What are Compression piles ? Explain the purpose & uses of Compression piles ?
Q: Why does The O-cell typically is attached to the tip end of a pipe pile prior to installation…
A: The Osterberg Cell is a hydraulically operated device fitted in the foundation. It is of high…
Q: Why would it be inappropriate to use the Terzaghi bearing capacity formulas to determine the toe…
A: The ultimate load which a foundation can support is calculated by terzaghi bearing capacity…
Q: Provide Feld’s rule for determining group capacity of pile groups ?
A: The general mathematical formula to calculate the efficiency of the pile group is ζ = Total pile…
Q: Describe the important advantages of driven piles.
A: Piles are defined as a foundation that provides support for the building structure. it is used for…
Q: Q-(e) If the effective plan area of a warehouse is 54 sq. m, and maximum height of piles permitted…
A: Given data- Effective plan area=54 m2maximum height of piles=270 cm=2.7 mTo find-The number of bags…
Q: Q # 1. What is pile foundation? Discuss the classification of pile based on materials/composition…
A: Pile foundation- a foundation laid with deep pile is known as pile foundation.
Q: What are the head details of H-piles under compression and subject to bending moment?
A: In question head details of H piles are to determined which is under compression and subjected to…
Q: Question 73/75 Static axial compressive pile load test shall be in accordance with what standard?…
A: Static axial compressive pile load test shall be in accordance with what standard? The answer is…
Q: Explain why are most marine piles circular in cross section?
A: Marine piles are circular in cross-section because: 1. Circular piles has high column buckling…
Q: 3- Describe the methods of stabilizing the sides of the excavation when making piles in loose soil…
A: A number of fundamental considerations should be taken into account while designing stable sides.…
Q: Explain some conditions which are consider for the structural design of driven piles.
A: The driven pile may be a form of pile that inserted up to the exhausting layer within the soil…
Q: Discuss the following method of load carrying capacity of pile : Static formula
A: There are four types of the load-carrying capacity of piles1) Static Method2) Dynamic Formulas3)…
Q: In what situation would the LTP be complemented by a pile cap?
A: A pile cap is a mat-like structure made of cement, sand and small scales. This mixture is placed in…
Q: Which one is a better choice, a large diameter piles or a system of several smallerpiles with the…
A: Piles plays pivotal role in stabilizing the superstructure. These are embedded vertically down into…
Q: In piling works, normally founding levels of bored piles are defined by using total core recovery or…
A: Piling is defined as being foundations that are driven or bored through the ground along a certain…
Q: Explain the methods of determining load carrying capacity of a pile.
A: Methods of determining load carrying capacity of a pile: Static method : suitable for friction…
Q: Define the functions of cap block, drive cap and pile cushion in driven piles?
A: Solution: Cap Block are generally installed between the end of hammer and the drive cap to control…
Q: Should engineers rely solely on Hiley’s formula in the design of H-piles?
A: Hiley Pile driving formulae: Hiley's pile-driving formula is described below according to IS:2911.…
Q: Q2/Explain the Piles Uses Briefly
A: Pile foundation is a type of Deep foundation and it is generally used when simple spread foundation…
Q: Describe the Method of representing pile for wave equation analysis.
A: Wave equation analysis is defined as a method for analyzing the behavior of the drive foundation…
Q: How the Driven piles are installed from the ground surface?
A: A pile is simply a large cylinder of a hard materials like concrete which is forced into the earth…
Q: The length of friction piles based on O Shear strength of soil O Pile size O applied load O all of…
A: 6. The length of friction piles based on: The loads are transferred from the structure to the soil.
Q: Discuss the following method of load carrying capacity of pile : Dynamic formula
A: Dynamic formulas are as follows. Engineering News Formula Hiley's Formula
Q: What distinguishes displacement piles from nondisplacement piles?
A: When the depth of a base exceeds three times the width, it is said to be stacked. A powered pile is…
Q: What is the ultimate downward load carrying capacity of a single pile driven in soil?
A: The ultimate downward load carrying capacity of single pile driven in soil are : - Using Analytic…
Q: What is Conventional static pile load tests?
A: Answer The pile load test is basically used to determine the bearing capacity of the pile. The pile…
Q: As driven piles penetrate into a saturated clay soil, why the material in the vicinity of the pile…
A: Once a pile is driven into clay, the soil around the pile develops vertical and horizontal…
Q: In designing the lateral resistance of piles, should engineers only use the earth pressure against…
A: Answer Introduction Lateral load resisted by the following ways 1) Passive soil resistance on the…
Q: What is a typical design group efficiency factor for piles driven into loose cohesionless soil…
A: The pile group efficiency is calculated from the ratio of the ultimate capacity of the group to the…
Q: An anchored sheet pile is to support a mass of cohesionless soil up to a height of 6 m above ground…
A: Given Unit weight of soil=21 KN/m3 Angle of internal friction= 30°
Q: Many engineers believe the only disadvantage to overdesigning pile foundations is the additional…
A: Yes, that's true. When a foundation is designed with higher factor of safety, it requires larger…
Q: Discuss about the Carrying capacity of single pile in granular and cohesive soil ?
A: The load bearing capacity of foundation soil or rock which enables it to bear and transmit load…
Q: Q4: It is required to construct a pile foundation comprised of 25 piles arranged in 5 columns at…
A: Given that Total imposed load= 3000 kN The diameter and length= 50 cm and 12m The water table was…
Q: Explain these two questions based on pile foundations: i) How do the soil stress states and strain…
A: 1) How do the soil stress states and strain states change by the installation and structural loads?…
Q: Describe the factors of safety for design of piles.
A: Answer IntroductionA pile foundation is a cylindrical structural member made of concrete, steel, and…
Q: Define the types of piles on the basis of their function with sketches.
A: Answer:- Pile: A pile is a long cylinder made up of a strong material such as concrete and a series…
Q: For a rigid pile cap with vertical piles at the middle and raking piles at the sides,what is the…
A: Brief concept- Piles are provided in the deep foundation where the applied load is very high and the…
Q: What is the most common yield strength of steel used for steel piles?
A: Yield strength: It is defined as the maximum stress applied to material until before it changes to…
Q: What are the primary advantages of using laterally loaded vertical piles instead of battered piles?
A: Introduction: Piles are used generally to transmit vertical loads and lateral loads to the…
Q: Discuss the categories of the loads acting on piles.
A: Answer The load has the following categories1- Axial Loads2- Lateral Loads
Q: Explain how wave equation analysis combined with static or dynamic load tests can be used to…
A: The wave analysis process is very important to know the relation between the pile capacities and…
Q: Relating to the installation of driven piles, provide a brief explanation of spudding,predrilling,…
A: Spudding: Spuds will penetrate scrap or arduous strata therefore the pile will reach the bearing…
Q: Describe the equivalent footing method of computing pile group settlement with the help of a…
A:
Q: Compare circular, square and I section piles in terms of usage, cost and advantages/disadvantages?
A: Circular Piles Usage These sections require less material to construct and provide stronger and…
Q: What is pile foundation? Discuss the classification of pile based on materials/composition and load…
A: Pile foundation - Pile foundation is the deep foundation that is employed to transmit the building…
Q: What is “block failure” in a group of piles and how does it differ from individual failure?
A: The cylinder which is long and used for carrying loads and transfer it to hard strata and made up of…
Q: Why would it be inappropriate to design a drilled shaft using a static analysis method developed for…
A: Static analysis is used to figure out: A pile's or a pile collective's nominal resistance in…
Q: Which are the Method of representing pile for wave equation analysis?
A: Wave equation analysis is a mathematical strategy for analysis for the conduct of driven…
Q: Identify the construction methods for helical piles.
A: piles are one of the best creations of civic industry and still, It is very useful in many aspects.…
What are Compression piles ? Explain the purpose & uses of Compression piles ?
Step by step
Solved in 2 steps
- State the different types of piles according to its function and construction?Relating to the installation of driven piles, provide a brief explanation of spudding,predrilling, and jetting (indicate the general purpose for the procedure, and the differences in the methods).Describe the factors of safety for design of piles.