what is kvl and kcl in circuit theory ?

Q: The domestic load in residential building comprises of the following: 6 lamps of 55 watt each, 4…

A:

Q: An 80μF capacitor in series with a 1000-ohm resistor is connected suddenly across a 220 V dc supply.…

A:

Q: Classification of substation in detail

A: Substation is a very important unit of a power system. It is a channel through which electricity…

Q: Question 6 a) Obtain the transfer function for the block diagram shown, by using the signal flow…

A: Given data, The block diagram is

Q: Consider a CMOS inverter, which the following nMOS VTO, n = 0.8 V PMOS VTO, p = -1.0V unCox = 50…

A: NMOS:    VT0,nμnCOX==0.8V50 μAV2   PMOS:    VT0,pμpCOX==0.8V20 μAV2   VDD=5VLn=Lp=1μmCout=2 pF…

Q: Suppose s(t) is an angle modulated signal with message signal m(t), peak frequency deviation Af =…

A:

Q: Implement the following Boolean function: * F(A, B, C, D) = E ( 0, 2, 3, 6, 7, 9, 11, 15 ) + d ( 1,…

A: The required circuit can be designed by using the Boolean expression obtained from k-map and also by…

Q: What are the basic logic gates in the MOS logic family? 1. NOR & NAND 2. AND & OR

A: Given  The basic logic gate of MOS logic family are

Q: 5V D1 R1 R2 Vout 1. The forward voltage of the diode is modeled as a constant voltage source Diode…

A: Given data, the value of resistance is2R1 = R2, The flowing current is 1 mA, The forward voltage is…

Q: For what use is a field-effect transistor (FET) ideally suited

A: FET is a three terminal electronic circuit element  Three terminals are Gate, source,drain It is a…

Q: analyse any six rules of indian electricity are mostly preferable

A:

Q: (b) For circuit in Figure Q4(b), given that Z₁₁ = 40N, Z1₁2 = Z21 = 60, Z22 = 802, Vs = 100 V, R₂ =…

A:

Q: Q2/ For the network shown in Figure (2),find the It and V. V= 0.5V oti 28 Γ΄ Δ Τ 5 ΚΩ R, Σ10 ΚΩ…

A: For the given electrical circuit we need to calculate the values of VL & IL.

Q: Q2:- For the series-parallel network of Fig. 1: a) Calculate Zr and Yr.b) Determine Ir and h.c) Find…

A: Given data,

Q: Determine the characteristic impedance for an air-dielectric transmission line with a D/r ratio of…

A: For the given question, We have, Dr=6.8Zo=?

Q: Find the step response of the system whose impulse respose is given as h(t) = u(t+1)-u(t-1).

A:

Q: 5. Find x[n] for each DTFT given below: (a) Xa(w) = 1 +e¯jw³ (b) Xa(w) = e-jw1.5, (c) Xa(w) = cos²…

A:

Q: Can you please describe the following: 1.) n-Channel JFET 2.) p-Channel JFET 3.) n-Channel…

A:

Q: Determine the gradient of the function f(x,y,z) = 3x4y2z3 at point (2,2,2).

A:

Q: Calculate the output voltage.

A:

Q: Problem 4. Determine the value of voltage V shown in Figure 5.6. 4Ω 50 V Figure 5.6 6Ω V

A: Given: Resistances = 4 and 6 To locate The circuit's voltage Solution: The circuit has a voltage of…

Q: What shunt resistance should be connected in parallel with an ammeter having a resistance of 0.040…

A: According to the given statement, An ammeter with resistance of 0.04 ohm is connected in parallel…

Q: Solar vehicle based on electrical machines and power systems for human applications with block…

A:

Q: Disadvantages of fuse in electric circuit.

A: What is Fuse? It is the economical protecting equipment within a circuit against circuit overloads…

Q: Explain why sapphire is used in the following heterostructure system of LED and mechanism for the…

A: An interface between two layers or regions of various semiconductors is described as a…

Q: what is  protective relaying? what is Time & Setting Multiplier ?

A: What is  protective relaying? A protection relays is a switching equipment which detect faults and…

Q: 83. An impedance Z, is in series to the two impedances Z₁ = 20-j100 and Z₂ = 10-1200 that are…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 3. In an ideal op-amp, which is not true? a) Open loop voltage gain is infinite b) Input resistance…

A: The input resistance of an ideal op amp is infinite so input of the op amp is open terminal so no…

Q: AH due to a current source is given by, H = [y cos (a x)]ā, +(y+e*)ā₂. Describe the current density…

A:

Q: find the phase-voltage Vol and torque angle (8) at full-load.

A: Alternator is a device which converts mechanical energy into electrical energy. It is also known as…

Q: + 20 V – 20 V + τό 10 ΚΩ SV 1 ΚΩ • 2.2 ΚΩ 7V· + • 2.2 kΩ

A: please refer the attached images for the complete answer...

Q: Consider a Bank with a floor area of 105sq.m. Solve for the load current rating of the br

A: For Bank floor of 105 sq. m then the general lighting load according to pec will be 105 * 28 = 2940…

Q: A 4 − μ F capacitor is initially charged to 300 V. It is discharged through a 100 mH inductance and…

A: Conditions For Oscillation: For oscillation, the condition should be Undamped or Underdamped and For…

Q: Determine the value of the capacitance, in picofarads, of a parallel-plate capacitor using a…

A: Given data : The dielectric of relative permittivity εr=4.07 The dielectric thickness d=33 mm The…

Q: An analog signal is sampled at 36 kHz and quantized into 256 levels. The time duration of a bit of…

A: Given, Sampling frequency, fs=36 kHz Signal quantized level, M = 256

Q: electrical engineering what is the function of inverter ?

A: Inverter : A converter known as an inverter transforms DC energy (from a battery or storage battery)…

Q: In a magnetic field, a coil with a resistance of 500 is placed. Determine the current at the coil at…

A: According to Faraday's Law of Electromagnetic induction, When a coil is placed in a time-varying…

Q: Type of earthing and explain each of them

A: Given: Type of earthing and explain each of them.

Q: What is the value of free space permeability?

A:

Q: (a) Ov For the circuit in Figure Q1(a), assume the circuit is in steady state at t = 0 before the…

A:

Q: (c) Consider the circuit shown in Figure Q2(c). (i) (ii) (iii) Determine the Thevenin impedance, ZTH…

A: Aim From the given circuit is to find the respective sub-parts of the question i.e, i,ii,iii.

Q: classify distribution system in electrical engineering

A: Distribution system in electrical are classified as: Radial system Ring main system Interconnected…

Q: The load per phase of a balanced 30 wye connected load is 8 + j6 Ohms per phase. This is connected…

A: For 3-phase supply, if they provide the voltage without saying line ya phase, then normally that is…

Q: A current of 10 A flows through a non-inductive resistance in series with a choking coil when…

A:

Q: A 2MVA, 2.3kV 3-phase Y-connected alternator operates at rated kVA at a power factor of 80%. The DC…

A:

Q: Two equal charges are released in a uniform magnetic field, one static and the other moving at a…

A:

Q: A meter whose constant is 600 revolution/ kwh makes 5 revolutions in 20 seconds . Calculate the load…

A:

Q: Explain each option & Choose the correct option. 4) The _ calculated load is rarely placed on an…

A: Aim To solve the three mcqs along with the necessary reason::

Q: at which time the current is zero. Im

A: Given: Inductor is 8 mH Resistor is 2 ohm potential 20 V t=0, I=0

Q: DIFFERENTIAL EQUATION with POWER SERIES: y" - xy = 0

A: An accumulation of words of the general form aₙ(x-a)ⁿ is a power series. Power series are functions…

Current Division Method

The generalized current divider formula is given by the following relation below,