What is the current passing through on 1202 resistor asshown in the given circuit in units of A?20-W3QW-6QW12 Qwww48 V60W60LW8Qww

Answered: What is the current passing through on…

What is the current passing through on 12 resistor as shown in the given circuit in units of A? 20 ww 3Q -M- 6Q Ww 12 Q -w 48 V 60 ww 60 w 8Q www

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter2: Electrical Quantities And Ohm’s Law

Section: Chapter Questions

Problem 1PA: You are an electrician on the job. The electrical blueprint shows that eight 500-W lamps are to be...

See similar textbooks

Related questions

Q: 8. A 10 power transformer supplies a load 8 kW of power at a power factor of 0.77 lagging at full…

Q: t Q8 Q3 IREF= 200 μA Q₁ VDD=+0.9 V C) Find the first stage gain (A1). Qs Vss=-0.9 V l₂ Q₁ ов 26 150₁…

Q: Find the fault current in both generators and in the motor for a three-phase mid-line fault. Find…

Q: Problem 11 A short-shunt compound generator supplies 80 A at 200 V. If the field resistance, Rf =…

Q: Consider a Frequency Division Multiplexing (FDM) system designed to transmit signals from multiple…

A: Frequency division multiplexing (FDM) system.It is designed to transmit signals from multiple…

Q: The effective value of Va, Vb, Vc in the given system is 220, Ly=350 mH and Ry=35 Ohm. It has been…

A: The above question is based on a 3-phase half-wave controlled rectifier with a freewheeling diode…

Q: To forward bias a silicon diode with a -71.6 V anode voltage, apply a cathode voltage. +72.3 V…

A: given here anode voltage of a diode and asked to find the cathode voltage of the diode.

Q: In the given system; Va, Vb, Vc effective value is 220V, Ly=300 mH and Ry=22 Ohms. It was observed…

A: Given data:RMS value of Supply voltage Vs=220VThree-phase half-bridge rectifierRY = 22 OhmsLy = 0.3…

Q: Input K and output Q of a falling edge triggered J-K Flip-Flop are plotted in the graph.…

A: to find the possible input of J in JK flipflop for the obtained output.

Q: In the series RLC circuit shown in Fig 2.1 below, find the current i(t) _t=0 Vin=20 V с 10 uF i(t)…

Q: The three-phase power line given in the figure is fed from both ends. The rated voltage is 380 V.…

A: The above question is based on the DC distribution system.Conductivity = 56 mho/mm = 56 mho/mHence,…

Q: A perfectly conducting wire containing a small 500-9 resistor is formed into a square, as…

Q: Find the 2rd harmonic of the signal whose spectrum is given belo -j2 -j3 j4 -225 -200 -100 -50 a. 8…

A: The two sided spectrum isWe need to determine the 2nd harmonic of the signal.

Q: Consider the energy gap of a silicon-based semiconductor at 0°K to be 1.21 eV and the material…

Q: CIK J K

A: The given problem is from digital electronics of flip flop. The detailed solution is given in the…

Q: Using the sine PWM method with the full bridge inverter below, it is desired to generate a voltage…

A: Frequency (f) = 50 HzInput voltage (Vdc) = 120 VAmplitude modulation rate (m) = 0.9Frequency…

Q: -1. V₁ + tr Μ 2Ω 4Ω Μ V₂

Q: Two resistors 2.50 and 1.20 are connected in parallel and take a total current of 60A. Find the…

A: It is given that:For Series circuit equivalent resistance isFor parallel circuit equivalent…

Q: The switch in the circuit shown has been closed for a long time before it is opened at t = 0. 6 V R₁…

A: As for DC source the inductor behaves as a short circuit and the capacitor behaves as an open…

Q: j0.8 Z12 is: Select one: O a. j0.48 O b. None of these O c. j0.8 O d. j0.6 ● e. j0.32 Clear my…

A: The given figure is shown below.We need to determine and .

Q: Vo Identify the correct transfer function H(s) = V of the circuit shown in the figure. V₁ V₁ 10 C R…

Q: Problem: Design a bandpass filter to pass frequencies between 250 Hz and 3,000 Hz and 20 kn. Plot…

A: Given Data:A filter with,Lower cut-off frequency Upper cut-off frequency Resistor To Find:Bandpass…

Q: ii. G(s) = 29 s²+6s+58 a) Find the location of the poles, natural frequency and damping ratio…

A: "Since you have posted a question with multiple sub parts, we will provide the solution only to the…

Q: Q7. Two stages of amplifiers are cascaded as shown. Find the total voltage gain! 2ΚΩ 600Ω 1kΩ my…

Q: , The Switch Figure has been closed for The Switch opens for + = 0+ 14 110 in the circuit shown in M…

Q: Given R1 = 2.1 ohms, R2 = 6 ohms and R3 = 3.8 ohms in a wye connection, what is the value of Rb (in…

Q: V₂₁₂ V/₂ R₂ www R₁ ww R₂ A₂ 5V R₂ R₂ www R₂ -V₂₂

Q: The following Design an analog Butterworth filter with properties. Find the transfer function. Ap =…

A: Analog Butterworth filterIt is designed to process continuous analog signals. It is known for its…

Q: 3 An alternating voltage is given by v= 75 (sin_200nt - 0.25) volts. Find: (a) The amplitude (b) The…

A: Voltage is given as,

Q: 1. If maximum value of current is 5√2 A, what will be the value of RMS current?

A: It is given that:

Q: iii. G(s) = 522 $3+24s²+166s+1044 a) Find the location of the poles, natural frequency and damping…

Q: The onalog Butlerworth Family, which has the following Characteristics design2 Find the transfer…

A: Given Data:Passband attenuation Stopband attenuation Passband frequency Stopband frequency To…

Q: Problem 4.38 Given the electric field 18 E R (V/m) R² find the electric potential of point A with…

A: It is given that:

Q: a question by considering the annual load time curve for an electric station as a straight line from…

A: Total capacity of Substation is the sum of power rating of each plant connected to that Substation…

Q: Solve Part a,b,c with explaination

A: Two voltage sources with different voltages should not be connected in parallel because they will…

Q: In order to improve the power factor for a single phase load P, where PFold= 0.4, PF new 0.90, (Vnew…

A: Note: Since you have posted multiple questions, we will provide the solution only to the first…

Q: Derive the transfer function of the following Inverting Op-amp: R₂ = 220 ΚΩ C₂ = 0.1 μF MHE || C₁ =…

A: Given:An inverting op-amp circuit, To do:we have to derive the transfer function of the circuit.

Q: Q4. Use a Karnaugh map to minimize the following standard SOP expression: (15 M) ABC + ABC + ABC +…

A: Step-1->

Q: Laplace ar

A: We need to prove Laplace transform is linear and Laplace transform of f(t)=1

Q: 2. Convert Varibles in the Coordinate system as follows: a) Point A (3, 2, -7) in the cylindrical…

A: As mentioned in the question, we have to solve only only part a. Given:Rectangular coordinate, (3,…

Q: 1. Find the average value of current when the curren that are equidistant are 4A, 5A and 6A.

A: It is given that:

Q: In the circuit given below, Ra=Rb=Rc=21 ohm loads are fed with an AC voltage with a fundamental…

A: For the given circuit diagram,

Q: determine the pole and zero of this

A: In this questionWe need to determine the zeros and poles of the X(z).

Q: The switch in the circuit shown in figure has been closed for a long time before it is opened at t =…

Q: Q1-A cable composed of 2mm diameter conductor covered with 1mm insulating material is found to have…

A: Resistance is given by,Given:Diameter (First conductor)=2 mmr1=radius of first conductor=1…

Q: C.13 Indicate whether the following statements are correct or not then correct the incorrect…

A: Explanation for all the statements are provided below.

Q: An FM signal is represented by the following: S(t)=10 Cos(2xx 106t+5 Sin2x10³t). Calculate: (i)…

A: Given:FM signal equation, To find:i) Carrier frequency, ii) Message frequency, iii) Modulation…

Q: Q7: Answer the following sentences with True or False only: 1. A three-phase PWM inverter feeding a…

A: Types of ConverterAC AC ConverterAC DC ConverterDC AC ConverterDC DC Converter

Q: 2.3 a Determine the flux density if the total flux in a core is 500mWb and the area of the core is…

A: Flux is given Area of core

Q: If you measure 10 V across a diode, it is probably O forward biased O in heavy conduction O reverse…

A: Measuring 10 volts across diode, it is probably in which bias?

Concept explainers

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.

Question

What is the current passing through on 1202 resistor as
shown in the given circuit in units of A?
20
-W
3Q
W-
6Q
W
12 Q
www
48 V
60
W
60
LW
8Q
ww

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given,

VIEW

Step 2: Calculation of total current,

VIEW

Step 3: Calculation of current in 12 ohm resistor,

VIEW

Solution

VIEW

Step by step

Solved in 4 steps with 6 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Single Phase and Three Phase System

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

You are an electrician on the job. The electrical blueprint shows that eight 500-W lamps are to be installed on the same circuit. The circuit voltage is 277 V and is protected by a 20-A circuit breaker. A continuous-use circuit can be loaded to only 80% of its rating. Is a 20-A circuit large enough to carry this load?
A circuit contains a 1000- and a 300- resistor connected in series with each other. The total circuit resistance must be reduced to a value of 1150 . Using standard resistance values of 5% resistors discussed in Unit 5, explain how to change the present resistance value to the value desired.
Given the voltage source of 12V,R1=9 ohms and voltage across R2 is 1/4 of the voltage source. Find the value of current and R2.
Find the total resistance if R1 = 200 ohms and R2 = 200 and R3 = 800 ohms are all connected in series.
Solve the unknows and answer this QUESTION: -Explain briefly why is the source (total) voltage almost the same as the voltage across the resistance? Given: R = 80 ohms L = 300 ohms C = 240 ohms
Two resistance are R1=10 ohm, tolerence5% R2=15 ohm, tolerance is 3% Determine the result along with tolerance if they are connected in parallel
Determine the current through, the voltage across, and the power dissipated by each resistor. (please use Kirchoff's Rule)
What is the required input voltage (volts) for a wheatstone bridge to produce an output voltage of 50 mV? The value of the resistors (ohm) are as follows: R1=118, R2=139, R3=126, and R4=135.
IF THE VOLTAGE AT RESISTOR RX IS 12V, WHAT IS THE TOTAL CURRENT AND THE VOLTAGES AT THE 5KOHM AND 10KOHM RESISTORS AND THE VALUE OF RX IN OHMS I T= VOLTAGE 5kΩ= VOLTAGE 10kΩ= RESISTANCE ON RX=
Determine the Thevenin resistance of the following circuit knowing that R1 = 1000 Ohms, R2 = 470 Ohms, R3 = 560 Ohms, R4 = 100 ohms, and R5 = 100 Ohms
Calculate the current through the 80-ohm load resistor RL. The source voltage is 80 volts. The resistances are all in ohms. If the resistance are in ohms, what is the current through RL?
You have to replace 1500 ohms resistor in radio. You have three of 1000 ohms resistors. How will you connect the three? Show in figures.