What is the average value of the half-wave rectified voltage of peak value 40 V A O V6.87 V 15.69 BO V 12.73 C O V 18.91 D O

Q: resonace

A: Resonance frequency- The frequency at which inductive reactance is equal to capacitive reactance it…

Q: A 10 M Hz carrier of peak value 10 V is AM amplitude modulated by a 1O kHz signal of amplitude 6 V.…

A:

Q: V For a zero-time average triangular signal with frequency 200 kHz, slew rate is 5 Us Determine the…

A: Given: Zero-time average triangular signal Frequency, f=200 kHz Slew rate, SR=5 V/μs

Q: Find tha value of the output voltage.

A: Referring to the circuit diagram, redrawing the circuit by marking the inverting and non-inverting…

Q: The oscillation frequency for the oscillator below is 3.12 MHZ for c=150 PF, L1=L2= 2.2 mH and M=0.5…

A:

Q: Determine the peak input voltage (Vpćim), peak output voltage (Vp(out), the average voltage (VavG)…

A:

Q: It is possible to detect the phase modulated signal non coherently. Select one: O True O False

A:

Q: In an RC-phase shift oscillator R= 1 kQ R¸= 1 k2 and C=0.1 µF. Calculate the frequency of…

A: Given that oscillator is RC-phase. Given values are -

Q: Determine the peak input voltage, peak output voltage, the average voltage and the peak inverse…

A: The waveform drawn for the given condition is shown below:

Q: Determine the resonant frequency of the Wien bridge oscillator for the resistor 11kO and capacitor…

A: we need to determine resonant frequency.

Q: Q/ In the uniform full wave Why is an outgoing voltage less than the transducent voltage?

A: Answer-

Q: 2. Determine Vo and Sketch output waveform for the clipper network shown. 2.2 k2 +30 V Si Vi O V 12…

A: The cut in voltage for silicon diode is 0.7 V  The calculation is shown in the next

Q: Determine the resonant frequency of the Wien bridge oscillator for the resistor 11KO and capacitor…

A: Given, Resistance (R) = 11 kohm  Capacitance (C) = 0.1 nF

Q: A 10 M Hz carrier of peak value 10 V is AM amplitude modulated by a 10 kHz signal of amplitude 6 V.…

A: Given, fc=10 MHzAc=10 Vfm=10 kHzAm=6 V

Q: Redraw the common emitter high frequency response

A:

Q: If the frequency of the input signal is 200 Hz, the frequency of the full-wave rectified signal…

A: The relation between the input and output frequencies for a full wave rectifier is given below:

Q: 1. 7 Pass filter High need to find 0.1NF RH CH High frequency cutoff 20 KHZ.

A: The operational amplifier setup a high pass filter . After finding finding the transfer function of…

Q: x(1) = rect (8r) Identify the CTFT of the given signal. Check All That Apply x(1) = (†) sinc (4)…

A:

Q: IN class A chopper, if the inductance is increased, then the output voltage will be smoothed the…

A: In class A chopper load is current is same as inductor current.

Q: A chopper has input voltage of 250 and the load resistance as 6Ω, the average load current as 53.5A.…

A:

Q: 10.13 Determine the critical frequencies for each of the following circuits: 5 µF 0.1 µF

A: The solution can be achieved as follows.

Q: Series RLC H() 40 20 700 180 100 (ap) e Phase (degy

A: It is given that: vin(t)=5 u(t) Vt=1 s The given magnitude and phase diagrams are:

Q: If f()=tsin 3t then f(t) is called as signal time multiplied exponential O exponentially decreasing…

A: Time multiple exponential.

Q: A dielectric resonator is considered to be closed at both the ends. O a. FALSE O b. TRUE

A: Dielectric resonator: It is designed to serve as a resonator for radio waves.

Q: In CRO, the oscillator circuit that produces sweep wave is called O Intensity grid O Accelerating…

A: Given :   In the above question they are interested to know the definition of the sweep wave…

Q: Q/ Calculate the o/p output for integration when vin= ±5 square wave and f=1kHz R= 500 N C=1µF

A: Square waveform Vin = +_5V Frequency f= 1kHz Resistance R= 500 ohm Capacitor C= 1uF Output of…

Q: carrier of peak value 10' V is AM amplitude modulated by a 10 kHz signal of amplitude 6 V. The…

A:

Q: 7. Determine the SQR for the following input signal and quantization noise magnitudes: V. (Volts…

A: Given: Input signal and quantization noise magnitude

Q: / Determin The magnitude of The Resultant For ce :- 15 30°

A: To determine the magnitude of F2 = ?

Q: It’s expected to construct one of the listed circuits and answer the relevant questions. 1. Series…

A: Resonant Circuit- A circuit which having low or very low impedance at certain frequencies.

Q: Determine the peak for both half cycles of the output waveform +16 V. -16 V V= 4 V O A. -16 V/-16 V…

A:

Q: 50 A RA RB 31.95 N { 0.05 O Determine IA and IR

A:

Q: 5. A 300-W carrier is modulated on a depth of 60 %. Calculate the total power in the modulated wave…

A: In this question, Power of the carrier signal Pc=300-W modulated  depth m=60 %. Calculate the total…

Q: Determine  • IC • RC • RB • VCE

A: In this question,  Find the • collector current IC  • Resistance RC  • Resistance RB  • Voltage VCE…

Q: R 47k Vo 220n Figure 1: RC Low pass filter. 1. (a) What is the cutoff frequency of the circuit shown…

A:

Q: Find the value of Cext for the following oscillator, cutoff frequency =25kHz 45,5 V RESET Vee DISCH…

A: The given 555 circuit is: Cutoff frequency, f=25 kHz

Q: Determine the fundamental period of the signals: x[n] = 1+ e() + el)

A: Given data, xn=1+ej2π7n+ej2π5n

Q: Q.1: Draw the output voltage of the circuit shown below, if the input voltage 17Sinwt. R Vị V. D G.…

A: To solve above mentioned problem, one should have clear understanding of working of diode. A diode…

Q: Ex, Shew that the cffetive Value or (r-S) 4Sine Wave Curreat w.th peak current Im in Iram.s Im Im

A:

Q: Determine the peak value of the output waveform V= 5V 20V R O A. -25 V O B. +25 V O C.OV O D. +15 V…

A: We need tell peak value of output voltage . We will check whether diode will be on or off .

Q: The fundamental period of the signals g[n] = sin(13 tn n / 6) – cos(9 Tn n/ 7) Select one: O a. 12…

A: Periodic Signal: A wave in discrete domain is said to be periodic if it it repeats itself after…

Q: Average value is equal to 63.66 percentage of the peak value. Select one: True O False

A: Given  Average value is equal to 63.66 of maximum value

Q: 2) Draw the expected output graph of the following circult. V=0,5V sine wave, R 100k, Rin 50kQ t…

A: We have to draw expected output graph of the given circuit : where,  Vi=0.5 V (sine wave)Rf=100…

Q: Choose a suitable frequency of the input signal which can be amplified by DC amplifiers. O 2GHZ 10HZ…

A: Choose the correct option Which frequency is of the input signal which can be amplified by the DC…

Q: Average value of output voltage (V) Peak value of RMS value of output voltage (V) output voltage (V)…

A: (1)Full wave bridge , no capacitor:Given that VS,RMS=220 V, f=50Hz,R3=10KΩ,N=11VO,RMS=220(111)=20…

Q: * Refer to the given figure. If Vin = 5 V, the rate of change of the output voltage in response to a…

A:

Q: öslg äbäi Find the value of Cext for the following oscillator, cutoff frequency =25kHz +5.5 V R 1.0…

A: The given 555 Astable multivibtrator is Cutoff frequency=25kHz

Q: 2. Determine the frequency of oscillation for the circuit of the figure below: Vout 20 k 10 k 50 k…

A: In this question we will find frequency of oscillation...

Time-Varying Field

Maxwell's equation in differential form are given as :