Answered: Water drops from a faucet at the rate…

Name: Water drops from a faucet at the rate of 6 drops per second. The fauc
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: Water drops from a faucet at the rate of 6 drops per second. The faucet is 200mmabove the sink. When one drop strikes the sink how far is the next drop above thesink?(5)

Engineering

Mechanical Engineering

Water drops from a faucet at the rate of 6 drops per second. The faucet is 200mm above the sink. When one drop strikes the sink how far is the next drop above the sink?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A siphon is used to drain water from a tank as illustrated below. Assume steady flow without friction. (a) If h = 0.89 m, find the speed of outflow at the end of the siphon, m/s (b) What is the limitation on the height of the top of the siphon above the end of the siphon?
A 15-ft-diameter tank discharges water at 50 F through a 2-in.-diameter sharp edged orifice. If the initial water depth in the tank is 10 ft and the tank is continuously pressurized to 50 psi, how long will it take to empty the tank?
6.36 This two-dimensional water (at 50°F) jet is deflected by the two-dimensional vane, which is moving to the right with a speed of 60 ft/s. The initial jet is 0.30 ft thick (vertical dimension), and its speed is 100 ft/s. What power per foot of the jet (normal to the page) is transmitted to the vane? See §6.5 for useful knowledge about moving CVs.
An orifice having an area of 0.0003 m² is located on the vertical side of a tank. The tank has a constant cross sectional area of 0.40 m². It takes 312 seconds to lower the head from 1.20 m to 0.60 m. Using c=0.60, which of the following most nearly gives the head in meter after 240 seconds from an initial head of 1.20m?
RATE WILL BE GIVEN A jet of water 50 mm in diameter and a plate strikes each at a right angle. When the plate is moving towards the jet at a certain speed, the plate experiences a force that is 2688 N. When that plate is moving away from the jet at the same speed, the plate experiences a force that is 332 N. 1. What is the velocity of the water (m/s) 2. What is the velocity of the plate (m/s) 3. What is the force if the plate stopped moving (N)
2.48 The plunger in the sketch moves at a constant speed of 2 fps. Estimate the force F necessary if there is leakage past the plunger. Assume no losses so that Bernoulli's equation may be used between the stagnant reservoir and the two exit areas. Solution: 44.7 lbs
A pipe, 12 inch in diameter at A, discharges 4.0 cfs of heavy fuel oil (sp gr = 0.899) into the air at B, where the diameter is 6 inch. If B is 12 ft above A and the frictional loss between the two points is equivalent to 3.0 lb per sq in, determine the pressure at A in pounds per square inch.
A channel carries water which is forced to pass under a structure, such asShow in Fig. 2. Neglecting energy losses, calculate the pressure in thepoint 1, knowing that the speed at point 2 is 2 m/s. Data Z1 = 0.8m; L1= 1.5 m and L2 = 1.0 m.
Answer is: V = 14.17 ft/s
A conveyor belt discharges gravel into a barge as shown at a rate of 50 yd3 ⁄ min. If the gravel weighs 120 lbf ⁄ ft3, what is the tension in the hawser that secures the barge to the dock?
The diameter of the pipe at point B is larger than at point A. - At which point is the water speed greater? Point B Point A It is the same at both points. Cannot be determined from the information given.
An open vessel of water accelerates up to a 30ᵒ plane at 2 m/s². a). What is the angle the water surface makes with the horizontal? B). If the angle mage by the water surface to the horizontal is increased to 25.21ᵒ, what will be the depth of water at the rear side of the vessel, if the initial depth of water at the rear side is 4m and the front is 2m before accelerating? The vessel has a length of 4m and 2m width. C). If the vessel’s depth at the rear side is 5m, what will be the volume spilled if the acceleration is increased to 15m/s²?