Value of n for constant temperature 0 0 O > 1 Ок 1 4

Q: Q8. The acceleration of a particle moving along a straight line is a = (C. t-1) m/s, where C is a…

A: Given data:- acceleration of particles (a)=(C.t-1) m/s2 C=3.6, v0=2.1 m/s at t=0 s To find:-Velocity…

Q: Car A is traveling at a location where the speed limit is 100 km/h. The police officer in car P…

A:

Q: Water is the working fluid in a regenerative Rankine cycle with one closed feedwater heater and one…

A: Given: To find:

Q: Do noncrystalline or amorphous materials have grain boundaries? Why or why not?

A: To be explained :- grain boundaries

Q: 06) An air standard Otto cycle has a compression ratio of 7.5. The maximum and minimum cycle…

A:

Q: Required information Problem 07.021 - DEPENDENT MULTI-PART PROBLEM - ASSIGN ALL PARTS NOTE: This is…

A: Heat transfer from the source, Q = -700 kJ  ( Negative because heat is lost from the source)…

Q: Problem 4 If a 5-kg steel plate is attached to one end of a 0.1 m x 0.3 x 1.20 m wooden pole, what…

A:

Q: A projectile is launched from point A with speed vo= 31 m/s. Determine the value of the launch angle…

A:

Q: A Venturi meter is being used to determine the flow of soyabean oil at 65°C in a pipe. The…

A:

Q: 17 When a pressure of 20.7 MN/m² is applied to 100 litres of a liquid its volume decreases by 1…

A: as per guideline i have to solve only first part of your question ,please repost left one.

Q: a) The temperatures between the air layer ?1 and ?2 indicated in the figure. b) The flow of heat…

A: Fourier Law of heat transfer:- Fourier law of heat transfer states that amount of heat transfer is…

Q: What does proportional control do to the second order system? O It changes equivalent stiffness of…

A:

Q: Use Given-Required-Solution in answering problems. Answers should be rounded off to two decimal…

A: GivenV=2ft3T1=75oF=(75°F − 32) × 5/9 + 273.15 = 297.039KP1=90 psia= 90×144=12960…

Q: Calculate the change in entropy for one mole of Cl₂ as it goes from the solid phase 3. at 172.12 K…

A:

Q: An insulated piston-cylinder device contains 4 L of saturated liquid water at a constant pressure of…

A:

Q: 4. A 10 lbm is drop on a 5 kgm piston with a face area of 800 cm² causing the cylinder to decrease…

A:

Q: Indicate how velocity, water temperature, and pipe area affect the Reynolds number.

A: Viscosity: The measure of the resistance to fluid flow (continuous shear deformation) is known as…

Q: Given the T shaped structure show below, find the tension in cables BE and DG if the tension in…

A: Given: Tension in cable CF = 120 N To find: Tension in cable BE, DG

Q: A Н F 12° В с 10°

A:

Q: A golfer is attempting to reach the elevated green by hitting his ball under a low-hanging branch in…

A:

Q: In a tensile test for an aluminum alloy, the sample is 2 inches long and 0.5 inches in diameter. The…

A: Given data:- Length of the sample (l) = 2 in diameter of the sample (d)=0.5 in Applied tensile load…

Q: netres in a glass tate the capilitary effect m when immersed in (i) water and (ii) mercury. The…

A:

Q: The lift force, F, of a V-2 rocket missile is a function of its length, L, velocity, V, average…

A: Givenm data: average diameter D=1.2 mlength L=30 mvelocity v=240 m/sangle of attack α=6°density of…

Q: (1-C.s) m/s² where Cis a consta Q13. The acceleration of a particle traveling along a straight line…

A: Givena=1-Cs      m/s2c=0.1vo=0so=1.7mt=0v=? when s=4.8m

Q: find centroid of the section if b =15 mm and h = 20 mm h C b cf/ bh

A: Given Data- A rectangular shape given we have to find the centroid of it h=20mm , b=15mm

Q: 22 A partially submerged body is towed in water. The resistance R to its motion depends on the…

A: Given DataResistance -RDensity-ρVelocity-Vlength -lAcceleration due to gravity -g

Q: Assume the input power to a pump P (ML T-¹) is depend on Q- Flowrate (L³ T-¹), H-pump head (L),…

A: “Since you have asked multiple question, we will solve the first question for you. If youwant any…

Q: (P7.15) A pipe with closed ends has an outer diameter of 80mm and a wall thickness of 3.0 mm. It is…

A:

Q: can you provide an answer easie to read. the answer is put into sentences like fcv=mgcos 6

A:

Q: Warm-up/Example "0" We will work through this problem together at the completion of lecture. The…

A: Given data: The beam is fixed at A

Q: The method of locating the center of gravity of a mass or an area is based on the method of…

A:

Q: Prorem 4/107 A lifting device for transporting 135-kg steel drums is shown. Calculate the magnitude…

A:

Q: 3. A refrigerator with a power of 450W and a COP of 1.5 is used to cool 5 watermelons of 11kg each…

A: GivenP=450WCOP=1.5n=5m=11kgT2=8oCT1=28oCCp=4.2 kJ/kgoC

Q: A well-insulated rigid tank contains 3.5 kg of a saturated liquid-vapor mixture of water at 200 kPa.…

A: Given at condition 1  mass of saturated liquid vapor mixture = 3.5 kg  Mass of the liquid mf=…

Q: We wish to produce an 0.3 inch plate of oxygen-free, high-conductivity (OFHC) copper that has a…

A: Solution: Given Data:

Q: A perfectly insulated system contains 2 ft³ of hydrogen at 75 F and 90 psia, which receives an input…

A: Given: initial volume , V1 = 2 ft3 initial temperature, T1 = 75 F initial pressure ,P1 = 90 psia…

Q: The rectangular coordinates of a particle which moves with curvilinear motion are given by x=…

A:

Q: 1.5-kg of water that is initially at 90 ◦C with a quality of 5 percent occupies a spring-loaded…

A:

Q: As depicted, a column is contained by a rigid material on its x-axis and has initial dimensions of…

A:

Q: Exercise 7.1 Compression and expansion of an ideal gas 50 mol/s of an ideal gas at 300 K and 1 bar…

A: Given: n˙=50 mol/sT1=300 KP1=1 barP2=10 barηadiabatic=80%P3=1 barT4=300 KTref=298 KPref=1 bar To…

Q: The shaft is made of A-36 steel. It has a diameter of 1 inches and is supported by hearing at A and…

A:

Q: 11 Calculate the work done in blowing a soap bubble of diameter 100 mm. Assume the surface tension…

A: surface tension S=0.038 N/m Diameter D=100mm=0.1m have to calculate work done

Q: A spherical radiator has a radius of 3ft and emissivity of 0.5. If radiates 6000 Btu/hr of heat at…

A:

Q: A particle moving in the x-y plane has a velocity v = 8.58i +2.14j m/s at a certain instant. If the…

A: Givenv=8.58i+2.14j  m/sa=0.65j m/s2θ=38o

Q: A single-stage rocket is launched vertically from rest, and its thrust is programmed to give the…

A:

Q: Required information The torques shown are exerted on pulleys A and B. Consider TA = 360 N·m and Tg…

A: Introduction When the shaft or pulley experiences a twisting moment or torque, shear stress forms in…

Q: An 0.29 inch diameter copper bar is to be cold worked 57%. Find the final diameter in inches.

A: Givend=0.29 inchCW=57%

Q: A fireworks show is choreographed to have two shells cross paths at a height of 131 feet and explode…

A: Before wind was blowing Height of intersection y=131 ft Max height H=131+30  H=161 ft we get…

Q: At the instant shown, the speed of B is 1.8 m/s. a. What is the direction of vB? b. c. What is the…

A:

Q: An insulated rigid tank is divided into two equal parts by a partition. Initially, one part contains…

A: Given data: N=14.5 kmolP1=330 kPaT1=50°C Need to determine the total entropy change during this…