Water with a density of 999.1 kg/m3 and absolute viscosity of 1.138 X 10-3 kg/m·s is flowing steadily in a 30-m-long and 4-cm-diameter horizontal pipe made of stainless steel at a rate of 8 L/s. the pumping power (KW) requirement to overcome this pressure drop within the span of the pipe. If the flow is laminar, use the figure below to calculate f. If the flow is turbulent,    use 0.01573 as the value for f. use 0.01573 as the value for f.

Q: Water at 60 degrees Fahrenheit have a density of 62.36 lb/ft.^3 and dynamic viscosity of 7.536 x…

A:

Q: Crude oil has a density of 856kg/m3 and dynamic viscosity of 0.0072Pa-s flow through a 60-mm…

A:

Q: Water with a density of= 999.7 kg/m3 and absolute viscosity of 1.307 x 10-3 kg/m·s is flowing…

A:

Q: Water with a density of= 999.7 kg/m3 and absolute viscosity of 1.307 x 10-3 kg/m·s is flowing…

A:

Q: A 10kg box slides on a ramp with a slope of 30°. There is a thin layer of oil with a N.s viscosity…

A:

Q: Determine the rate of flow of water through a pipe of diameter 20 cm and length 50 m when one end of…

A: given data diameter = 20cm length = 50 m f= 0.009 height of water in the tank = 4 m find the flow…

Q: Water flows (from bottom to top) in a vertical duct of 5 cm of internal diameter. A differential…

A: Solution is attached below

Q: Someone claims that the shear stress at the center of a circular pipe during fully developed laminar…

A: This claim is true as the shear stress at the center of a circular pipe during fully developed…

Q: A fan is used to force air having a temperature of 20°C through the 200- mm-diameter galvanized…

A:

Q: Glycerin, with a density of 1260 kg/m3 and an absolute viscosity of 1.5 kg/m.s, flows in a tube with…

A:

Q: Q4) Water at 10°C flows from a large reservoir to a smaller one through a 5-cm-diämeter cast iron…

A:

Q: A liquid flows through a 2.067-in ID standard steel pipe at a velocity of 3 m/s. If the density and…

A: Given data as per question Diameter of steel pipe =2.067 in=0.0525018mvelocity =3 m/sdensity of…

Q: Consider the problem of draining a hemispherical tank of radius H* feet that is full of water and…

A: dVdt=-KA2gh(t)  ........(1)dhdt=dVdt(1πr2)    .....(2)From (1) and (2):dhdt=-KAπr22gh(t)

Q: Q1 / Show that velocity profile for fully developed laminar flow on an inclined plane, shown in…

A: Apply continuity equation and navier stokes equation to solve this problem

Q: 2. The radial clearance between a plunger and the walls of a drum is 0.075 mm, the length of the…

A:

Q: The space between the shaft and sleeve is filled with an oil of viscosity 6.5 stokes and density 900…

A:

Q: Consider the problem of draining a hemispherical tank of radius H* feet that is full of water and…

A:

Q: A thin oil having a density of 800 kg/m³ is pumped from an underground storage tank through a 300 mm…

A: ⇒given data;⇒density(ρ)=800kg/m3⇒diameter of pipe line(d)=300mm=0.3m⇒horizontal distance or…

Q: What is the function of V-cone flow element and manifold pressure measuring devices, where equipment…

A:

Q: 1- Oil with a density of 850 kg/m3 and kinematic viscosity of 0.00062 m2/s is being discharged by a…

A: Given data: ρ=850 kg/m3v=0.00062 m2/sd=8 mmL=40 mh=4 m Need to determine the flow rate of oil…

Q: Consider the problem of draining a hemispherical tank of radius H* feet that is full of water and…

A: Given data: -  The radius of circular drain hole is R = 3 in. The change in volume is dVdt=-kA2ght.…

Q: Determine the type of flow from a 30cm diameter pipe with water flowing at 1.2m/s. the viscosity of…

A: Given Data: Diameter of the pipe, d=30 cm Velocity, v=1.2 m/s

Q: Water with a density of 999.1 kg/m3 and absolute viscosity of 1.138 X 103 kg/m-s is flowing steadily…

A:

Q: Water (with a viscosity µ of 0.00958 N.s/m²) is flowing in a pipe with a diameter of 10 cm at a dish…

A:

Q: 13. Oil of SG = 0.87 and a kinematic viscosity v = 2.2 x 10-4 m2/s flows through the vertical pipe…

A:

Q: An oil with a viscosity of µ = 0.40 N s /m2 and density ρ = 900 kg/m3 flows in a pipe of diameter d=…

A:

Q: Water with a density of= 999.7 kg/m3 and absolute viscosity of 1.307 x 10-3 kg/m·s is flowing…

A:

Q: Oil flows in a 39-cm-diameter pipeline at an average velocity of 0.5 m/s. A 304-m-long section of…

A:

Q: A vented tanker is to be filled with fuel oil with Density= 920 kg/m3 and Viscosity =0.045 kg/m s…

A:

Q: In a pipe conveying steady flow of incompressible fluid, what factor determines the magnitude of…

A: The factor which affects the velocity of fluid flow through a pipe is needed to be identified. The…

Q: What are the applications and principles of Laser-Doppler Anemometer to agricultural and biosystems…

A: The laser Doppler anemometer employments a bar of light from a laser that's partitioned into two…

Q: The velocity profile for the fully developed laminar flow of a Newtonian fluid between two large…

A: Given, The velocity profile of flow is,       uy=3u021-yh2

Q: The velocity profile in fully developed laminar flow in a pipe of diameter D is given by u = U, (1-…

A: Given: velocity profileu=uo 1-4r2D2

Q: Heated air at 1 atm and 35°C is to be transported in a 150-m-long circular plastic duct at a rate of…

A: Given: The flow rate of the circular plastic duct is Q=0.35 m3/s and the head loss in the pipe is…

Q: Water at 60 degrees Fahrenheit have a density of 62.36 lb/ft.^3 and dynamic viscosity of 7.536 x…

A:

Q: The ethanol solution is pumped into a vessel 25 m above the reference point through a 25 mm diameter…

A: Hello. Since your question has multiple sub-parts, we will solve first three sub-parts for you. If…

Q: Heated air at 1 atm and 100F is to be transportedin a 400-ft-long circular plastic duct at a rate of…

A: Given: The length of the circular duct, L = 400 ft The volumetric flow rate through duct, Q = 12…

Q: For a fluid flowing inside a pipe, given a constant Reynolds number, how will the Fanning friction…

A:

Q: Q2 Oil with a density of 850 kg/m³ and kinematic viscosity of 0.00062 m²/s is being discharged by a…

A:

Q: Water at 16oC (Density = 999 kg/m3 ; Viscosity = 1.12 x10 -3 kg/m-s) is flowing steadily in a…

A:

Q: Water at 10 C flows in a 3-cm-diameter pipe at a velocity of 1.5 m/s. The Reynolds number for this…

A:

Q: In the flow of water through a capillary tube, if the diameter of the tube is increased by 3 times…

A: ANSWER : b) increase by a factor of 81

Q: Water is flowing under laminar conditions in a pipe of length L. If the diameter of the pipe is…

A:

Q: SAE 30 Engine Oil at 20 °C has a density of 0.882 g/cm² and kinematic viscosity of 272 mm³/s and is…

A: Given data: d=0.01 mL=5 mh=5 mv=272×10-6 m2s

Q: Water flows through a circular tube with a velocity of 2 m/s. The diameter of the pipe is 14 cm. If…

A: Given:v=2 m/sd=14 cm =0.14 mν=10-6 m2/sρ=103 Kg/m3

Q: Oil with a density of 850 kg/m3 and kinematic viscosity of 0.00062 m2/s is being discharged by a…

A: Given Data v=0.00062 m2/s ρ=850 Kg/m3 Diameter =8mm Dynamic viscosity μ=ρv=850(0.00062)=0.527 Kg/ms

Q: The ethanol solution is pumped into a vessel 25 m above the reference point through a 25 mm diameter…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Properties of Fluids

The term fluid represents a type of substance that can easily change its shape under any external pressure/force and can flow. Fluids can acquire any shape in which it is stored and can resist normal stresses but cannot resist shear stress in rest condition. Whenever external shear stress is applied to fluids, it starts to flow. The fluids may be liquid or gas. Example- water, air, etc.