What are Low voltage network types? And explain every type of it ?

Q: What is the Vmax and Vrms of 169sin 377t?

A:

Q: Explain the specific concepts and processes for the design methods that can effectively and…

A: The Answer is

Q: Any change of the Components currents references will not affect the resulting current values, why?

A: we need to know why any change of the Components currents references will not affect the resulting…

Q: does line current need Vrms or the given peak voltage to be

A: In this question we will write about line current....

Q: example where you will find this in real world? explain

A: Given circuit is a passive low pass filter

Q: es could the Network Laws have over the simple Series and

A: The various network laws such as the KVL and the KCL is used to determine the current and voltage of…

Q: Define the term "local wide network."

A: The given terms are as follows -  1. Local Network 2. Wide Network

Q: & Prove That %3D

A: Resonance Resonance is the condition when the voltage across a circuit becomes in phase with the…

Q: Discuss advantages of per units representation

A: Advantages of per unit representation

Q: State Space Representation.

A:

Q: Report: In the report comment on the following: - The plot of the obtained VSWR for the matched…

A: Voltage standing wave ratio for a matched load is 1 which define that power is perfectly transmitted…

Q: Why do we need to use the Bus Bar protection? Generalize the theory behind it

A: The power system these days has become quite complex and consists of many equipment operating in…

Q: Describe the purpose and with neat diagrams, the working of cycloconverters

A: A cycloconverter converts ac power at one input frequency to output power at a different output…

Q: 2. What do you understand by the load curve? What information's are conveyed by a load curve?

A: Load curve  A graphical plot showing the variation in demand for energy of the consumers on a source…

Q: Can we use the delay spread for GSM or not. Justify your answer

A: For GSM the channel bandwidth is Ws=200 kHz.

Q: Discuss in points the parameters affecting the total number of cells in cellular systems.

A: A cellular system contains a center organization that interfaces with base stations with receiving…

Q: For the circuit shown in the figure below, com

A:

Q: Discuss in detail about the evolution of electrical/ non- electrical Communication methods and…

A: consider the given question;

Q: Give two (2) examples of network management components and their functions?

A: Solve the problem

Q: which the voltage regulation is maximum and the value of this regulation.

A:

Q: Please explain the concepts regarding the equivalent resistance of series, parallel, and…

A:

Q: rminal network to be im ng impedance and voltage nstrate with diagrams

A: The Thevenin's theorem states that a linear and bidirectional two terminal networks can be replaced…

Q: For the circuit shown beside

A:

Q: Applications of MEMS And NEMS?

A: MEMS- MEMS stands for Micro-Electro-Mechanical Systems. They are basically miniaturized mechanical…

Q: Source Transformation method I=? V50ohm=? P50ohm=?

A: By source transformation voltage source with series resistor can be replaced by current source with…

Q: 3. Refer to the graphics addendum (C). What is the phase voltage at the Load?

A:

Q: What is meant by FACTS in power systems? Discuss about SVC type FACTS device

A: Power system A network that consists of generation, distribution, and transmission systems. It uses…

Q: Discuss the method of reducing to an economically and operationally acceptable level the cost and…

A:

Q: What is the nodal analysis/ node - voltage method? Also, please give me some circuit problems…

A: Nodal analysis is a method that provides the node voltage value and it can be used to analyze the…

Q: WiMAX, Wifi and DSL and NGN are telecommunication network implementations. Briefly outline each. Use…

A: WiMAX: WiMax is part of the transition from voice-only to multi-service wireless communications…

Q: Explain what is Grid system

A: The Grid system is a network to deliver electricity from producer to consumer.

Q: please write details about Arduino or ESP8266

A: ESP8266S plant irrigator : We can built a smart plant irrigation system using ESP8266S and EasyIoT…

Q: The choice of wiring system design is basically affected by temperature, safety and cost factors,…

A: Before assembling a structure, one needs to make the right choice when it comes to the type of…

Q: Investigate the operation principle of 3- phase inverter for 120° conduction intervals (by sketching…

A: Rectifier: Because nearly every electrical appliance runs on DC (Direct Current), the rectifier…

Q: What do you understand by the term phase containment of errors? Explain with example.

A: Specifications, architecture, implementation, integration, & deployment are the steps of an…

Q: Q2B:_Find Vs and Is for long transmission line when Vr-12v, Ir=3mA. z=50 O/m, y=2 S/m, for L=250?.

A: A Transmission line is considered long transmission line, when the length of the line is equal to or…

Q: Using Mesh current method s

A: Mesh Analysis It is the easier way to analyze a complex network, it can only be used in a planar…

Q: How can you understand the zones of protection CTs and PTs And their applications in Protection…

A: Current transformers are generally used to measure currents of high magnitude. These transformers…

Q: What are the constraints are following in unit commitment?

A: Constraints in unit committment :- 1- Spinning reserve - It is the total amount of generation…

Q: a) What do you mean by adaptive protection? What functions are expected to be performed by an…

A: Adaptive protection The given protection utilizes settings for adjustable protective relay(ex-…

Q: Investigate the operation principle of 3- phase inverter for 120° conduction intervals (by sketching…

A: Rectifier: Because nearly every electrical appliance runs on DC (Direct Current), the rectifier…

Q: Can we select components voltage references randomly in order to write KVL? Why?

A: we need to answer that Can we select components voltage references randomly in order to write KVL?…

Q: What is the application of stark effect in electronic and communications engineering field?

A:

Q: 7. Describe the direct connection, series and parallel methods of measurements using Q-meters? Why…

A: Q-meter is used to measure quality factor of a coil Q. Also measures Resistance R, inductance L and…

Q: What is a twisted pair cable?What are its two types and draw the sketch?

A: In radio frequency when disturbance in external source affects the electrical circuit by…

Q: Write about the uses and importance of twisted pair cable - crossover cable

A: Twisted pair cable :-  These cables have two questions insulated conductors which are generally made…

Q: The expression of Q factor for Schering bridge is given by

A: The expression of the Q factor for schering bridge

Q: What are the constraints are followed in Unit commitment?

A: According to question we have to explain  What are the constraints are followed in Unit commitment?

Q: Derive expression for figure-of-merit of SSB-SC.

A: We need to derive the expression for figure of merit for SSB . We need to calculate input and output…

Q: Discuss in detail about the evolution of electrical/ non-electrical Communication methods and…

A: Electrical Communication: In which any type of information (speech, alphanumeric, visual, or other…

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.