VRY = 220 cis 0°, VYB = 220 cis -120° and VBR = 220 cis -240°. IR = 10 cis 0°. The load is balanced and delta connected. Determine the: (a) Impedance per phase (b) Current per phase (c) Line currents.

Q: (b) Prove the following Boolean expression. (i) (A+B+C)(A+B+C) = AB+C (ii) (A+C)(Ã+B) = AB + AC

A:

Q: Determine the stability of system: S³+ S² + S +4 (a) Absolutely stable (b) Critically stable (c)…

A: Given the system characteristics equation, s3+s2+s+4=0

Q: Use thenodalanalysisto find the branch currentsi1,i2, andi3in the given circuit.

A: Given: Required: i1,i2 and i3

Q: A pulse code modulated system has 8 bits per sample. What is the number of levels present in the…

A: Given: The number of bits transmitted per sample for the pulse code modulated system is 8. The…

Q: A 6 pole, 250V series motor is wave connected. There are 240 slots and cach slot has 4 condoctors.…

A:

Q: 2. The load per phase of a balanced 30 wye connected load is 8 + j6 Ohms per phase. This is…

A: In the given system, the load and source are balanced,so we can do the calculations of on per phase…

Q: Simplify the following Boolean expressions to a minimum number of literals: ( yz ′ + x ′ w ) ( xy ′…

A: It is given that: A=(yz'+x′w)(xy′+zw′)

Q: In the circuit shown above, the initial voltage across capacitor is 2 V and I is a unit step current…

A: The required parameters can be obtained by considering the state of the circuit at t=0 and after…

Q: Vm Find r.m.s 10 III 0 211

A:

Q: In a 8 bit microprocessor, estimate the number of distinct opcodes present.

A: The detailed solution along with the explanation is provided in the following section.

Q: Construct K-map for following Boolean expression. f(A, B, C) = (A + C) (A + B) (A + B + C)

A:

Q: A capacitor in an LC oscillator has a maximum potential difference of 15V and a maximum energy of…

A:

Q: 19.a. There are six general conditions under which equipment that contains exposed…

A: Given: (a)The first condition establishes a zone measuring 5′ horizontally and 8′ vertically from…

Q: In the DC circuit below, all resistors are 20 N. ɛ1 = 100V, ɛ2 = 50V %3D %3D R R R R R (a) for this…

A: Given:

Q: A 230 V single-phase induction motor has the following parameters: R1 =R2= 11 ohms, X1 = X2 = 14…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: Simplify the following Boolean expressions to a minimum number of literals: xyz + x ′ y + xyz ′

A: The given Boolean expression can be reduced by using the Boolean law and postulates.

Q: 5. The output of the op amp is o 0.1 V o -0.1 V o 10 V 0-10 V 2.1 V 2.0 V 10 V -10 V Output

A: open loop opamp is the opamp in which output has no effect on the input .  in open loop , it has…

Q: Determine the line currents for the three-phase circuit of Fig. Let V₁ = 110/0°, V = 110Z 120, V =…

A: Given, Va=110∠0° VVb=110∠-120° VVc=110∠120° V

Q: 400 V Use the mesh analysis or nodal analysis to find io in the circuit + | 32 Ω 64 Ω 180 Ω 16 Ω 48…

A:

Q: explain outdoor substation

A: Outdoor substations: Outdoor substations are substations that handle all voltage ranges from 55 KV…

Q: What is the value of free space permittivity?

A: In this case, the value of the free space permittivity is to be determined.

Q: explain why Two coils are said to be mutually coupled if the magnetic flux Ø emanating from one pass…

A: The magnetic fields in one of the coils tend to join with the other when two coils are placed close…

Q: A cubic spline S for a function f is defined by: (x³ = x + 1 - -2≤x≤0 S(x) lax³ + bx² + cx+d 0≤x≤2 =…

A: We need to select correct option for given function

Q: 7. Assume Q = 0 initially and determine the waveform of Q for the NAND SR latch with the following…

A:

Q: the XOR (or V) gate may be

A: AND gate- It's output is high only when both the inputs are high, if not then output is low.   OR…

Q: The circuit shownbelowis a dc model of aresidential power distribution circuit.Use the mesh-current…

A: Given circuit,

Q: Consider the RC circuit shown in figure. Find the following: (a) The governing differential equation…

A: Given data : The given circuit is shown below,

Q: write the necessasity of estimation and costing

A: Necessity of estimation and costing: Administration Approval/Decision to Proceed in Principle: To…

Q: draw and explain service connection wiring diagram for 1 phase and 3 phase installation

A: Rules For Wiring : The current Rating of wire should be 1.5 times the load current Required For…

Q: A Fast Fourier Transform (FFT) is a technique that can be used to estimate the frequency spectrum of…

A: According to the question, for the given input sequence xn=1, 9, 0, 0, 1, 3; We need to determine…

Q: (b) Vi A circuit which operates at = 50 rad/s is shown in Figure Q2(b). (i) (ii) If an input…

A:

Q: 2) Write down the specification and types of insulators used in transmission line

A: The electrical insulator is a device that provides the required insulation between the line…

Q: find the phase-voltage Vol and torque angle (8) at full-load.

A: Alternator is a device which converts mechanical energy into electrical energy. It is also known as…

Q: Consider the RC circuit shown in figure. Find the following: (a) The governing differential equation…

A: Given circuit,

Q: Determine fundamental period of given signal x(t) = 2 cos 1.5 nt + sin 3.5 t

A:

Q: write down the slection of wiring accessories used in electrical installation

A:

Q: Q2 The circuit in Figure Q2 is an active filter. (a) (b) (c) (d) Derive the expression for the…

A: As per the guidelines of bartleby i need to answer first three subparts only so kindly repost other…

Q: Q3:- For the network in Fig. 1: a) Calculate Rr and Ir. b) Determine l, la and Is. e) Find V.Vaan…

A:

Q: (b) Vi A circuit which operates at o = 50 rad/s is shown in Figure Q2(b). (i) (ii) If an input…

A:

Q: Oa. 0.09 O b. 0.2 O c. 1.1 O d. 0.01 Oe. 10 RB Q4 + RC ģ Stage 1 a Cm c RC V02 Q2 M R₁ R4 R3 -R3…

A: R1=0.1K  R2=1K

Q: Q3/ in a n-type gallium arsenide semiconductor at T-300 K the electron concentration varies linearly…

A: Given a n-type gallium arsenide semiconductor at, Temperature, T = 300 K Charge on electron,…

Q: 8.a. A grounded conductor is a conductor that has been _______ grounded. A. electronically B.…

A: 8.a. A grounded conductor is a conductor that has been intentionally grounded. It is used to carry…

Q: Estimate the total land requirements for wind farms generating an amount of electric  energy equal…

A:

Q: Classification of substation in detail

A: Substation is a very important unit of a power system. It is a channel through which electricity…

Q: Implement a full adder with two 4 × 1 multiplexers.

A: Implementation of Full adder with two 4:1 Multiplexers is explained below: Multiplexer : Multiplexer…

Q: 3. In an ideal op-amp, which is not true?

A: The correct option along with the explanation is provided in the following section.

Q: 5) For the circuit Figure Q1(b), assume the circuit is in a steady state at t = 0 bef the switch is…

A:

Q: 1. Which of these is incorrect for an operational amplifier?

A: The correct option along with the explanation is provided in the following section.

Q: condary voltage and the output and power factor of each transformer. Test data Open circuit:…

A: SOLUTION- Load : 750 A, 0.8 pf lag IL=750∠-36.86°A A.  V=200 V      I = 200400=0.5 PA=15KW =…

Q: An RCL circuit connected in series has R = 180 ohms, C = 1/280 farad, L = 20 henries, and an applied…

A:

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.