V = ? (± 3.2 5 2 5 + Vx = 9V

Q: Determine the average power supplied to the circuit in Fig. 17.26 if i(t) = 2 + 10 cos(t+10°) + 6…

A: Given, Current,  it=2+10cost+10°+6cos3t+35° A

Q: Write the following quantities in scientific notation. (a) 150002 (b) 0.003342 (c) 0.000 025 A (d)…

A: Scientific notation is used to express very large or small number into a decimal form . The first…

Q: 3. Write a Verilog module for the circuit below. j k m, mo 5.40 00 for IC of

A: main module: mux module:

Q: A power supply provides 400 watts to a load and is 80% efficient. In 24 hours how many…

A: Given: Power output, Pout=400 W. Efficiency, η=80%=0.8 . Time, t=24 hours.

Q: 18. Represent the electrical network shown in state space where V₁ (t) is the output. v(t) (+) 2 H…

A: State variables are choosen as current through the inductor. (Note: if any capacitor found then…

Q: .what is the total resistance ? 2. What is the current and volt

A:

Q: A power supply provides 400 watts to a load and is 80% efficient. In 24 hours, how many…

A: Given: Power output, Pout=400 W. Efficiency, η=80%=0.8 . Time, t=24 hours.

Q: For a pulse-amplitude modulated (PAM) transmission of voice signal having maximum frequency equal to…

A:

Q: 2. Calculate the total resistance between the points A and B. A www 4 ohm www 3 ohm 1 ohm 2 ohm

A: Given data, Circuit diagram is given as,

Q: роз KCL @ node A, B, C kuci SA the 1252 V₁ 2512 20520 405 un V₂ 405 ↑) 7.5 A

A:

Q: *P1.37. Given that ia = 2 A, ip = 3 A, id = -5 A, and in = 4 A, determine the values of the other…

A:

Q: A 500 lossless line has load voltage V₁ = 10 e/25° V and load impedance 50 e/³0⁰ 9. Find the value…

A:

Q: (coso) (147) find the Power factor of the following ckf. 452 im mmmmm 355 1-3252 I'ver

A:

Q: 4.) Consider the unit-step response of a unity-feedback control system whose open-loop transfer…

A:

Q: 48 V + 4Ω www 2Ω ww ww 4Ω 6 Ω t=0 IL 1Η ww 5 Ω ww ww m 10 Ω 20 Ω M 1ο 20 Ω

A: Solution: Since the switch has been closed for a long time, so the inductor had reached its steady…

Q: 3. Solve the equivalent resistance across: a. "a" and "b" b. "c" and "d" 20 KAMA 20

A:

Q: Determine the total amount of power in the series circuit in Fig.

A: It is given that:

Q: A9 + دشت شدا W 1 = ? 62

A: Given circuit:

Q: Q9/C ompute the discrete-time Fourier transform of the sequence x(n). Plot DTFT magnitude and angle…

A: Given: A discrete time sequence, x[n]=n(0.9)n[u(n)-u(n-21)] To do: Compute the DTFT of x(n). Plot…

Q: B) 1. The reflection coefficient is equal to (1) when: a) Z₁-0 b) Z,₁=0⁰ c) Z₁-Zo d) Z,=1

A:

Q: A conducting rod of length 0.5 m falls freely from the top of a building of height 7.2 m at a place…

A: Solution !! l = 0.5 m; h = 7.2 m; u = 0 m s-1; g = 10 m s-2; BH = 40378.7 nT The final velocity of…

Q: 19. Consider the analog signal x(t)=3 cos(100mt). The minimum sampling rate to avoid aliasing, in…

A: Given : Analog signal is : 3 cos100 πt

Q: For an n-channel JFET, VGs(om=-8V and Ipss=7 mA. Determine the value of VGs required to set up ID of…

A: Use drain current equation of jet to determine value of VGS.

Q: Problem 10. For the double-beam oscilloscope dis- plays shown in Figure 10.20 determine (a) their…

A:

Q: 5. Approximately how many milliamperes of current flow through a circuit with a 40 V source and 6.8…

A: Given data, Voltage source V = 40 V. Resistance R=6.8 kΩ

Q: 5. Use source transformation to find the value of lo in the circuit. Μ 3 ΚΩ ww 36 ΚΩ 6 ΚΩ 34 ΚΩ 3 ΚΩ…

A: In this question,  We need to determine the current Io  using the source transformation.  We are…

Q: A system is used to transmit base3 PCM signal of 256 level steps, the input signal works in the…

A:

Q: * The voltage Vout in the circuit shown is 10V 1002 5N 10Ω3 Vout

A:

Q: series motor runs at 800 rev/min when the voltage is 400V and the current is 25A. The armature…

A:

Q: Calculate the output voltage if V₁ = 1.09V, and V₂ = 0.59V. Vo= V₁ 250 ΚΩ 500 ΚΩ 100 ΚΩ 50 ΚΩ 500 kn…

A: The given circuit diagram is shown below:

Q: In a d.c. series motor, the torque developed is 20 Nm at 10 A. If the load current is doubled, the…

A: Given a dc series motor with, Torque developed, τ1=20 Nm. At the current, I1=10 A. When the current…

Q: 3. Normalized impedance of 1-j is: a) In the upper half of the impedance smith chart. b) In the…

A: Smith chart:  Smith chart is a quick and easy way to determine the value of input resistance or…

Q: (a) For the continuous time system whose differential equation representation is given as, d³y(t)…

A: The given differential equation is d3ytdt3+5d2ytdt2+9dytdt+16yt=5d2xtdt2+3dxtdt+8xt...(i) We need to…

Q: To get the best reading on a GPS, the device needs to locate: a. Three GPS satellites b. Seven GPS…

A: We need to select correct option  for number of satellite for GPS .

Q: 3. The magnetic flux passing through a coil perpendicular to its plane is a function of time and is…

A: Solution !!

Q: 1) DRAW A SCHEMATIC DIAGRAM FOR AUTOMATIC FORWARD & REVERSE MOTOR CONTROL USING LIMIT SWITCH, RELAY…

A: It is asked to draw a schematic diagram for an automatic forward and reverse motor control. We need…

Q: Find current in in the circuit shown below. Assume R₁ = 2 kn, R₂ = 3 kN, R3 = 6 kN, R₁ = 4 km, and…

A:

Q: Zero Flag explained in a few lines

A: Zero Flag is a bit in flag register. It says whether the output of an operation is zero or not by…

Q: 5 A For the circuit shown in the figure, the Nodal Equation for node 2 is 1Ω V3 Μ 4Ω 2Ω Μ Μ 11] 1A…

A: Circuit is given as:

Q: 2. Determine the current I in each of the circuits given in Figure B. 1.5 V 7A (a) 3 A (b) Figure B.…

A: We need to find out current for given circuit .

Q: Find Vout 10.0 V 2 k 2 k M Vout

A: This is a basic problem of circuit. The solution is given in the next step

Q: A corridor is lighted by 4 lamps spaced 15 m apart and suspended at a height of 5 m above the centre…

A:

Q: Find the equivalent resistance of the network shown in figure between the points a and b O (b)

A: We need to find out the equivalent resistance for given circuit ,. We will use series and parallel…

Q: For a certain 12 V zener diode, a 10 mA change in zener current produces a 0.05 V change in zener…

A: We need to find out zener impedance for given current and voltage .

Q: A 4-pole shunt generator with a lap-wound armature has an armature resistance of 0.1 ohm, and field…

A:

Q: 6.) Please solve only analytically Problem B-5-12 from Ogata (page 265). Ignore the computational…

A:

Q: Problem 8. For the oscilloscope display of a pulse waveform shown in Figure 10.18 the 'time/cm'…

A: Given: An oscilloscope display of a pulse waveform. The 'time/cm' switch is on 50 ms/cm The…

Q: A 250V series motor draws a current of 40A. The armature resistance is 0.15 ohm and the field…

A:

Q: A receiver is tuned to an RF signal of 96 MHz and the LO frequency is 100 104 MHz O 108 MHz 98 MHz…

A: Given data, RF signal frequency, fs=96 MHz. Local oscillator frequency, fl=100 MHz.

Q: Find the equivalent resistance of the network shown in figure between the points a and b +(b)

A: In this question,  We need to determine the equivalent resistance across the terminal a and b.  We…