V A₂=0.02 m² 30° 60° A=0.01 m² This planar water (p = 1000 kg/m³) jet is deflected by a fixed vane. If the velocity V = 6.8 m/s, neglecting the gravity, what is the absolute X- component (horizontal) of force to hold the vane stationary (N)? A. None of them. B. 817.39 C. 1325.54 D. 986.51 E. 524.74

V A₂=0.02 m² 30° 60° A=0.01 m² This planar water (p = 1000 kg/m³) jet is deflected by a fixed vane. If the velocity V = 6.8 m/s, neglecting the gravity, what is the absolute X- component (horizontal) of force to hold the vane stationary (N)? A. None of them. B. 817.39 C. 1325.54 D. 986.51 E. 524.74

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

If the e = 45°, and the bar 0Q is rotating in the counterclockwise direction at 1.6 rad/s, which of the following is the velocity of the slider P?.
Determine the largest value of couple moment M just before the disk begins to slip.
Find the magnitude and direction of the friction force when theta=35deg and P=200N
If the equivalent single force of the system is 300 kN acting up along the y-axis, determine the magnitude and direction of F2 and its direction if F3=255 N and F1=477.44 N and α=60°.
Determine the resultant force (kN) due to water acting on the 4m by 1m triangular area CD. The apex of the triangle is at C. (γwater = 9.81 kN/m3). Solve for magnitude N and the location (m) of the resultant force due to water acting on the 4m by 1m triangular area CD. The apex of the triangle is at C. theta = 27 degrees.
The pole is subjected to the force F which hascomponents Fx = 1.5 kN and Fz = 1.25 kN. If β = 75°,determine the magnitudes of F and Fy.
A swimming pool has a width of 12ft and a side profile as shown. Determine the eccentricity e of the resultant force the pressure of the water exerts on bottom BC. inclined BC makes an angle of 14.478 with the horizontal.
At what angle theta must the 400N force be applied in order that the resultant R of the two forces have a magnitude of 1000N? For this condition,what will be the angle beta between R and the horizontal?
1. Determine the equations of slope and deflection. 2. Determine the slope and deflection at point 3m from point A. E =210 GPa. 100 | Cross section 6KN.m 2m B8KN 2 kN/m 2m T ) B8KN 2m
A horizontal plate turns an oil jet. If ?1 = 30 m/s, ?2 = 25m/s, and the area of incoming jet ?1 = 0.06 m2. Determine the required force in the x-direction to hold the plate.
Data are as follows: P=6.2 kN, L=3.2m, d=1.25m, b=80mm, t=25, h=120mm, h1=90mm. Determine the moment of inertia about the centroidal x-axis in mm^4.
Should the moment at ED be 256.95? and i am not seeing you calculate that moment at E