What are different types of lattice defects

Q: Calculate the moment of inertia of the shaded area about the x-axis. 89 mm Answer: Ix 89 mm 68 mm…

A:

Q: Q.1) The following truss has a pin support at A and a rocker support at G. Points A, B, C, D, E, F,…

A: The following truss has a pin support at A and a rocker support at G. Points A, B, C, D, E, F, G are…

Q: The figure below (for illustrative purposes) shows a perfectly rigid (non-deformable) beam which is…

A:

Q: Consider a steam power plant that operates on a reheat Rankine cycle and has a net power output of…

A: The steam enters the high pressure turbine  .The steam enters the low pressure turbine  .The…

Q: A conveyer belt at the postal service deposits packages down a chute of radius p to be sorted. At…

A:

Q: The following EOMs describe the behavior of an electric motor attached to a torsional spring and…

A:

Q: Using masons rule find the transfer function G(s) = C(s)/R(s)

A: Given:To find:Transfer function.

Q: To build a 20 µm wide fixed-free cantilever beam with a force constant of 10 N/m and a resonant…

A: Given data:Width of the cantilever beam = Force constant = Resonant frequency = Young's modulus =…

Q: Calculate the BPs

A: To calculate the at sea level, we first need to calculate the air density at sea level. We can use…

Q: In the new model of the pump, water leaves the impeller with a velocity of 25 m/s and an…

A:

Q: A chemical process is expressed using the following transfer T'(s) 4(1-s) Q'(s) s(3s+1) Where T and…

A: To resolve this issue, we must utilize the provided transfer function to calculate the amplitude of…

Q: A combined gas-steam power cycle uses a simple gas turbine for the topping cycle and simple Rankine…

A: Given that:For gas turbine cycle:For Rankine cycle:Net power output of the system = 110 MWTo…

Q: Calculate the moment of inertia of the shaded area about the x-axis

A:

Q: A water gate is to be reinforced with three horizontal beams (running to the page). If the water…

A: A water gate is to be reinforced with three horizontal beams (running to the page). If the water…

Q: The steel rod having a diameter of 1 in. It is subjected to an internal moment of M= 200 lb⋅ft…

A:

Q: Help provide a mathematical model of each of the air conditioning components of the system and the…

A: To Find:the mathematical model of each of the air conditioning components of the system. the key…

Q: The steel eyebolt shown in the figure is loaded with a force F = 300 N. The bolt is formed from wire…

A:

Q: When a free vibrations is run on the system, the ratio of amplitudes on successive cycles is 2.5 to…

A:

Q: 4. Air flows into a pipe from the region between a circular disk and a cone as shown in Fig. P4.55.…

A: The velocity is given by relation The value are

Q: Carbon Dioxide (M=44) is being stored at 46°C, 80 bar. The critical temperature and pressure are…

A:

Q: The bent rod is supported as shown in the figure by a smooth surface at B and by a collar at A,…

A: F = 120 lbM = 400 lb⋅ft

Q: Air enters the turbine of a gas turbine at 1200 kPa, 1200 K, and expands to 100 kPa in two stages.…

A: Assumptions:Since working fluid in gas turbine cycle is air, hence assume cold air standard analysis…

Q: Q. 2) Given the following system of forces acting on the solid as shown, (a) Determine the…

A: A solid structure is given with force and moments acting as shown.

Q: Air is expanded from 320 psia and 500°F to 100 psia and 50°F. Assuming constant specific heats,…

A:

Q: You have a round power-takeoff shaft guard. The inside diameter of the guard is 3.5 inches. You need…

A: We have round power takeoff shaft(PTO)The inside diameter of the guard is 3.5 inches.Clearance =1/2…

Q: Problem 3 CD steel. Calculate the maximum principal stress within the rod. 100N The solid bent rod…

A:

Q: Q3 An oil engine working on the dual-combustion cycle has a cylinder diameter of 25 cm and stroke of…

A:

Q: -1-60 in. and L2= ne the maximum shear stresses T₁, ne the rotation angle DA of gear i in.,…

A: The power supply by the motor is The speed of the motor is The diameter of shafts 1 and 2 is The…

Q: 14.14 A cast iron pipe (E = 1.0 × 10¹¹ Pa) is 0.9 m in diameter and carries water (K=2.0 x 10⁹ Pa)…

A: The elasticity of pipe is .The diameter of pipe is .The bulk modulus of water is .The velocity of…

Q: A mass of 4 kilograms is attached to the end of a spring. A force of 8 N stretches the spring 80 cm.…

A:

Q: Consider incompressible flow at a volume rate Q toward a drain at the vertex of a 45° wedge of width…

A:

Q: We said above that G(w) does not depend on the number of people or their mass, and that it increases…

A:

Q: Water is to be heated as it flows through a carbon-silicon pipe of inner diameter 3 cm and wall…

A:

Q: A piston-cylinder device initially contains 1.0 kg of water at 30 o C and 2 MPa. The water is heated…

A:

Q: The end rollers of bar AB are constrained to the slot shown. If roller A has a downward velocity of…

A: Given:To find:Tangential acceleration of roller B.

Q: For the two-bar planar truss shown in Figure Q1 below, determine the displacements of node 1 and the…

A: Consider as horizontal and vertical displacements of node-1. Similar meaning applies for nodes 2…

Q: Determine the product of inertia of the shaded area about the x-y axes. y 160 Answer: Ixy 40 M Save…

A:

Q: Application of de A motorboat and its load weigh 2,450 N. AssumIng that the propeller force is…

A:

Q: 2. a. Find the expression for dh dt dh b. Compute if D₁ = 1in, D₂ = 3 in, dt V₁ = 3ft/s, V₂ = 2ft/s,…

A:

Q: 3. Determine the x, y, z components of reaction acting on the ball-and-socket at A, the reaction at…

A: Given , a plate in which a uniformly distributed load of 40 lb/ft acts from A to B  and a moment of…

Q: the turbine, the work consumed by the pu bles. t Turbine

A: Write the properties of water at each state.

Q: 2. Determine the moment projected by the force F in the above figure about point O. Express the…

A: F=5 kN%Matlab Script:clear,clc% i)ra=[ 0 0 12] % ra position vector [x-coordinate y-coordinate…

Q: Write the steady-state solution as p(t) = hM cos (wt + o) and plot M versus frequency ratio for…

A:

Q: Considering now the real case, where the turbine and feed pump are not isentropic, and the feed pump…

A:

Q: 3. A cable winch is driven by a hydraulic motor and reduction gear, whose transmission ratio i=5.…

A: The hydraulic pressure, p = 240 bar = 240105 N/m2The mass to be lifted, m = 5000 kgThe transmission…

Q: Is this the only correct option in the question above? I think the question is worded for more than…

A: To elaborate why a sling psychrometer can measure humidity.

Q: Consider the smooth uniform bar shown in (Figure 1), which has a mass of 15 kg. Neglect the…

A:

Q: 2) Determine the force in each member of the loaded truss. Ans. AB = 12 kN T, AE = 3 kN C BC= 5.20…

A:

Q: Question 1 A sparepart distributor is deciding on a policy for the use of TL or LTL transportation…

A: To Find:the optimal order size and annual cost if it is ordered independently of each other.the…

Q: Cylinders X and Y, connected by a rigid rod curved parallel to the smooth cylindrical surface,…

A:

The Space Lattice and Unit Cells

Every matter consists of atoms, molecules, and ions. If these atoms, molecules, and ions (micro-particles) are represented in a three-dimensional space-occupying certain specific points in space, then these arrangements are termed as space lattices and the specific points which are being occupied by atoms, molecules and ions are termed as lattice points. The atoms, molecules, and ions at the lattice points are generally grouped in a regular fashion and repeat periodically at the three-dimensional space.