Vire on compass ou place a long straight wire on top of your compass, and the wire is a height of 3 millimeters above the compass needle. If the conventional current in the wire is I = 0.9 ampere and runs left to right as shown, calculate the approximate angle the needle deflects away om North and draw the position of the compass needle. (Do this drawing on paper. Your instructor may ask you to turn in this work.) - 17.2 North Additional Materials eBook

Vire on compass ou place a long straight wire on top of your compass, and the wire is a height of 3 millimeters above the compass needle. If the conventional current in the wire is I = 0.9 ampere and runs left to right as shown, calculate the approximate angle the needle deflects away om North and draw the position of the compass needle. (Do this drawing on paper. Your instructor may ask you to turn in this work.) - 17.2 North Additional Materials eBook

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter22: Magnetism

Section: Chapter Questions

Problem 38PE: (a) A 0.750-m-long section of cable carrying current to a car starter motor makes an angle at 60°...

See similar textbooks

Similar questions

Check your Understanding Themagneticfield shown below Is confined to the cylindrical region shown and is changing withtime. Identity those paths for which =EdI0 .
A bar magnet falls under the influence of gravity along the axis of a long copper tube. If air resistance is negligible, will there be a force to oppose the descent of the magnet? If so, will the magnet reach a terminal velocity?
The rod shown below moves to the right on essentially zero-resistance rails at a speed v=3.0m/s . If B = 0.75 T eveywhere in the region, what is the current through the 5.0 resistor? Does the current circulate clockwise or counterclockwise?
The accompanying figure shows a metal disk of inner radius r1 and other radius r2 rotating at an angular velocity while in a uniform magnetic field directed parallel to the rotational axis. The brush leads of voltmeter are connected to the dark's inner and outer surfaces as shown. What is the reading of the voltmeter ?
The magnetic flux through the loop shown in the accompanying figure varies with time according to m=2.00e3tsin(120t) , where m is in milliwebers. What are the direction and magnitude of the current through the 5.00 resistor at (a) t= 0; (b) t=2.17102 s and (c)t=3.00 s?
A current of 1.5 A flows through the windings of a large, thin toroid with 200 turns per meter. If the toroid is filled with iron for which =3.0103 , what is the magnetic field within it?
Measurements affect the system being measured, such as the current loop in Figure 22.56. (a) Estimate file field the loop creates by calculating the field at the center of a circular loop 20.0 cm in diameter carrying 5.00 A. (b) What is the smallest field strength this loop can be used to measure, if its field must alter the measured field by less than 0.0100%?
The current through a circular wire loop of radius 10 cm is 5.0 A. (a) Calculate themagnetic dipole moment of the loop. (b) What is the torque on the loop if it is in a uniform 0.20-T magnetic field such that p and B are directed at 300 to each other? (C) For this position, what is the potential energy of the dipole?
The accompanying figure shows a conducting ring at various positions as It moves througli a magnetic field. What is the sense of the induced em! for each of those positions?
Is the magnetic field of a current loop uniform?
Check Your Understanding Consider using Ampere’s law to calculate the magnetic fields of a finite straight wire and of a circular loop of wire. Why is it not useful for these calculation?
Is Ampere’s law valid for all closed paths? Why isn’t it normally useful for calculating a magnetic field?