What is the external source's contribution to the movement of a single positivecharge in an electric field?Flux densityOPotential differenceDipoleMoment

Flux density is the amount of flux which is passing through a given area The voltage difference…

Answered: What is the external source's…

What is the external source's contribution to the movement of a single posit charge in an electric field? Flux density OPotential difference Dipole Moment

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter3: Magnetic Starters

Section: Chapter Questions

Problem 30SQ

See similar textbooks

Related questions

Q: a) Write all the rules to draw root-locus for a system then, locate poles and z on S-plane (draw to…

A: Root locus is a graphical method to find the range of gain by which we can determine the stability…

Q: 2. A 500-V, 50-kVA, 1-0 alternator has an effective resistance of 0.2 Q. A field current of 10 A…

A: The alternator basic problem can be solved easily by calculating Xs from short circuit test and open…

Q: a-

Q: Consider the choices.(w1)

Q: Construct JK flip-flop circuit diagram using D flip-flop and explain the characteristic table.

Q: Q2/ Draw the following data formats for the bit stream [1 10011 0] (i) (ii) (iii) (iv) Polar NRZ…

Q: 4. bus throughput Consider a serial bus (1 bit wide) that runs at 2GHZ, using alternate cycles for…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Consider a continuous-time ideal highpass filter S whose frequency response is So, l삐 20 When a…

A: Consider a continuous-time ideal highpass filter S whose frequency response is: H(jω)=0ω≤201ω>20…

Q: What is the significance of a negative indication on a wattmeter? Explain in 3 to 5 sentences

A: Wattmer Connection:

Q: Find V, for the circuit given below. 10K 100K 20K goVee 10 V 30K b-Vcc O6 V 20K 12 V 40K

Q: Vse ä de lta modulatin To Convert the following Signd Sin (2TT=2000¢)

A: The block diagram/schematic for converting the given analog signal into a digital signal using delta…

Q: +Vcc Vin V, Vo Vref Vy -Vcc Ry Rxl Fig. A2c: Inverting Schmitt-trigger circuit.

Q: what amp fuse do i need in 1w led light

A: A one watt LED usually draws 0.3 Ampere as voltage rating of LED is 3.3 volts.

Q: Q.3. Consider the Bode magnitude plot shown in the figure below. The transfer function H(s) is 20…

A: We need to select correct option for given bode plot .

Q: IS 15. The electrolysis of water produces A. gaseous water B. H2 and O2 gases C. electrically…

A: Electricity is used for electrolysis Electricity is passed through the water Then water is…

Q: Fill in the blank In modulation and demodulation technology, the low-frequency signal controlling…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: A 3Ø, 2000KW, 480V ∆-connected alternator is short-circuited and is operated at rated speed to…

A: An alternator is a type of electrical generator that transforms mechanical energy into electrical…

Q: The dc armature resistance of delta-connected alternator measured across its two terminal is 0.8…

Q: In an A.C. circuit, the current is given by i =100 sin 200xt amperes. The time taken by the current…

A: In this question we need to find a time taken by current to reach its peak value.

Q: If Rx=80 KQ, find the value of Vo. How large Rx be to avoid saturation if the maximum output is 10…

Q: What the effect from changing the value of L in RL circuit.؟

Q: ? Electric charges in motion constitutes a Surface current density O Current sheet O Current O…

A: In this question we need to choose a correct option

Q: (B)Using the Fourier Transform, integral, pairs and properties, evaluate: f(t)=cos(24t).sin(64t

Q: RESIS FANCE Stれ」E CompurE 10.TAL AND VO LTAGE IN 14nr [-1A 23 k 28 KA 12 v

Q: Which of the following statements is true about a Moore sequential machine? A. The outputs of a…

A: In this question we need to choose a correct option

Q: use both IEC and NEMA symbols. - Conductors crossing but not connected - Conductors crossing and…

Q: QI: Check the following statements and see which one is true and which one is false Without any…

A: Solution

Q: c) arrangement of all amplifiers in a cascaded form to produce the minimum total noise factor at the…

Q: A 20 ohm resistance R and a 0.001 farad capacitance Care in series. A direct current voltage E of…

A: In this question we need to find a resulting current i(t) at 10.01 sec for the given series RC…

Q: The displacement vector is D= 6 âz+ 8 ây+ 8 â, in the region y>5 with the dielectric constant e = 7.…

Q: Function generator is a versatile instrument that delivers a choice of different waveforms whose…

A: These are few true or false type questions related to the basic understanding of measuring…

Q: 5 Which circuit below contains the greates O A circuit with a current of 25 amps and a resistance of…

A: We need to select correct option for voltage

Q: 4. A delta connected balanced load is connected to a 3 - phase, 400 V supply. The line current is 35…

Q: a) Write all the rules to draw root-locus for a system then, locate poles and z on S-plane (draw to…

A: Root locus is a graphical approach to find the stability of a system using OLTF It is the locus of…

Q: Q5: Consider the plant S-2 G(s) = %3D (s + 3)(s2 + 2s + 17) 1. Sketch the approximate Bode plot for…

Q: A delta connected balanced load is connected to a 3 – phase, 400 V supply. The line current is 35…

Q: Comment on the curves obtained.

A: On the basis of torque ,speed and armature current we draw different characteristics of motor by…

Q: 23. Given the electrochemical reaction shown, what is the standard free energy change AGº if E° =…

A: Given, E0=+1.61 V To find-Standard free energy change ∆G0

Q: 1. A 30-kVA, 440-V. 50-Hz, 3-0, star-connected synchronous generator gave the following test data :…

A: Power: P=30 kVA Voltage, V=440 V Frequency, f= 50 Hz Table will be, Field Current 2 4 6 7 8 10 12…

Q: a) Define following terms: - Control system N, Z, P, gain margin, and phase margin b) Write the…

A: a) In Nyquist plot, A closed Contour is configured in clockwise. A plot is drawn for 0+ <ω<∞,…

Q: Lab report: Series VS Parallel Circuits Which circuit? Look at the 2 circuits below. I a. In which…

A: NOTE :- As per our company policy, only FIRST 3 sub-parts of a Question can be answered at a time,…

Q: If vị is 6V, v, =? 40 k. Oa 어 20 k2

Q: tal Medulation two modulation schemes would you select? Why? Show computations: • Binary coherent…

A: Bit Error Rate: The amount of bit errors per unit time is known as the bit error rate (BER). The…

Q: Two coils have self inductance of 5H and 1H, the mutual inductance being zero. If the two coils are…

Q: Table Q2(c) shows the specification of three (3) amplifiers. Suggest the arrangement of all…

Q: A differential amplifier has a common-mode gain (Ac) of 0.2 and a common-mode rejection ratio (CMRR)…

A: In this question, We need to determine the output voltage be if the single-ended input voltage was…

Q: Q5/ The bit sequence [1 01 11 01011] is to be transmitted using following formulas: (i) (ii) (iii)…

Q: a) Define the function of each opamp given below. b) Calculate V-

A: The operational amplifier is designed as a summing amplifier. The output is the sum of response of…

Q: Hws find the powed supply in the Rir cuit in fig. 2Jv wYe1 Je wye 2l

Q: 17. In the standard notation for a voltaic cell, the double vertical line represents? A. a phase…

A: Voltaic cell based on Electromagnetic chemical reactions Electric current through voltaic cell…

Question

What is the external source's contribution to the movement of a single positive
charge in an electric field?
Flux density
OPotential difference
Dipole
Moment

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

23/ The amount of Capacitance is affected by the ability of the Dielectric to support _____. A. ELECTRODYNAMIC FORCES B. POTENTIAL GRADIENTS C. ELECTROMAGNETIC FIELDS D. ELECTROSTATIC FORCES
Induced voltage acts like a resistance to hinder the flow of current through an inductor. True or False It is often more desieable to the conductor instead of the magnetic field. True or False
Determine the generated voltage for simplex Lap winding with 4 coil per slot each containing 8 turns given the following specifications No. slots = 123 slots P = 8 poles N = 600 RPM FLUX = 400, 000 Maxwell
Amagnetic field is being generated by a current of 2.0A flowing through 180 turns of wire on a core having a reluctance of 210000.0 At/Wb. Determine the flux of the circuit in mWb.
H.) When one coil of a magnetically coupled pair has a current of 5 A, the resulting fluxes φ11 and φ12 are 0.40 mWb and 0.80 mWb, respectively. If the number of turns N1 and N2 are 500 and 1500, respectively, what is the self-inductance L2? a. 560 mH b. 1080 mH c. 540 mH d. 1060 mH
If a time-varying magnetic flux is applied perpendicularly on a filament wire loop that includes a capacitor. Calculate the capacitor current by two different methods if the generated electromotive force is V. cos(cot) V. Draw the capacitor and its loop.
Electromagnetics-Electric Fields due to continuous charge distributionsNote:this problem also needs a drawing in relation to the problemPlease show full and clean drawing and solution thank you.
When one coil of a magnetically coupled pair has a current of 5 A, the resulting fluxes 11 and 12 are 0.40 mWb and 0.80 mWb, respectively. If the number of turns N1 and N2 are 500 and 1500, respectively, what is the self-inductance L2? a. 560 mH b. 1080 mH c. 540 mH d. 1060 mH
An inductance of 2 Henries and a resistance of 20 ohms is connected in series with an emf of E volts. If the current is zero at time t = 0, find the current at the end of 0.01 sec if (a) E = 100V and (b) 100 sin 150t V.
Define the term Capacitance and Inductance? Capacitance: It is the amount of charge that is stored inside a capacitor at a given voltage. Inductance: It is defined as the property of a coil to resist any changes in electric current flowing through it. Mutual inductance happens when a secondary coil opposes current change in the primary coil. Mention what is the difference between generator and alternator? Both generator and alternator work on the same principle they convert mechanical energy into electrical energy. Generator: It converts induced emf (Electro Motive Force) into direct current, where it based on stationary magnetic field and revolving conductor which rolls on the armatures with slip rings and brushes riding against each other. Alternator: It has rotating magnetic and stationary armature for high voltage and stationary magnetic field and a rotating armature for low voltage
A magnetic coil produces 100,000 maxwells with 2,000 turns and with a current of 2amperes. The current is cut off and flux collapses in 10ms. Determine the voltage acrossthe coil. Ans. 200V
Determine the emf inducted in a coil that rotates its 1250 r/min. The coil has 60 windings and a length and width of 0.7 and 0.6 respectively. The pole shoe has an area and area of 0.4 meters squared and it moves through a magnetic flux of 36 mWb