Write the following quantities in scientific notation. (a) 150002 (b) 0.003342 (c) 0.000 025 A (d) 750V (e) 800 000V (f) 0.000 000 047 F

Q: +V1 30 V R1 10 Q 1₁ ww R2 80 ww R3 30 1+ V2 18 V 12 ww R4 4Q R5 20

A:

Q: consider two buses connected by an impedance of (0 + 5j) Q. The bus '1' voltage is 100 230° V, and…

A:

Q: If a resistor is dissipating 1/4 W, it can supply 1/4 W to the load. True False

A: Given: A resistor is dissipating 1/4 W

Q: Q1] for the following circuit choose the correct answer Assume that the circuit. operates at @= 50…

A:

Q: 5. A unity gain feedback system has an open loop transfer function given by G(s) = k (s+3)(s+5)…

A:

Q: For the op-amp shown in the following figure, the voltage gain is equal to------- Vino 3 ΚΩ 80 ΚΩ…

A: Circuit is given as:

Q: Back-up protection is not a good substitute for better maintenance. Discuss.  Why are differential…

A: Solution question (1): It is asked why back-up protection is not a good substitute for better…

Q: MA Lb T° is the dimensional formula of electric power, find the value of 5a + 2b - 6c. 3. a. 25 c.…

A: To find the dimensional formula of electric power

Q: Simplify the following expression by applying one of the theorems. State the theorem use (d) (UV' +…

A:

Q: A feedback system signal flow graph diagram shown in figure below. . Then, the denominator of total…

A:

Q: 7. The total rotational losses of an induction motor are a combination of A) Friction losses C) Core…

A: Since you have posted the multiple questions so we are supposed to answer 3 questions.

Q: In Boolean Logic, there are only two answers: True and False True False

A: Asking about Boolean logic output

Q: Solve the emitter voltage of a voltage-divider bias circuit with Vcc=9V, R1=560k ohms, R2=560k ohms,…

A: Types of biasing for Transistor  Fixed bias Self bias Voltage divider bias Collector bias Emitter…

Q: Given Figure shows the input characteristic for an n-p-n silicon transistor. When the base emitter…

A: The graph is given as the input characteristic of an n-p-n silicon transistor. The input…

Q: Explain the characteristics of the series and compound DC generator under no-load to loaded…

A:

Q: A 20-pole, star-connected, three-phase alternator rotates at 300 r.p.m. The armature has 360 slots…

A:

Q: The bode plot of a transfer function is given below. has

A: option (a) One pole and one zero

Q: 2 52 Req R14.0 R33.13 www. R14.0 R2 3.0 R45.0

A: We need to find out the equivalent resistance for given circuit , we will do star to delta…

Q: Two shunt generators and a battery are all connected to common bus-bars. The open circuit voltage of…

A:

Q: 1. Find the current I through a resistor of resistance R=202 if the voltage across the resistor is 6…

A: Given: A resistor is connected across a voltage source. Resistance, R=2 Ω. Source voltage, V=6 V.

Q: Construct a gate circuit using AND, OR, and NOT gates that corresponds one to one with the following…

A: Given expression is F = (WX'+Y)[(W+Z)'+(XYZ')] Logic circuit using AND ,OR & NOT gates =?

Q: 1. Given the Circuit below, find branch currents 11, 12 and 13. 1₂. 50 15V i1 602 10Ω 10V 12 www 4Ω

A:

Q: Determine Norton's equivalent current in the circuit shown below. S 2520°V 12.

A: Solution !! The current through the terminals a and b is the Norton’s equivalent current. The…

Q: Which organization has authority over interstate and interna commerce in the communications field?…

A: 1)  ITU -T Stands for  The International Telecommunication Union (ITU) is the United Nations…

Q: B) 1. The reflection coefficient is equal to (1) when: a) Z₁-0 b) Z,₁=0⁰ c) Z₁-Zo d) Z,=1

A:

Q: wo shunt generators and a battery are all connected to common bus-bars. The open circuit voltage of…

A: It is given that: VB=247 VEg1=Eg2=250 VRa1=Ra2=0.12 ΩRf1=Rf2=100 ΩIL=40 A

Q: For a certain 12 V zener diode, a 10 mA change in zener current produces a 0.05 V change in zener…

A: We need to find out the zener diode impedance for given current and voltage .

Q: If the power of an elementary electric dipole is 100 kW, what should be the numerical value of the…

A: Note: We have considered Half wave electric dipole antenna. According to the question, if power of…

Q: Q1] for the following circuit choose the correct answer Assume that the circuit operates at w = 50…

A:

Q: The voltage across a 5-kΩ resistor is 16 V. Find the current through the resistor.

A: We need to find out the current through the resistor , we will it find out by using of ohm's law .

Q: Q1] for the following circuit choose the correct answer Assume that the circuit operates at w= 50…

A: We need to find out the impedance for capacitor .

Q: Find the steady-state -state magnitude gain excitation of the following circuit : If Nin = с 7 10…

A: Laplace transform is used to convert time domain signal in to frequency domain. Transfer function is…

Q: ܕܒܓ ܝܘ c(t) =1=e7r cos @at 1-g -sin out

A:

Q: Explain the key features and working principle of electronic ignition system

A:

Q: for the following circuit fill in (answer in phasor form the blanks ): Vs=5 sin 10t b) v=....... i…

A:

Q: B) An FM signal e(t)FM = 20 сos (2л10't + 6 sin 2л10³t) exist over 500 resistive load, determine: 1.…

A:

Q: a. A 5-kW AC motor has a power factor of 65% lagging when it is connected to a 200-V 50-Hz mains.…

A: Given that: The output of the motor, Pout=5 kW Power factor=65%=0.65 Supply: VS=200 V, 50 Hz…

Q: A one-to-all communication between a source and all hosts on a network classified as a…

A: We need to select correct option for given communication .

Q: 4. In an Amplitude Modulation: a) Amplitude of the carrier varies. b) Frequency of the carrier…

A: Amplitude Modulation Amplitude modulation is a type of modulation used in electronic communication,…

Q: B) For the lossless T.L shown below, the line is driven with a generator that has Eg=30Vrms and…

A:

Q: Consider continuous standard telephone channel, with bandwidth 3100 Hz perturbed by bandlimited…

A:

Q: What is the function of the one-bit half adder? Exactly how many inputs and outputs are there…

A: One-bit half adder:- A form of combinational logic circuit known as the Half Adder adds two 1-bit…

Q: B- For the ECL logic gate in Fig. 4. Assume VBE = 0.7 V. 1). Determine RE and Re₂ such that I = 2 mA…

A:

Q: Draw a circuit that uses only one AND gate and one OR gate to realize the following function: (b)…

A: Given Boolean expression is  F = WXYZ + VXYZ + UXYZ Asked to draw the circuit using only one AND…

Q: Question 47 If a resistor is dissipating 1/4 W, it can supply 1/4 W to the load. True False

A: In this question,  We need to choose the correct option We know , the Active power is dissipate…

Q: (³) d- Р [PA~Y (pv₁] V (PVq₂) V p

A:

Q: 3. A short shunt compound generator delivers 100 amperes at a terminal voltage of 200 V. Armature…

A:

Q: Determine the average power supplied to the circuit in Fig. 17.26 if i(t) = 2 + 10 cos(t+10°) + 6…

A: We need to find out power supplied by source for given circuit , first we will find out the current…

Q: 39 Consider a system with input x[n] and output y[n]. The input-output relation for the system is…

A:

Q: Find the total external armature current of a dc machine which has the following specifications: 120…

A: Torque = 12π×flux×number of armature conductors×armature current×number of polesnumber of parallel…

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.