Water is being pumped into an inverted conical tank at some constant rate. The tank has a height of 600 cm and the diameter of the tank across the top is 400 cm. If the water level is rising at a rate of 20 cm/min when the height of the water is 200 cm, find the rate at which water is being pumped into the tank. (Round your answer to the nearest integer.)

Water is being pumped into an inverted conical tank at some constant rate. The tank has a height of 600 cm and the diameter of the tank across the top is 400 cm. If the water level is rising at a rate of 20 cm/min when the height of the water is 200 cm, find the rate at which water is being pumped into the tank. (Round your answer to the nearest integer.)

Mathematics For Machine Technology

8th Edition

ISBN:9781337798310

Author:Peterson, John.

Publisher:Peterson, John.

Chapter59: Areas Of Rectangles, Parallelograms, And Trapezoids

Section: Chapter Questions

Problem 79A

See similar textbooks

Similar questions

The diameter of a carousel merry-go-round is 30ft. At full speed, it makes a complete revolution in 6 s. At what rate, in feet per second, is a horse on the outer edge moving?
Compute the following problems. Express the answers to 1 decimal place. Use: T=LFN A slot 812.00 millimeters long is cut into a carbon steel baseplate with a feed of0.80 millimeter per revolution. Find the cutting time using a 75-millimeter diameter carbide milling cutter running at 640 r/min.
Compute the following problems. Express the answers to 1 decimal place. Use: T=LFN Seven brass plates 9.00 inches wide and 21.00 inches long are machined with amilling cutter along the length of the plates. The entire top face of each plate ismilled. The width of each cut allowing for overlap is 212 inches. Using a feed of0.020 inch per revolution and 525 rpm, determine the total cutting time.
Compute the following problems. Express the answers to the nearer whole number. Use C=3.1416DN12 or DN12 for customary units and C=3.1416DN1000 or DN1000 for metric units. What is the surface speed of a 16-inch diameter surface grinder wheel running at1194 rpm?
Compute the following problems. Express the answers to the nearest whole number. Use N=12C3.1416D or 12CD for customary units and N=1000C3.1416D or 1000CD for metric units. An annealed cast iron housing is drilled with a cutting speed of 20 meters per minute using a 22-millimeter diameter carbon steel drill. Find the revolutions per minute.