What are the function of the following 8085 pins: INTR, RESET, HOLD, TRAP, ALE.

Q: 1. What is the ideal line percent regulation rating? 2. Shunt voltage regulators require  __________…

A: The objective is to determine line regulation and voltage sampling.

Q: Calculate v(t) for t> 0 in the circuit

A: The given RLC circuit can be analysed by considering the response before t=0 and after t=0.

Q: A 5 kVA single-phase transformer has a core loss of 35 W and a full load copper loss of 40 W. It…

A:

Q: 2 In these sentences the words in italics have more than one meaning. What is the correct definition…

A: We are authorized to answer only 3 subparts at a time since you have not menioned which question you…

Q: A 3-ph balance express feeder has an impedance of (6+j20)/ph. At the UP load end, the line-to-line…

A: Given data, Impedance of per phase Zph=6+j20 Ω/ph Line voltage VL=13.8 KV Absorbed power P = 1200 KW…

Q: 22. The voltage applied to the h.v. side of a trans- former during short-circuit test is 2% of its…

A:

Q: Vi +40 -40 t + Vi D₁ R₁ = 2.2 ΚΩ D2 www R₂ = 2.2 ΚΩ Vo RL= • 2.2 ΚΩ

A: NOTE- As per the policy we can answer only one question, please resubmit the question on the portal…

Q: Calculate the value of Zab in the network j6 Ω −9 Ω ασ m = -j9 Ω b a j6 Ω j6 Ω 20 Ω 20 Ω -j9 Ω 10 Ω

A:

Q: ) Three 1 Ohm resistors are in parallel. The total resistance is (a) 1/3 Ohm, (b) 3 Ohms, (c) 1…

A:

Q: OV- 15 V - 15 V 13V 15 V ---|---· - 15 V

A:

Q: Given the vector current density J = 8p³ z 3 : ap - 8p sin 2 ay m A/m ² find the current density at…

A: We need to find out the current density and current .

Q: Q2) show that: X(0)8(f) a) Stx(t)dt → + x(f) 2π]f 2 b) if x(t) = x(-t) (even symmetery) then all the…

A: Given data, a). ∫-∞tX(t)dt = X(f)2πjf+X(0)δ(f)2. b). if X(t) = X(-t) (even symmetery)then all sin…

Q: 5. In the circuit below, the switches S₁ and S2 are open initially and the capacitor has a charge of…

A: We need to find out time for given charge on capacitor

Q: Calculate Vo in the circuit 30 Ω ww 100 sin 200 V 50 Ω -- 50 με 0.1 Η υ(1)

A: The given circuit diagram is shown below:

Q: Evaluate the following integrals

A:

Q: A 440 V, shunt motor has armature resistance of 0.8 ohm and field resistance of 200 ohm. Determine…

A: Given data, Terminal voltage V = 440 V Armature resistance Ra=0.8 Ω Field resistance Rsh=200 Ω…

Q: Q1c) Find the equivalent resistance, Rab, of the circuit given at the terminals a-b. Show all work.…

A: In this question we need to find a equivalent resistance between terminal a and b

Q: beta (the part because inductive) and alpha (firing angle) in Thyristor factor or scale?

A: This question is regarding the thyristor factors like extinction angle and firing angle of the…

Q: Let A = -2ax + 5ay + az, B = ax + 3az, and C = 4ax -6ay + 10az. Find A ∙ (B x C)

A:

Q: The ac bridge shown in Fig. 9.84 is known as a Maxwell bridge and is used for accurate measurement…

A:

Q: Design an Ayrton shunt by indirect method to provide an ammeter with current ranges , 3A, 5A, 8A, If…

A: The meter voltage should be calculated by using the meter current and resistance and by using this…

Q: Homework 1: Apply the Shannon-Fano code procedure for DMS with the following probability. Find the…

A: As per company guidelines we are supposed to answer only one question. Kindly repost other questions…

Q: Find Vth and Rth at load. 5Ω M 202

A:

Q: Simplify the block diagram shown in Fig. (1), then obtain the closed-loop transfer functions C(s)/R…

A: Given circuit is ,

Q: A 100kVA, 6600/330V, 50Hz, single-phase transformer took 10A and 436W at 100V in a short-circuit…

A: It is given that: 100 KVA, 6600/330V, 50HzPsc=436WIsc=10AVsc=100 V

Q: Determine the equivalent impedance of the circuit j4 Ω H -j6 Ω 4Ω 2 Ω ww α ο j12 Ω b o j6 Ω ell j8 Ω…

A: In this question we need to find a equivalent impedance of the given circuit.

Q: Figure shows an improved series voltage regulator with current limit circuit protection 1. Calculate…

A:

Q: How does change in frequency affect the operation of a given transformer? with a decrease in…

A: Transformer:

Q: Calculate the value of Zab in the network j6 Ω -j9 Ω α. -j9 Ω bo j6 Ω j6 Ω 20 Ω ww 20 Ω -j9 Ω 10 Ω

A:

Q: For the following VTC, the time at which the output is 90% of the steady- state is: VH 400 90% VH+…

A: Given data, Voltage time characteristics:

Q: It is a circuit in which the carrier is varied in such a way that its instantaneous phase is…

A: In this question we will write about modualtion.....

Q: Find I(t) t = 0 12 Ω 24 Ω 6A i(t) 5Ω 2Η Answer: 2e-2t A, t > 0. Μ 8 Ω

A: We need to find out the current for given circuit

Q: 2. The figure below shows the cross section of a long cylindrical conductor of radius a, containing…

A: Given  The figure below shows the cross section of a long cylindrical conductor of radius a,…

Q: The value of E at P(p = 2,4 = 40°, z = 3) is given as E = 300ap -200a+100a V/m. Determine the…

A: Given  The question is related to electrostatics.we need to find the incremental work required to…

Q: *10. A moving particle encounters an external electric field that de- creases its kinetic energy…

A: Work done (W) on a motional charge is equals to kinetic energy  Change in KE is equals to work done…

Q: manufacturer quotes a maximum VSWR of 1.07 for a resistive load when it is used to terminate a 75 Ω…

A: We need to find out the percentage  reflection power

Q: . An FM signal has a deviation

A: Frequency modulation- When modulation is done by taking frequency of information signal modulated…

Q: A fault exists in a three-phase system is depend on the insulation level of the rated cable. Analyse…

A: Given A fault exists in a three-phase system is depend on the insulation level of the rated cable.…

Q: Vi Solve for VCB and VCE. 10 μF + '47 ΚΩ B 10 ΚΩ 18 V ' 2.4 ΚΩ C ΦΕ 10 με 16 + Vc β=120 1.1 ΚΩ Vo

A:

Q: in 2's complement system.

A: Code convertors-These code converters are used for conversion of one type of binary code to another.…

Q: 31. The all-day efficiency of a transformer depends primarily on (a) its copper loss (b) the amount…

A: As per bartleby guideline for more than three mcq asked only first three are to be answered please…

Q: Determine the equivalent impedance of the circuit j4Ω H 2 Ω -j6 Ω 4Ω ασ ww j12 Ω bo ell j6 Ω elle Η…

A: Given  A circuit and we need to obtain equivalent impedance of the circuit. Please find the below…

Q: 10. In a transformer, the leakage flux of each wind- ing is proportional to the current in that…

A: Given  Few multiple choice questions based on transformers. Please find the below attachment for…

Q: Q3) Mesh Analysis a) Write mesh equation for loop current I, and then simplify it in terms of I, and…

A: Given circuit,

Q: Write a short note on each of the following 1) Propagation constant 2) Phase constant 3)…

A: Transmission line  connection between the transmitter and receiver to permit signal transmission.…

Q: Find Vth and Rth at load.

A:

Q: Q1b) Find V. across the 1652 resistor.(Polarity as indicated) Simplify circuit to one voltage source…

A:

Q: 3 Given the vector current density J = 8p ³ z : ap- 8p sin 2 ay m A/m ² find the current density at…

A:

Q: Calculate the value of Zab in the network j6 Ω -j9 Ω m j6 Ω -j9 Ω bo j6 Ω 20 Ω 20 Ω j9 Ω 10 Ω

A: In this question,  We need to determine the impedance Zab  in this given network?  We are solving…

Q: The overall efficiency

A:

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.