Answered: Weighted piston type accumulator is…

Name: Weighted piston type accumulator is shown in the figure below. If area
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: Weighted piston type accumulator is shown in the figure below. If area=340 cm², a lift of the ram =1190 mm. Calculate the capacity of the accumulator in terms of liters.

Engineering

Mechanical Engineering

Weighted piston type accumulator is shown in the figure below. If area=340 cm², a lift of the ram =1190 mm. Calculate the capacity of the accumulator in terms of liters.

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter8: Centroids And Distributed Loads

Section: Chapter Questions

Problem 8.113P: Calculate the resultant force caused by the water acting on the parabolic arch dam. The water levels...

See similar textbooks

Similar questions

Evaluate the dimensionless groups hcD/k,UD/, and cp/k for water, n-butyl alcohol, mercury, hydrogen, air, and saturated steam at a temperature of 100C. Let D=1m,U=1m/sec, and hc=1W/m2K.
The hemispherical glass bowl is filled with water. Find the location y of the center of gravity of the filled bowl. Approximate the bowl as a thin shell of radius R=6.15in. Use 1=162lb/ft3 for glass and 2=62.4lb/ft3 for water.
Calculate the resultant force caused by the water acting on the parabolic arch dam. The water levels are 16 ft on the upstream side and zero on the downstream side. For water, use =62.4lb/ft3.
Please answer in essay: From the figure below, discuss the internal effect of the external forces acting on the body.
The man in the figure below is pulling a drum over a circular hill. All surfaces are smooth (no friction forces). If the drum weighs 60N, what is the tension on the rope for the drum position shown?
A hydraulic press has a ram of 30 cm diameter and a plunger of 4.5 cm diameter. Find the weight lifted by the hydraulic press when the force applied at the plunger is 800 N
A rectangular gate 5 m × 3 m is hinged at its base A and inclined at 60 degree to the horizontal as shown in the figure. To keep the gate in a stable position a counter weight (W) of 5000 kg is attached at the upper end of the gate. Find the depth of water at which the gate begins to fall. The weight of the gate is 2000 kg. Neglect the friction at the hinge and pulley
Question 3 3.1 A rectangular pontoon has a mass of 120 x 103 kg and floats in sea water, see figure 3.The pontoon has a length of 18m and width of 7.5m.The vertical sides of the pontoon are 2.5m high.The mass density of sea water is 1 025 kg/m3.Find the metacentric height of the pontoon and specify whether it floats stable in this position.
The diameters of a small piston and a large piston of hydraulic jack are 2 cm and 10 cm respectively. A force of 60 N is applied in the small piston. Find the load lifted in N by the large piston when the piston are on the same level.Take density of the liquid in the jack is 1000 kg/m^3.
at the bottom of a container, which forms an angle A with the horizontal, is a cube of edge a, as shown in the figure, made of a material of density p. Determine the force with which the cube presses on the bottom, if a liquid of density p0 is poured into the container. The top edge of the cube is h from the surface of the liquid. There is no liquid between the bottom of the container and the cube. The atmospheric pressure is P and the acceleration of gravity g (neglect the thrust).
A rectangular gate of width "a", length "b" and inclined at an angle "A", with water on one side is shown in the figure. Use a=9.5 ft, b=5ft, z=6.5ft and angle A=55 degrees. (a) Determine the location of the center of the gate from the water surface along the plane of the gate (in feet). (b) Determine the eccentricity (in feet). (c) Determine the location of the center of pressure from the water surface along the plane of the gate (in feet). (d) Determine the vertical distance (in feet) of the center of the gate from the water surface. (e) Determine the total resultant force (in lb) acting on the side of the gate.
A semicircular plate of radius 5ft rests vertically on its diameter at the bottom of a pool filled with water to a depth of6ft. Assume that the water’s weight density is62.4lb/ft3.•Find the force exerted by the water against on side of the plate.