What are the errors caused by improper plumbing?

Q: FUNDAMENTALS OF SURVEYING UPVOTE WILL BE GIVEN. Please write the complete solutions legibly. And…

A:

Q: What force is required to stretch a wire of 1 cm² in cross- section to double its length? Given Y =…

A:

Q: A 5-lb soil sample was taken from a fill. The volume of the hole from which the sample was taken was…

A:

Q: The supporting bars (1), (2) and (3) shown are made of A992 steel [E = 29,000 ksi] and have equal…

A: Given :

Q: b) A workshop of six similar internal surfaces possesses a reverberation time of 3 sec. The…

A: The given data is shown below: Distance=2mSound power level=80 dBQ=2

Q: A trapezoidal channel (slope = 0.006, n = 0.014) has a bed width of 4 m and is with a side slope of…

A: Given- Slope S=0.006n=0.014bed width B=4 mside slope=1:2 (V:H)⇒m=2flow rate Q=100 m3s-1It is needed…

Q: Water at 25° is flowing between A and B through a steel pipe 30 centimeters in diameter and a length…

A:

Q: A partition of total area 20m². consists of a brick wall plastered on both sides to a total…

A: According to given data  A partition of total area 20m². consists of a brick wall plastered on both…

Q: Sum of the length of the solid boundaries of the section in contact with the fluid is known as A.…

A: Given: Sum of length of the solid boundaries of the section in contact with the fluid is known as…

Q: Chlorine is used as the disinfectant in a municipal water treatment plant. It achieves 50 percent of…

A: Given- Efficiency n1=50%time t1=3 minutescase-2Efficiency n2=99%time t2=?

Q: 50 KN 2m C. The force R = 600 kN is the resultant of the forces P, Q and 50 kN in figure 3. 1.…

A: Note: Hi! Thank you for the question As per the honour code, We’ll answer the first question since…

Q: Calculate the porosity of a rock that is 50% Quartz, 50% Muscovite, and that has a bulk density of…

A:

Q: .53 A structural member carrying a pull of 700 kN connected to a gusset plate using rivets of 20 m…

A: Rivet value=minshear,tear,crushRivet value=35kn

Q: A horizontal nozzle of 30 mm diameter discharges a steady jet of water into the atmosphere at a rate…

A: Given: Diameter of nozzle, d =30 mm = 0.03 m Discharge of water, Q=15 l/s = 0.015 m3/s Density of…

Q: The 1000N block shown started at rest and moves towards the right. Which if the following gives the…

A: According to Given data   Figure given is-   The 1000N block shown started at rest and moves towards…

Q: Situation #2: A properties: Width, b = 400 mm 415 MPa rectangular beam has the following Effective…

A:

Q: A canal is proposed to be made in soil having cohesion 25 kN/m2, p' = 0° and void ratio of 0.792 and…

A: Given- Cohesion of soil C=25 kN/m2ϕ'=0ovoid ratio-e=0.792G=2.65Side slope=1:1FOS=2.5Stability no.…

Q: Given a 25-year storm event using the rational method for the drainage basin located in Pennsylvania…

A: Given, For overland flow, L = 100 ft and S = 2% or 0.02

Q: need fast pleasee   A distance was measured on an 8% slope and found to be 2528.75. what is the…

A: Horizontal distance = length measured along the slope+ correction  Given, Slope length = 2528.75 m…

Q: Three structural member(AB,BC, and CA) of equal lengths L, areas A, and elastic moduli E,…

A:

Q: A three-fluid system (immiscible) is a vacuum pump. The specific gravity values of the fluids (S₁,…

A:

Q: The following are the potential unethical behavior of a Quantity Surveyor (QS) in preparing the…

A: Quantity Surveyor : Quantity surveyor is a professional expert in construction industry who has…

Q: A reinforced concrete circular pile of 12 m length and 0.6 m diameter is embedded in stiff clay…

A: given- Length L=12 mdia=0.6 madhesion factor=0.5coehsion C=100 kN/m2

Q: Solve the differential equation (x + sin y) dx + (xcosy-2y)dy =0

A: Given, (x+siny )dx + (x cosy -2y) dy =0 To solve for above differential equation,

Q: Question 7: Given a 1050 HR steel, estimate (a) the rotating-beam endurance limit at 106 cycles. (b)…

A: Given data: 1050 HR steel

Q: hi, can you please explain where was the 9.17 and 61.777 solved from?

A: Solution: The values of P/A and P/G should be calculated from the Compound interest tables. Based on…

Q: Q4) Circular curve connects two straights intersected at a station (20+20.10).If the deflection…

A: Given:Setting pot curve  by PI method

Q: 2. Refer to Figure Q2, which shows a diagram of a loaded frame. Using the Principle of Virtual Work,…

A:

Q: Solve the problem using the NRCS method for a watershed located right outside New York City, New…

A: Solution: Given: Segment TYpe of flow length ft slope % 1 Overflow 100 4 2 Shallow channel…

Q: 4. Determine the rectangular representation of the resultant force and direction angle of the figure…

A: Given data:

Q: Oil flows through a circular pipe at a rate of 0.4m^3/s.  Density p= 960kg/m3  Length of Pipe =…

A: Given Flow rate = 0.4 m3/s.  Density p = 960 kg/m3 Length of Pipe = 120 m Head loss along the length…

Q: AT beam supports the three concentrated loads shown in Fig. P-556. N.A. is 3.5 in., INA = 97.0 in.…

A: Given data: INA=97 in4

Q: The smooth pipe rests against the opening at the points of contact A, B, and Cand supports the force…

A: Given : F = 300 N Find : Magnitude of reaction at A and B?

Q: Design a rectangular tied column for flexure in a reinforced concrete frame is subjected to the…

A: Answer  Calculation of maximum axial load demand Pu 1) Pu = 1.2*PD+1.6*PL Pu = 1.2*200+1.6*100 Pu =…

Q: A 1 m 10 kN 1 m 5 kN/m 21 2 m B

A:

Q: determine the member stresses of the truss shown. indicate if the stress in the member is in tension…

A:

Q: Elev.10 m 1 Válvula verificación Elev. 30 m Tub 1 2 3 L(m) 12 20 25 Ch 140 150 150 D 0.1 0.1 0.1

A: Given  Flow rate, Q = 15 L/s = 0.015 m3/s Efficiency, η = 75% = 0.75 Elevation of Upper Tank = 30 m…

Q: 3. Draw shear force and bending moment diagram of the beam shown in Fig.3 using slope deflection…

A:

Q: Q.24 Over a basin of area 333 km², there was a storm for 6 h with a uniform intensity of 2 cm/h. The…

A: Given- Area of the basin-A=333 km2time of storm-t=6 hUniform intensity I=2 cm/hrRunoff R=20×106…

Q: Convert the following to SI units: a. 8.0 in b. 66 ft/s c. 60 mph.

A: International system of units or SI units  has seven base units which are second for time, metre for…

Q: Solve the ff. Using CONJUGATE-BEAM METHOD ANSWER ASAP pls. Provide complete solution, I'll rate.…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Q1) The following angles and distance were measured in the closed loop traverse (ABCDEFA),Draw the…

A:

Q: A U-tube with both limbs open to atmosphere contains two in.miscible liquids of densities P₁ and p2…

A:

Q: E. To transfer loads from frame A to one end of the river to frame C at the other end, high strength…

A:

Q: 2-25. Determine the reactions at the smooth support C and pinned support A. Assume the connection at…

A: Given data:

Q: ← Traffic Volume and Capacity If saturation headway of given traffic is 2.5 sec and the cycle time…

A: Given- saturation headway-h=2.5 scycle time C=65 sStartup loss timeL1=2 sClearance time C1=1 sYellow…

Q: A 20 mm thick laboratory soil sample reaches 60% consolidation in 32.5 seconds under double drainage…

A: Given- thickness of soil sample H=20 mmConsolidation U=60% time t=32.5 sDouble drainage conditionIt…

Q: Water is pumped from a supply reservoir to a ducti iron water-transmission line, as shown in Figure…

A: Given : Flow rate through pipeline = 1 m3/s dia of pipe = 750 mm Pressure at A is 350 kpa To Find :…

Q: Situation 1 | A built-up beam made from fastening two channels to a wide flange section carries…

A: Bending stress: It is the stresses caused by the bending of the beam. Its variation is zero to the…

Q: The hoist shown is used in a machine shop to position heavy workpieces in a lathe. If the cable…

A: Given :

Collection Systems

The collection systems form a part of sanitary engineering, which is a sub-branch of civil engineering. It is also known as public health engineering and wastewater engineering. It is a methodology followed to remove and properly dispose of human waste, along with creating systems to provide safe and clean usable water. These measures ensure a hygienic and disease-free community. Sanitary engineering, apart from building sewer disposal units, is also involved in plumbing, fire protection, hydraulics, life safety, environmental protection, information technology, microbiology, pathology, and so on.