What current I is needed to transmit 125 MW of power over a transmission line held at a voltage of 25.0 kV? 5 x10 Find the power loss P that would occur in the transmission line if a 1.65 Q line is used to transmit 125 MW of power. 37,13 x106 Ps Incorrect What percent loss does this represent? 29 percent loss: Incorrect

What current I is needed to transmit 125 MW of power over a transmission line held at a voltage of 25.0 kV? 5 x10 Find the power loss P that would occur in the transmission line if a 1.65 Q line is used to transmit 125 MW of power. 37,13 x106 Ps Incorrect What percent loss does this represent? 29 percent loss: Incorrect

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter20: Electric Current, Resistance, And Ohm's Law

Section: Chapter Questions

Problem 69PE: Unreasonable Results (a) What current is needed to transmit 1.00 102MW of power at 480 V? (b) What...

See similar textbooks

Similar questions

Integrated Concepts (a) Assuming 95.0% efficiency for the conversion of electrical power by the motor, what current must the 12.0-V batteries of a 750-kg electric car be able to supply: (a) To accelerate from rest to 25.0 m/s in 1.00 min? (b) To climb a 2.00 102-m- high hill in 2.00 min at a constant 25.0-m/s speed while exerting 5.00 102 N of force to overcome air resistance and friction? (c) To travel at a constant 25.0-m/s speed, exerting a 5.00 102 N force to overcome air resistance and friction? See Figure 20.44.
While taking photographs in Death Valley on a day when the temperature is 58.0C, Bill Hiker finds that a certain voltage applied to a copper wire produces a current of 1.000 A. Bill then travels to Antarctica and applies the same voltage to the same wire. What current does he register there if the temperature is 88.0C? Assume that no change occurs in the wires shape and size.
The human body can exhibit a wide range of resistances to current depending on the path of the current, contact area, and sweatiness of the skin. Suppose the resistance across the chest from the left hand to the right hand is 1.0 106 . (a) How much voltage is required to cause possible heart fibrillation in a man, which corresponds to 500 mA of direct current? (b) Why should rubber-soled shoes and rubber gloves be worn when working around electricity?
A large cyclotron directs a beam of He ++ nuclei onto a target with a beam current of 0.250 mA. (a) How many He++ nuclei per second is this? (b) How long does it take for 1.00 C to strike the target? (c) How long before 1.00 mol of He++ nuclei strike the target?
Integrated Concepts (a) An immersion heater utilizing 120 V can raise the temperature of a 1.00 102 -g aluminum cup containing 350 g of water from 20.0°C to 95.0°C in 2.00 min. Find its resistance, assuming it is constant during the process. (b) A lower resistance would shorten the heating time. Discuss the practical limits to speeding the heating by lowering the resistance.
Unreasonable Results (a) What current is needed to transmit 1.00 102 MW of power at 10.0kV? (b) Find the resistance of 1.00 km of wire that would cause a 0.0100% power loss. (c) What is the diameter of a 1.00-km-long copper wire having this resistance? (d) What is unreasonable about these results? (e) Which assumptions are unreasonable, or which premises are inconsistent?
A Van de Graaff generator is one of the original particle accelerators and can be used to accelerate charged particles like protons or electrons. You may have seen it used to make human hair stand on end or produce large sparks. One application of the Van de Graaff generator is to create X-rays by bombarding a hard metal target with the beam. Consider a beam of protons at 1.00 keV and a current of 5.00 mA produced by the generator, (a) What is the speed of the protons? (b) How many protons are produced each second?
A 20.00-V battery is used to supply current to a 10-k resistor. Assume the voltage drop across any wires used for connections is negligible, (a) What is the current through the resistor? (b) What is the power dissipated by the resistor? (c) What is the power input from the battery; assuming all the electrical power is dissipated by the resistor? (d) What happens to the energy dissipated by the resistor?
. The generator at a large power plant has an output of 1,000,000 kW at 24,000 V. (a) If it were a DC generator, what would he the current in it? (b) What is its energy output each day—in joules and in kilowatt—hours? (c) If this energy is sold at a price of 10 cents per kilowatt-hour, how much revenue does the power plant generate each day?
A man foolishly tries to fish a burning piece of bread from a toaster with a metal butter knife and comes into contact with 120-V ac. He does not even feel it since, luckily, he is wearing rubber-soled shoes. What is the minimum resistance of the path tire current follows through the person?
Unreasonable Results (a) What current is needed to transmit 1.00 102MW of power at 480 V? (b) What power is dissipated by the transmission lines if they have a 1.00 -resistance? (c) What is unreasonable about this result? (d) Which assumptions are unreasonable, or which premises are inconsistent?
If the current carried by a conductor is doubled, what happens to (a) the charge carrier density, (b) the current density, (c) the electron drift velocity, and (d) the average time interval between collisions?