the induced voltage is the rate of change in the magneticfield with respect to time. A rapid change in the flux induces a high voltage. Similarly, a slowchange in the flux produces a low induced voltage.What HaveI Learned So Far?1. What is the effect of increasing the number of loops to the magnitude of the inducedEMF?2. What will happen to the magnitude of the induced EMF if the number of loops will bedecreased?3. How does making the magnetic flux faster affect the magnitude of the induced EMF?How about when make the magnetic flux slower?youMathematically, Faraday's law is stated as follows:ДФEMF = NAAtf loons of the

What is the effect of increasing the number of loops to the magnitude of the induced EMF? What will happen to the magnitude of the induced EMF if the number of loops will be decreased? How does making the magnetic flux faster affect the magnitude of the induced EMF? How about when you make the magnetic flux slower?

What is the effect of increasing the number of loops to the magnitude of the induced EMF? What will happen to the magnitude of the induced EMF if the number of loops will be decreased? How does making the magnetic flux faster affect the magnitude of the induced EMF? How about when you make the magnetic flux slower?

Inquiry into Physics

8th Edition

ISBN:9781337515863

Author:Ostdiek

Publisher:Ostdiek

Chapter8: Electromagnetism And Em Waves

Section: Chapter Questions

Problem 3Q: (Indicates a review question, which means it requires only a basic understanding of the material to...

See similar textbooks

Similar questions

(Indicates a review question, which means it requires only a basic understanding of the material to answer. Questions without this designation typically require integrating or extending the concepts presented thus far.) What happens to a ferromagnetic material when it is placed in a magnetic field?
Is the direction of the magnetic field shown in Figure 24.6 (a) consistent with the right—hand rule for current (RHR-2) in the direction shown in the figure?
A 9-turn generator coil with area 0.160 m2 rotates in a 1.30 T magnetic ﬁeld. At what frequency should the coil rotate to produce a peak emf of 135, as expressed using three significant figures? Can you help me conceptually how the answer is derived better.
The 17.0 cm long rod in the figure below moves at 4.00 m/s. What is the strength (in T) of the magnetic field if a 8.90 V emf is induced?
Considerable scientific work is currently under way todetermine whether weak oscillating magnetic fields suchas those found near outdoor electric power lines can affecthuman health. One study indicated that a magnetic field ofmagnitude 1.0 x 10-3 T, oscillating at 60. Hz, might stimulatered blood cells to become cancerous. If the diameter of a redblood cell is 8.0 µm, determine the maximum emf that can begenerated around the perimeter of the cell.
How can we calculate the motional emf of a conductor moving in a magneticfield?
Given a toroid with 150 loops and aradius of 24 cm, find the B-fieldinside if the current through thewires is 4 Amps.
What is self-induction? What happens to the work required to establish a magnetic field in a solenoid?
A 10 millimeter long wire is conducting a DC curent - 20 A. Located within the same plane as the wire, a neodymium bar magnet is rotating very close to the wire, resulting in a uniform field 1.25 Tesla. If the resulting magnetic field covers the wire uniformly: Show the equation used for determining the magnitude and direction of the resulting force Calculate the minimum and maximum force applied to the wire. What direction does the force point to during a full rotation of the PM? Hint: Ignore the dynamics of the rotation. Consider your answers for four representative points during the magnet's full rotation
A velocity selector in a mass spectrometer, like the one shown below, uses a 0.133 T magnetic field.a. What electric field strength is needed to select a speed of 4.93*10^6 m/s?b. What is the voltage between the plates if they are separated by 1.00 cm?
An alternator is an AC generator, so from there, we are given a car alternator which produces about 14 V peak output to charge the car's 12-V battery. If an alternator coil is 17 cm in diameter is spinning at 1200 revolutions per minute in a 0.19T magnetic field, how many turns must it have to produced a 14V peak output? I am unfamiliar with the derivations, so need someoone who can help me with understandig symbology to the values better.
Let’s Check 11 In this activity, please write TRUE if the statement is true and write FALSE if the statement is false. This is to check your understanding of the concepts. _________1.The voltage will be induced in a stationary magnetic field. _________2. The maximum magnetic flux is found when the area is perpendicular to the magnetic field. _________3. The direction of the induced voltage will depend on the direction of the magnetic flux. _________4. Generators is an application of induced voltage. _________5. The voltage is induced when the changing magnetic flux enters the loop of wire. _________6. The generator rotates to produce a fast rate of change of the magnetic fields. _________7. The Faraday’s law tells the presence of induced voltage in a loop while Lenz’s Law tells the direction of induced voltage in the loop. _________8. In the generator, the mechanical energy turns the coil relative to the magnetic field order to induce the voltage. ________9. The Lenz’s…