What is preventive maintenance? Give two (2) advantages of it

Q: Q4. Why disposal of hazardous waste is not suitable by land filling?

A:

Q: Define the Navfac (1982) Correlation Between SPT Blowcount and Relative Density ?

A: The SPT N value is the number of blows required to penetrate the second and third 15cm penetration…

Q: Q.1: Buildings require maintenance to ensure their functionality and ensure that they do not…

A:

Q: A. Explain briefly what is an EMS B. If you are hired as project engineer to build a new cement…

A: Note: Hi! Thank you for the question As per the honour code, We’ll answer the first question since…

Q: What procedural guidelines are followed by the inspector regarding the safety program?

A: The guidelines to be followed by the inspector regarding safety program are,   1. Set Safety and…

Q: Explain impact of conveyor belt water cleaning machine to overcome flood issues.

A: The conveyor belt water cleaning machine is mainly used to collect floating or surface trash such as…

Q: How do Flow Irregularities impact certain pipeline operations and what are their advantages and…

A: Concept- Flow irregularities- These are the issues that arise while the fluid flows in the…

Q: With the aid of a diagram, discuss the As Low As Reasonably Practicable (ALARP)' principle for…

A: The idea of ALARP ("as low as reasonably practical") is used to understand how to manage security…

Q: What document is required for facilities before they discharge treated wastewater into bodies of…

A:

Q: What are the highway culvert design criteria and sizing principles, what risks they are exposed to…

A: Highway culvert: A highway culvert is a drainage system that allows water to flow beneath the road…

Q: Identify an engineering firm of your choice Determine the methods used by the firm in handling risk.…

A:

Q: what are the different approaches to Preventive Maintenance Optimization (PMO)?  Compare between…

A: Preventive maintenance optimization can be defined as it is a method of continuous improvement,…

Q: Which of the following occurrences are a specified (named) peril commercial building and personal…

A: The following occurrences are a specified or named  peril commercial building and personal property…

Q: Homework: What are other primary treatment systems? Describe flow equalization. Under what…

A: In the primary treatment process there are Screening, Grit removal, comunition and sedimentation…

Q: Select the best answer. How often must waste material and debris be removed to a disposal AND…

A: According to section 1926.252(b).All scrap and waste material shall be removed immediately from the…

Q: Why are dams not a permanent or long-term solution in flood prevention? Define liquefaction and why…

A: Brief concept introduction- Flood- Floods occur when an excess of water submerges normally dry…

Q: What criteria will you used to decide the type of (flume, open ditch, surface pipe or underground…

A: Flumes are specially shaped, engineered structures used to measure the flow of water in open…

Q: 1. What is the difference between PAHS and HAPS ii. What is the meaning of Environmental Impact…

A:

Q: A floodwall hasbeen builtwith a 20-year design period (T). Find: a. The probability that the…

A: The probability that the floodwall will overtop is given by: 1T Where,  T = Design period…

Q: construction site A that was recently issued a stop-work order from the artment of Safety & Health…

A: The condition when there is injury, illness, health damage, or death i.e. Fatality of the person on…

Q: inated data and provide FIVE (5) so

A: A word used in the arts to describe data that has been tampered with, either by accident ("sloppy…

Q: r functionality and ensure that they do not deteriorate to a state of creating safety concerns to…

A: Maintenance is defined as the work that is done periodically or annually for maintaining good…

Q: Discuss the suitable approaches for estimating expected hazard of non-predictable natural disorder?

A: Hazard are the events that cause damage and harm to human life. Natural hazards are natural events…

Q: As a highway or transportation engineer, what requirements should be meet for a flexible/rigid…

A: A Highway pavement is a structure consisting of a superimposed layer of processed material above the…

Q: what are the six drainage systems and their uses and applications?

A:

Q: Give one factor why settlements occur in the road pavement. What are the most common road failures…

A: Settlement is road pavement occurs due  to the compaction of upper layer or  the  highly compaction…

Q: A round concrete storm sewer pipe used to carry rainfall runoff from a parking lot is designed to be…

A: The pipe is half full so the wetted area will be half of the area of the pipe and is calculated as,

Q: What are the two situations of groundwater contamination due to factors other than a reaction with…

A: Groundwater is the water stored in the subsurface of soil or below the earth surface. The…

Q: What does “Refusal” mean during SPT Test?

A: Brief concept- SPT test- This test is done on the soil to check the soil for bearing capacity,…

Q: What is Epanet software of pipe design? Give a short introduction. (b) What concepts of Fluid…

A: a) Epanet is a software that is used to design the water distribution system for a particular area,…

Q: Is a Stormwater Management System Needed? Yes No Pre-Development Image Why is a stormwater…

A: Stormwater            is also an important resource as human population and demand for water grow,…

Q: at least 2 paragraphs, give your idea on how to deal with tight confined spaces in the drainage…

A: Brief concept introduction- Tight confined spaces- Entrance and exit points are limited or…

Q: Consideration of drainage is of practical importance. Why?

A: - Drainage is an arrangement in the form of closed pipes or open small channels used to drain off…

Q: 9) Obstacles of planning could be : a. Predicted risks b. Re- structuring c. Absence of monitoring…

A: Planning is a process of organizing various activities in required format, so as to achieve a…

Q: (A) What are the differences between coagulation and flocculation processes wit ct to their working…

A: INTRODUCTION:- Efficiency of sedimentation tank is very less if consist of fine suspended particle.…

Q: Explain the CBR test; how to conduct the test and its purposes. Where are the usages of test results…

A: CBR test also known as California Bearing Ratio test is conducted on especially soils on the…

Q: search at least five (5) modern technologies used in the mitigation of liquefaction hazard.…

A: Liquefaction is a procedure which generally naturally happens where the shear strength of soil mass…

Q: What are the points of convergence and divergence in the approaches to waste management hazardous…

A: Convergence and divergence in the approaches to waste management  Even in the developed countries…

Q: Estimated Cost Alternatives (present value) Useful life Element Year A B Row 40 $0 $40,000 $60,000…

A: Note-Since we answer three subpart at a time so we will answer the first three. Please resubmit…

Q: two environmental problems associated with groundwater?

A: Two environmental problems associated with groundwater can be described as under-

Q: The 1997 NEHRP Provisions limited the use of ELF method for irregular buildings. How many criterion…

A: The mentioned criteria as per 1997 NEHRP provision is shown below:

Q: Discuss and provide appropriate examples of application on how "lean construction nd 'value…

A: Given to give Examples on application of lean construction and value engineering that contribute to…

Q: Discuss at least 4 consequences of inappropriate disposal of MSW. Define the term; Reuse

A: Inappropriate disposal of municipal solid waste leads to many problems- 1. Leads to water…

Q: What are common sources of groundwater contamination?

A: Some of the groundwater pollution reasons are listed below :   Improperly, poorly designed landfills…

Q: What are the different approaches of hazard assessment? Give examples of how each approach applied

A: A hazard is defined as a condition, event, or circumstance that could lead to or contribute to an…

Q: Why the first performance period is more than the second performance period? I Initial…

A: Given data- A graph representing the variation of serviceability index with the time period is…

Workplace Safety

A workplace can be referred to as a space where people work together for the accomplishment of a common goal of the organization. Here, people can be a worker, an employee, and an employer. A person can be said to be an employer if he/she gets the job of organizational goal accomplishment through other persons, and that person gets paid for his/her service. All employees can also be referred to as workers. An employer may also hire workers of other categories which require specialized skills to finish a work. Both employees and workers along with the employer form the primary occupants of a workplace.