We measure and record the instantaneous voltage between the two wires of a power transmission line at arbitrary locations. The measurements at two locations: 0.3m apart. Will the two waveforms be different? If it is different, describe the difference. If so, by how much (negligible to significant).

Q: Q/What is the effect of the length of the transmission line on the  Phasor measurement unit (PMU)…

A: - A phasor measurement unit (PMU) is a gadget used to gauge the greatness and stage point of an…

Q: Derive the power angle equation for a power system network and draw the corresponding curve.

A: Power Angle Equation for a Power System Network: Suppose a synchronous machine is connected to an…

Q: 6. (a) Describe the basic Microwave transmission system and give the importance of each component in…

A: Transmission lines- Transmission lines are basically a part of an electrical system, through which…

Q: Can you explain the results for me ,,, and thank you

A: The digital circuits can be combinational as well as sequential circuits. The combinational circuits…

Q: Obtain an assuming no transients present. expression for the power dissipated in the

A:

Q: discuss the behavior of the efficiency output power curve ?

A: The efficiency output power curve indicates the changes in the output power with changes in…

Q: Wiat is the difference between a real independent voltage source and an ideal independent voltage…

A: Resistance opposes the flow of current. The dependent voltage or current source value depend on…

Q: active and reactive power drawn by the mixer fed from a 230 Vrms, 50 Hz single phase AC network was…

A:

Q: Determine the instantaneous voltage utilizing component from voltages given.

A: Any time domain signal can be sinusoidal, DC signal or any curve signal. Sinusoidal signals are…

Q: Report: In the report comment on the following: - The plot of the obtained VSWR for the matched…

A: Voltage standing wave ratio for a matched load is 1 which define that power is perfectly transmitted…

Q: The assum Ption of Plane electromanetic waves has rather limited vallidity Find all the situations…

A: The assumPtion of Plane electromainetic waves has rather limited validity Find all the situations…

Q: Explain the General immittance analysis in detail??

A: According to question we have to Explain the General immittance analysis in detail?

Q: Can we generate PWM from PPM?

A: Yes we can can generate PWM from PPM.

Q: Electrical Engineering How to measure the electric field intensity at 2m away from a Parallel…

A: Given data: Charge of the electron q=1.6×10−19C Mass of the electron m=9.1×10−31 kg Acceleration due…

Q: Draw the circuit diagram of Two quadrant chopper which is having average load current might be…

A: Sometimes a chopper may be required to provide a two quadrant operation by retaining the current…

Q: Draw a figure that represents one cycle of the AC voltage signal present at a typical household wall…

A:

Q: Define the harmonic frequency and interharmonic frequency used in power system quality.

A: In power system, sinusoidal waveform is taken as reference which is economical so both voltage and…

Q: Q5) Define the types of the communication systems forms and plot them and explain each one in…

A: (5) Communication System: a. It is a system that allows information to be exchanged between two…

Q: 6. BJT is more linear than FET. Why? Explain

A: A BJT has constant gain in the active region so the graph obtained in this region is a straight line…

Q: discuss the behavior of the efficiency output power curve?

A: The output power of the shunt motor varies with the efficiency due to certain parameters like…

Q: The Hellmann formula describes? (a) solar irradiance depending on the thickness of the cloud cover.…

A: The velocity of wind varies with the height above the ground.

Q: For the cct shown Find ZT, I,e, phaser diagram =100L I.

A: Given U =100∠0°R =8 ΏXL =6Ώ

Q: Briefly describe how a distance can be measured by the method of phase comparison

A: From the method of phase comparison, the distance is measured indirectly by determining the number…

Q: Find the square root of 9260° using any methods.

A: Given polar number x=9∠60° Although,  r∠θ°n=rn∠nθ In the given problem n=0.5

Q: Q#5. Illustrate the variation of output power taken from the wind turbine? How the frequency in wind…

A: In the case of the Wind turbine generated power will vary with the wind flow. So the power will…

Q: What are Low voltage network types? And explain every type of it ?

A: A low-voltage network is a component of electric power distribution that transports electricity from…

Q: An offshore wave energy device with a frontal width of 5 metres, an overall efficiency of 38% and a…

A:

Q: 5. Daily electric load variations in a power system is results in small signal stability of power…

A: "Since, you have asked multiple questions, according to our guidelines, we can answer only one…

Q: Please write short introduction about AC Circuits - Series Circuits

A: An a.c circuit differs from a d.c circuit in many respects. First, in a d.c circuit we consider…

Q: 6/ (a) Describe the basic Microwave transmission system and give the importance of each component in…

A: (a) Microwave transmission system : A microwave link is a communications system that uses a beam of…

Q: For a Cockcroft-Walton voltage multiplier circuit, if Vmax = 460 kV and n = nopt = 14, %3! (i) What…

A: Because of our policy only first 3 questions will be answered;

Q: Mention Factors determining the size and the direction of the generated emf

A: Factors determining the size and the direction of the generated emf are follows-

Q: Give the application of gases and gas mixtures as insulating medium in (a) High-Voltage Switchgear,…

A: Now a days gases and their mixture are used in high voltage cable and high voltage switchgear…

Q: An aluminum transmission line is to be replaced by copper having the same total resistance. If the…

A: Resistance is given as, R=ρlA The resistance of the aluminum transmission line is given as,…

Q: 1 How large is the phase shift between Uin and Uoutt?

A: BJT and MOSFET are the class of transistors used in analog electronics. They are widely used…

Q: / Plot the blocking voltage of the SCR at ?=0o for three-phase HWR. What is the value of PIV?

A:

Q: How to convert 22 mW of power into the units of dBm

A: In this case, 22 mW of power is to be converted into its equivalent power in dBm.

Q: What are the advantages of using CDMA for a cellular network

A: Code Division multiple access (CDMA) is used by various radio communication technologies to access…

Q: If for example communication power is often normalized by assuming R to be a unity in Ohms, although…

A: Power is usually referred to as the amount of energy transfer from one form to another and…

Q: Q6: What are the main differences between the terms "Mobile" and "Wireless"?

A: We oftenly use Mobiles and wireless words interchangeably however there is a very slight difference…

Q: A coaxial cable with a characteristic impedance of 50 Ohm is used to deliver mi- crowave signal to a…

A:

Q: As an example of the use of such a wattmeter in measuring average power, let us consider the circuit…

A:

Q: Determine the charging current (Ic) at 50 Hz of a single-conductor EHV transmission line having…

A:

Q: The roots of the characteristic equation of pic 3 are given ???? And what is the appropriate…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: Draw the circuit diagram of Two quadrant chopper which is having average load voltage might be…

A: CHOPPER:- A chopper circuit is any of numerous types of electronic switching devices and circuits…

Q: . Describe the basic Microwave transmission system and give the importance of each component in the…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: MOSFET

A: Given- Vt=1 Voltskn'=20μA/V2L=4μmW=100μmλ=0VD=+5Volts RS= 4 kΩ

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.