a compound of manganese-55 and oxygen-16. If 77% of th mass of…

A:

Q: 1. Natural gas composed of 60. mol % methane, 30. mol % ethane, and 10. mol % propane at 25 °C and…

A: Given, The natural gas is composed of 60 mol% methane, 30 mol% ethane and 10 mol% propane.   Write…

Q: What is the different between Open Loop and Close Loop system in process control system? Give an…

A: The difference between open-loop and closed loop system in process control is to be outlined.

Q: A fuel containing 70% ethane and 25% propane is burned with dry air. All the H₂ burns to H₂O and the…

A: Basis feed=100 mol (supposed)  Given that feed has- Ethane (C2H6)=70% = 70 mol Propane (C3H8)=25%=…

Q: 4.22 A heat engine absorbs 260 kJ of heat from a source at 325 K and yields a work output of 72 kJ…

A: Given data for the heat engine are as follows: Heat absorbs from source of 325 K = 260 kJ Work…

Q: 2) The absolute pressure within a 45.0-liter gas cylinder should not exceed 58.0 atm. Suppose the…

A: Given data are as follows: Volume of cylinder = 45.0 L Maximum pressure = 58.0 atm Number of moles =…

Q: A fluid system undergoes a non-flow frictionless process following the pressure-volume relation as p…

A:

Q: A NiO-20 mol% MgO ceramic is heated to 2200 °C. Determine (a) the composition of the solid and…

A: Note = molecular mass of MgO = 40.312 g/mol molecular mass of NiO = 74.71 g/mol Draw a horizontal…

Q: 5.) The phase diagram of sulfur, S8, is presented below. There are two crystalline forms, rhombic…

A: Phase diagram of Sulfur, S8 is given.

Q: Identify 1 types of Enhanced Oil Recovery (EOR) methods and explainhow they works. Name one…

A: Enhanced oil recovery, often known as EOR, is a technique for improving oil recovery that modifies…

Q: Acetic acid is obtained from the reaction of sulfuric acid with calcium acetate: H₂SO4 + Ca(CH₂…

A: Acetic acid is obtained by the reaction of sulfuric acid and calcium acetate.

Q: A binary system can be described by the regular solution model. The enthalpy of mixing is given by…

A: Given, The enthalpy of the mixture, ∆Hmix = X1X2600X1+4000X2 The mole fraction of componenet-1, X1 =…

Q: 4- A piece of material 4 cm thick id subjected to high frequency elictric heating at uniform…

A: Given data:  heat generation rate, q=70 W/m2 hi=10 W/m2.C h0=12 W/m2.C T∞=270C k=0.75 W/m.K b=4…

Q: 8. B. friction factor imbers 7 to 9, e given U-tube manometer, mercury was used in the manometer to…

A: Density of Hg mercury Dhg = 13600 kg/m3 Density of water Dw = 1000 kg/m3

Q: A producer gas has the following percentage volumetric composition: CO2 = 10.8 %, CO = 18.3 %, CH4 =…

A: Volumetric composition of a producer gas is given.

Q: H.W. Find Q? Ti-20 oC hi=10 90 cm 80 cm kl=0.15 k2=0.25 k3=0.45 k4=0.52 50 cm k5=0.6 20 cm 40 cm…

A: The heat transfer through the given wall is to be calculated.

Q: Which of the following results in only vapor products ( D and B)? 1) Partial condenser 3) Partial…

A:

Q: X (s) Gy(s) G₂ (s) G₂(s) G5(s) Gg(s) G₂ (s)

A:

Q: Enlist different production processes for the product Vinyl Acetate, and select the suitable…

A: Dear User ! As per our authoring guidelines, we have solved the first of the three independent…

Q: Blue water gas (BWG) is obtained by passing steam over red hot carbon-enriched coal. The gas is…

A: As given CO2:CO=1:8 BWG at 23 C,748 mmHg and 90% RH supplied 30% excess air is same condition BWG…

Q: Calculate the change in change in Gibbs energy of 15g of ik mass density 0.751 g/cm³) when the…

A:

Q: T2=45 °C 1-25 °C TI=45 °C 12-40 °C

A:

Q: One way in which the useful metal copper is produced is by dissolving the mineral azurite, which…

A: The original concentration of copper sulfate in the sample is to be determined.

Q: 220 CO2 + H₂, lied to control the CO mole fraction in _d P = 1 atm, compute the mole fraction 0500

A:

Q: Calculate the enthalpy change for the reaction and the type of reaction: P406(s) + 2 02(g)----->…

A:

Q: (a) copy the reaction scheme for the synthesis of glycerol and biodiesel from vegetable oil via…

A: Dear User! Both part(a) and part(b) of the question involve the use of your lab notebook and an…

Q: One of the methods to increase oil recovery from reservoir is injection of Carbone Dioxide. Explain…

A: Oil recovery techniques fall into three categories: 1) Primary oil recovery: It is employed during…