Using the current divider rule, find the unknown currents for the networks below. 6A 8 Ω 8 Ω 6Ω 6Ω 4 6Ω

Q: Use a series of source transformations to find io in the circuit in (Figure 1). Take i = 1.6 A and v…

A: The voltage source in series with resistor can be converted into current source with parallel…

Q: In the network shown below, find R for maximum power transfer and the maximum power transferred to…

A: Given An electric circuit To find RL for maximum power transfer and maximum power transferred to the…

Q: A silicon wafer is doped with Phosphorus at 10¹5/cm³. Its conductivity is Use µn=1000 cm²/V/s and…

A: We need to find out the conductivity of given semiconductor.

Q: Q3) A Series DC Motor having a series field resistance of 0.25 ohm and an armature resistance of…

A:

Q: Determine T(s) = I₁(s)/V(s) if R1 = 1 ohm, R2 = 2 ohms, C1 C2 = 1F, and Vin = V(s). Vin ww R1 ww R2…

A: In this question we need to find the transfer function of the given circuit

Q: Q.12 In a two port network, Z₁₁ = 29, Z12 = Z21 = 592, The value of h₁2 is Z22=192 =1Ω

A: Given- A two port network- Z11=2 ΩZ12=Z21=5  ΩZ22=1  Ω To Find- The value of h12.

Q: 4. Consider the following circuit diagram, calculate total resistance; Rab. 120 12sint v 120 60 60…

A:

Q: The aggregated supply and demand for a particular hour of a day-ahead market of a two-sided auction…

A: Given: Supply:           Cs=10+0.2V+0.3V2 Demand:         Cd=100-0.3V-0.02V2

Q: Match Current (Torque) Control with Improper Pole-Zero Cancelation case to the resulting impact on…

A:

Q: 2. In the following series circuit the voltage measured across the inductance was 16.8V, the voltage…

A:

Q: 20 V 1 0 Write loop and node equations for each of the following: Μ 200 Ω (a) 500 Ω Μ 300 Ω 10 V 1…

A:

Q: Find the unknown quantities for the circuit below using the information provided. 10 V + I = 3 A 12…

A:

Q: P4: In the following transmitter/Receiver (Transceiver) system shown below find: H(w) m(t) =…

A: We need to find out unknown values for DSB modulation and de modulation .

Q: 3. Determine i.(t) in the op amp circuit given below if vs = 4 cos(104t) V and where R = 97 KQ.

A: The value of output current can be calculated by using the ideal operational amplifier…

Q: 13.69 Use the convolution integral to find v, in the circuit seen in Fig. P13.69 if v; = 75u(t) V.…

A:

Q: The characteristic impedance of a transmission line is 75+ 5600². The line is connected to a 200 &…

A:

Q: Select one: R₁-50KQ The voltage gain of the above amplifier is: 70 R:-10KQ

A: Using properties of ideal opamp calculate relation between input and output and then find gain of…

Q: Find the charge q(t) on the capacitor and the current i(t) in the given LRC-series circuit. L = 5 2…

A:

Q: A certain transformer has a ratio of 8:1. The primary winding resistance is 0.00283 Ω and has 1,165…

A: In this question we need to find the resistance of the secondary winding.

Q: If B = exp(r² - 2), what is VxB?

A: It is given that: B→=expr2-2where,r2=x2+y2

Q: Find all the prime implicants and essential prime implicants from the K-map below. be Prime…

A: We need to find out the prime implicants and essential prime implicants.

Q: The circuits below are in steady state. (a) Find the complex power received by the capacitor, in the…

A: Given data Resistance, R=2Ω Capacitance, C=10 mF Supply current, is=5cos100t+π3 A A voltmeter is…

Q: a. Transfer function (3 pts) b. What is the response of the system? (3 pts) Value of wo? (3 pts)…

A:

Q: A 50ft transmission line is used for a microwave system. Aportion of the transmission line is found…

A: We need to find impedance of transmission lines at low frequency.

Q: As shown in the below figure, a 10 resistance is connected across a source that has a load line…

A: It is given that: v+i=100                       ...... i

Q: 2) Draw a phasor diagram showing the supply voltage, the voltage across R, the voltage across L and…

A: In this question We need to draw the phasor diagram.  We know Current in the impedance Z, I= V/Z

Q: -30 S O 1 6 μF Figure 6.63 For Prob. 6.31. 2 I 3 4 5 LO 4 μF = +21 V t

A: Answer : given that  initial capacitor voltage V(0) = 0 to find the current and voltage across the…

Q: Question In the circuit below the switch has been closed for a long time, at t = Os the switch is…

A:

Q: Find R₁ for maximum power transfer and the maximum power that can be transferred to the load in the…

A: In this question We need to determine the value of load resistance RL  for maximum power transfer to…

Q: Design the Transmission Gate circuit for F = (ABC) + (CDE) + (BD). Do not simplify the function. Use…

A: According to the question, we need to design the Transmission gate circuit for the function F = AB C…

Q: Two rings of radius R=8 cm are 50 cm apart and concentric with a common horizontal axis (figure…

A: “Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: Solve for the voltages across and currents through every resistor given that all of the resistors…

A:

Q: www 6Ω ww 592 2 A 5 V 15 92 ww 8 V +|₁F 10 Ω ww 10 V 452 452 www Determine the power supplied by…

A: Given Data: A DC resistive circuit with, Branch currents and Node voltages  which are assumed as…

Q: Give the other types of high-pass filters. Draw the circuit and frequency  response of each.

A:

Q: Compute the root mean square value of the square wave shown below. V 20 V 0 0.1 0.2 0.3 0.4 t(sec)

A: Given- A square wave as shown- To Find- The root mean square value.

Q: In residential and commercial buildings, what kind of circuit connection is being used? Is it series…

A: Type of connection which is used in residential and commercial buildings :  Parallel connection…

Q: vị(t)u(t) + R L eeeee C + vo(t) See the dynamic RLC circuit shown above. It has a time dependent…

A: In this question we need to find the following Draw the given circuit in s domain. Find the…

Q: A plot of H (e) is shown below. What is the value of when |H(e") |=0? O 3 O 3.176 O 2 |³H| 3.5 3 2.5…

A: In this question We need to choose the correct options What is frequency if magnitude of the H(ejw )…

Q: 3. Could the function g(w) = 2e-w/3 be the magnitude of the Fourier transform of a real-valued…

A:

Q: 2. Consider the interconnection shown in Fig. 2. a) What value of a is required to make this a valid…

A:

Q: Two uniformly charged rods, rod 1 and rod 2, are placed as in the figure. Both rods are 40 cm long.…

A: “Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: Find the current through a 2002 resistance, and current through a 400 resistance

A: It is given that:

Q: Find the periodic time for the following wave forms,  (a) 60Hz ( b) 1000Hz

A:

Q: Given the input waveforms and the circuit configurations, sketch the output waveform for items (a)…

A: Given: The circuits with input wave forms as,  To do: Sketch the output wave forms for both the…

Q: A 1 meter long solenoid with 200 turns carries 2A of current Calculate the magnetic field on axis.

A: Given: Number of turns,N=200 Current,I =2A Solenoid of 1m long. Need to calculate magnetic field.

Q: For a particular BJT, Is = 5×10–15 A and I's = 10-13 A, calculate the collector current knowing that…

A: It is given that: Is=5x10-15 A,Is'=10-13 A,VBE=0.7 V,VCE=0.15 VVT=25.9 mV

Q: Calculate the current through each resistor in the figure if each resistance R = 1.28 k and V = 12.0…

A:

Q: c) Determine and sketch the even and odd parts of: x(t) = 4 µ(t-1), where μ() is the unit step…

A: We need to find out the even and odd signal for given signal .

Q: Calculate the voltages v/ and v2. 20ΚΩ 5mA www ww 5KQ 2V0 - + 4ΚΩ· V₂ + vo

A:

Q: 4-5. Determine the moment about point B of each of the three forces acting on the beam. F₁ = 375 lb…

A: 4-5)

Current Division Method

The generalized current divider formula is given by the following relation below,