The pressure exerted by a molecular hydrogen gas at a temperature of 7 °C is 1.01x105 N/m². Assuming thehydrogen molecular diameter is 2.0 x 10-10 m, and the mean speed is 860 m/s. What is the collision frequencyof the molecules. Useful constant: kg = 1.38 x 10-23%3DO a. 1.273 sO b. 1.172 x 10'sO c. 2.580 x10° sO d. 1.273 x 10°s

for solution refer below images. NOTE:- here, answer demanded is frequency and frequency's unit is…

Answered: What is the collision frequency

Engineering

Mechanical Engineering

What is the collision frequency

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

An 8 m/s wind enters a wind turbine rotor with a diameter of 36 m. Assume the air density 1.2 kg/m3 Calculate: The power of incoming wind, The maximum power extracted by the wind turbine, If the gearbox, generator and electrical transmission and processing efficiencies are 0.85, 0.96 and 0.95, respectively, what is the turbine effective converted power
Suppose we got the following data during a test of a 2- stroke engine in which gas is usedas a fuel:Diameter of the piston = 149 mmStroke length = 179 mmClearance volume = 0.88 literrpm of the engine = 302Indicated mean effective pressure = 6.0 barGas consumption = 6.0 m3/hCalorific value of the gas (fuel) = 16990 kJ/m3Make a clear sketch the geometry of this engine using the data and determine thefollowing:i. Indicated power developed by the engine in watt.ii. Air Standard Efficiencyiii. Indicated thermal efficiency of the engine.
A ramjet drives a missile at V0=966m/s at an altitude of 33.5km (air density 0.01kg/m3 and T0=232K). If the missile inlet captures a stream tube of air A0=1,1m2 in area, the fuel-to-air ratio is 0,049, and the fuel heating value is 50MJ/kg. what is the fuel mass flow rate?
A steam generator generates flue gas at an average temperature of 260 C inside a Chimney. The theoretical draft is 0.5 kPa and the ambient condition of the air is 21 C and 100 kPa. Assume the coefficient velocity to be 0.30 and the molecular weight of the flue gas is 32. For air-fuel ratio requirements per second of 15, calculate: a. The diameter of the Chimney, meter b. The theoretical draft, cm H₂O
Two homogeneous spheres of mass M radius R joined by a bar of length L = 2R, negligible mass, and suspended from its geometric center by a rope such that when rotated ϕ exerts torque −kϕ with k torsion coefficient of the wire. The air exerts dissipative effect F = −6πηv on each sphere, where η is the viscosity of the air and v is the linear velocity of each sphere. If I0 = 25MR2 is the moment of inertia of a sphere with respect to its center of mass (image 1)determine the equation of motion of the pendulum. (image 2)
Over a 30 m length of 150 mm vacuum line carrying air at 293 K (Molecular Weight =26.44 kg/kmol, Viscosity = 18.12*10^-6 N s/m^2), the pressure falls from 1 kN/m^2 to 0.1 kN/m^2. If the relative roughness e/d is 0.002, what is the approximate mass flow rate? (unit is required).
A) A full propane cylinder from a camp stove leaks its content of 0.9 kg into a (3mX3mX3m) room at 20deg C and 1 atm. After a long time, the fuel gas and room air are well mixed. Is the mixture in the room flammable? Note: propane air mixture is flammable for 0.51 > Ф > 2.83 B) A jet of ethylene exists a 20 mm diameter nozzle into still air at 300K and 1 atm. Compare the spreading angles and axial locations where the jet centreline mass fraction drops to the stoichiometric value for initial jet velocities of 15 cm/s and 5 cm/s. The viscosity of ethylene at 300K is 102.3*10^-7 N.s/m^2 Note : I need both of above
A stream of air at 77°F and 1.2 atm absolute flowing at a rate of 225 ft3/h is blown through ducts that pass through the interior of a large industrial motor. The air emerges at 500°F. Calculate the rate atwhich the air is removing heat generated by the motor. What assumption have you made about the pressure dependence of the specific enthalpy of air?
A centrifuge with a diameter of 1.2 m and a height of 40 cm must spin at what rpm. For a suspension with particles bigger than 25 microns, a liquid thickness of 18-cm in the bowl that flows out at a rate of 100 L/min? Particles have a density of 1250 kilograms per cubic meter. The density of the water is 991 kg/m^3, with a viscosity of 0.88 cP.
Q/ ture or false -The flow curves are classified according to the number of reactors and the mechanism of separation or non-separation in the cores
The application rate of a certain chemical is recommended at 4 kg/ha. The calibration test of a 16-liter knapsack sprayer is as follows: Nozzle discharge = 1.2 liters/min, swath = 1.5 m and walking speed = 20 m/minDetermine the amount of chemical to mix with water per loading:a. 102 gms/load b. 160 gms/loadc. 200 gms/load d. 240 gms/load
The spread of pollutants through the atmosphere is governed partly by the effects of winds but also by the natural tendency of molecules to diffuse. The latter depends on how far a molecule can travel before collid ing with another molecule. Calculate the mean free path of diatomic moleculesin air using σ = 0.43 nm2 at 25 °c and (a) 10 bar. (b) 103 kPa. (c) 1.0 Pa.