Voltage follower

Q: Draw the outputs of the circuits to scale according to the input signal.

A: We have to draw the output waveforms for following input signal and circuits:

Q: LED LED LED

A: AND Gate: For AND gate , if all the inputs are true then output is true otherwise output is false.…

Q: operational amplifiers

A: The solution can be achieved as follows.

Q: a) The maximum input low voltage for 74LS00. 4 b) The typical output high voltage for 74LS00. c) The…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: There are 4 select lines present in a multiplexer. How many input lines aren present  in the…

A: In this case, there are 4 select lines present in the multiplexer.

Q: Which of the following represent passive transducer? a) Strain gauge b) Thermistor c)…

A: Right Answer option A. Strain gauge

Q: For the given circuit, what is the minimum peak value of the output waveform if the input waveform…

A: Negative Clamper Circuit: A Negative Clamper circuit is one that moves the output signal to the…

Q: In Analog to Digital Converter (ADC) the input will be in digital form. O a. TRUE O b. FALSE

A: Analog to digital converter (ADC) are the converters that convert analog signal to digital signal.

Q: The differential gain is .........

A: The solution is provided in the following section.

Q: 3x8 multiplexer Ca,b,c are mux inputs): a フ+

A: The function at each output terminal of a decoder is a min term and the function is given is max…

Q: generation current density at a reverse bias

A: Semiconductor-  Materials which don't have free electrons in valence so there is no flow of current…

Q: The controlling parameter in MOSFET is a) Vds b) lg c) Vgs d) Is

A: Metal Oxide Semiconductor Field Effect Transistors (MOSFETs) are very widely used in modern…

Q: Determine the regulated output voltage of the circuit

A: It is given that:

Q: In .................. mode of operation, fully controlled converter will keep a delay angle range…

A: average value of output voltage can be controlled by controlling the delay angle of thyristor.

Q: 10. The function of stage-2 signal conditioning is to (a) convert a resistance measurement to the…

A: Generally in the 2nd  stage of signal conditioning the amplification should be done, it means it…

Q: List the differences between D-MOSFETs and E-MOSFETs.

A:

Q: sampled at rate 64 samples

A:

Q: Given: a) analyze and draw the output waveform of Vo. Vi = 15 V E = 8 V b) identify what type of…

A:

Q: It is connected to the input of a transistor (BJT) amplifier circuit with a gain of "-50" with a…

A: Given Vin = 100 mV P-P Gain Av = -50  Voltage gain is negative so it should be common emitter…

Q: 1 ΜΩ 9-16 V '2 ΚΩ AlDe LẠI VGS (Th) = -3 V ID (on) = 4 mA VGS (on) = -7 V Vaso Figure 2: E-MOSFET…

A:

Q: in a triode, what should be done to increase the plate current? Note only vary the Vgg

A: Given, Triode and it's plate current. Note :- only vary the Vgg i.e.., Grid voltage. Please find the…

Q: A second modulating tone having the same amplitude but a different frequency is added to the first…

A:

Q: Draw a low level AM circuits (transistor based)

A: Types of Amplitude Modulation   Single sideband modulation Double sideband suppressed carrier…

Q: Draw the v0 output signal according to the given input signal (R=160Ω)

A: The solution can be achieved as follows.

Q: A Voltage to Frequency Convertor (VCF) consists of a voltage controller oscillator (VCO), a gate…

A: In the question following data is given Output Frequency/input measured voltage = 100 and 200 pulses…

Q: sampled signal

A: Low Pass Filter-It is the  filter which passes only the frequencies lower than the specified…

Q: Greater than the base current

A:

Q: A flow rate transducer

A:

Q: In a potentiometer output voltage is directly proportional to the input temperature. Select one:…

A: In a potentiometer output voltage is directly proportional to the input temperature

Q: Vị 1+20V si vi 1.0k Vo -5 V -20V +

A:

Q: 2. Which mode should the GPIO pin be configured for the following circuit: B1: a.) Output b.) Input…

A: In the given circuit switch is opened

Q: The signal ALE is active (high/low).

A: ALE signal stands for the address latch enable

Q: input signal

A: Given- Solution-

Q: For the given circuit, what is the minimum peak value of the output waveform if the input waveform…

A:

Q: Compare RTD and thermistor

A: Thermistors and RTD both are types of the resistors which is use to sense the temperature change.…

Q: Differentiate between JFET and MOSFET transconductance curves. in a table

A: The difference between MOSFET and JFET transconductance curves is as shown below

Q: Given: Vimax = 8V (note: ignore E) a) analyze and draw the output waveform of Vo b) identify the…

A:

Q: Graph: Draw the Supply voltage, output voltage and gate pulse on graph sheet for the firing angle a…

A: Vin=Supply voltage V0=Output voltage Vp1=Pulse of 1st Thyristor The below graphs are output of a…

Q: What is the different between self bias and fixed bias and follwer in jfet

A: Fixed bias is when the biasing circuit is independent of changes in transistor parameters and is…

Q: The harmonic spectrum of the following figure belongs to the input current of which of the rectifier…

A: To solve above problem, one should know what three phase semi converter is and how it is working. To…

Q: Junction Field Effect Transistors has high input resistance in the order of : ohms.

A:

Q: What is the resolution of a analog to digital converter if the full scale voltage range is volt and…

A: Given data, Full scale voltage V=8 V Number of bits n=2

Q: Positive feedback is required for an oscillator to operate properly

A: In this question , we will write feedback used in oscillator...

Q: For the given circuit, what is the minimum peak value of the output waveform if the input waveform…

A: In this question we need to find a minimum peak value of output voltage

Q: ampl of second harmonic ampl of fundamental HD2

A: Amplitude means the maximum displacement from the position of equilibrium.

Q: gain from an AMP

A: Inverting Operational  Amplifier  In an Inverting amplifier, feedback is connected with an…

Q: In saturation, Vce is maximum minimum 1 V equal to Vcc

A: This value is usually around 0.05-0.2V.