Water falls from a height of 500 m and the mass of water is50 kg. What is approximately the rise in temperature ofwater at the bottom if the whole energy is used to heat thewater? Specific heat of water is 4.18 kJ/kg-deg C.O 5000 deg CO 1173 deg CO 500 deg CO 0.23 deg CO none of the above

Answered: Image /qna-images/answer/27a40c19-3591-4295-a72b-6e35e537a557.jpg

Answered: Water falls from a height of 500 m and…

Sustainable Energy

2nd Edition

ISBN:9781337551663

Author:DUNLAP, Richard A.

Publisher:DUNLAP, Richard A.

Chapter1: Energy Basics

Section: Chapter Questions

Problem 10P: The temperature of 1 m3 of water is decreased by 10C. If this thermal energy is used to lift the...

See similar textbooks

Similar questions

The temperature of 1 m3 of water is decreased by 10C. If this thermal energy is used to lift the water vertically against gravity, what is the change in height of the center of mass?
The heat exchanger radiates thermal energy at the rate of 2500 kJ/h for each square meter of its surface area. Determine how many joules (J) are radiated within a 5-hour period.
Civil engineering: Energy Please solve the problem clearly , don't use previously solved solutions. I am asking this for a second time. Hope you understand Question: The atmosphere is stable with a lapse rate of -0.2 degree C/100 m. The surfaces air temperature is 15 degree C. A parcel of air is released at the ground with a temperature of 25 degree C. Calculate the maximum mixing height, in m.
1. Water at 68 has a dynamic viscosity of 1 centipoise. Compute its dynamic viscosity and kinematic viscosity in foot pound-second units. 2. A volume of 15.5 cu.ft of a liquid weighs 782 lb. Compute the mass density of the liquid. 3. Compute the number of watts which are equivalent to 1 horsepower. (1 watt = 10^7 cm-dynes per sec; 1 hp = 550 ft-lb per sec.) 4. A city of 6000 population has an average water use of 110 gallons per person per day. Compute the average total rate of use in cubic feet per second and in gallons per minute. ( 1 cu. Ft = 7.48 gal.) 5. Compute the unit weight and kinematic viscosity, in foot-pound-second units, of dry air at 15 and an absolute pressure of 14.7 lb per sq.in.
A coal-fired power plant discharges 1 m^3/s of cooling water into a river, which has a flow of 9 m^3/s and a temperature of 20 degree C. According to the regulation, the temperature in the river immediately below the discharge cannot be increased by higher than 1 degree C. Therefore, what is the highest temperature of the cooling water is allowed for discharge?
calculate the density and specific weight of carbon dioxide at an absolute pressure of 300 kN/m^2 and 60 degree celsius
Determine the energy consumption (BTU/min), If two 50-kg LPG tanks are needed per 24-hour operation, heating value for the LPG of 11,000 kcal/kg. Subject: Civil Engineering: Thermodynamics
1. If the work done 10000 cal, and the initial pressure 100 atm, when the ideal gas | expand isothermally and reversibly from the initial l volume (V1) to the final volume (10 V1), R = 1.987 cal/mole.K. ~ (A) calculate V1. (B) If there are - 2 moles from ideal gas what is the temperature.

Recommended textbooks for you

Sustainable Energy

Civil Engineering

ISBN:

9781337551663

Author:

DUNLAP, Richard A.

Publisher:

Cengage,

Engineering Fundamentals: An Introduction to Engi…

Civil Engineering

ISBN:

9781305084766

Author:

Saeed Moaveni

Publisher:

Cengage Learning

Sustainable Energy

Civil Engineering

ISBN:

9781337551663

Author:

DUNLAP, Richard A.

Publisher:

Cengage,

Engineering Fundamentals: An Introduction to Engi…

Civil Engineering

ISBN:

9781305084766

Author:

Saeed Moaveni

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

Water falls from a height of 500 m and the mass of water is 50 kg. What is approximately the rise in temperature of water at the bottom if the whole energy is used to heat the water? Specific heat of water is 4.18 kJ/kg-deg C. O 5000 deg C O 1173 deg C O 500 deg C O 0.23 deg C O none of the above