What is the importance of compensator in control systems?
Q: 1 The force of an electrostatic field f (x, y, z) has the direction of the gradient of f. Find Vf an...
A: Given 1. f = (x-1)2- (y+1)2, P(4,-3) Find gradient of f and find its value at point P(4,-3). 2. Fi...
Q: Given an analog signal x(t)=10 cos(2π.5500t)+5 cos(2π.7500t) is sampled at a rate of 8,000 Hz, ...
A:
Q: Question-4: Design a Negative-Positive biased clipper circuit that limits the positive output cycle ...
A:
Q: Calculate the area of the surface using the differential surface a r = 10, a/4 < o < 2a/3, 0 < ¢ < 2...
A:
Q: Apply the initial- and final-value theorems to each transform pair in Problem 12.40.
A:
Q: 4. Refer to the figure below. Find the net electrie field at point S. 1.19 nc 50 cm 3.45 nC 50 cm 50...
A: This question belongs to electro magnetic field theory . It is about calculation of electric field a...
Q: A semiconductor is a material that has _____ energy band gap. a)no b)wide c)narrow d)nuclear
A: Energy band gap is the difference in the energy between the conduction band and the valance band. A ...
Q: An inductive coil takes a current of 2 A and consumes 160 W when connected to a 240 V AC supply. A s...
A:
Q: For the system described by y (t) = #(t) cos(t) + 5 %3D where x(t) is the input and y(t) is the outp...
A:
Q: (b) The switch in the DC circuit of Figure 2(b) has been in position a for a long time. At time t = ...
A: Brief description: Transient analysis is only applicable for those networks where network consists ...
Q: What is PLC?
A: It is a Programmable Logic Controller used in industries to monitor the operations in the industries...
Q: 3. Refer to the graphics appendix. What current is most near the current through R1? .200 A .046 A ....
A:
Q: The voltage is 20 V, and the capacitors are identical with capacitances of 15 uF. In your solution s...
A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for y...
Q: 1. Find the total Capacitance in the circuit.
A: If the capacitors are connected in parallel then we can add it or if the capacitors are connected in...
Q: Region 1 (y 0) contains dielectric medium with ɛ2
A: Region 1 (y<0) contains the dielectric medium with ε1=5ε0 and μ1=1.5μ0. While region 2 (y>0) c...
Q: R1 3 R2 R3 10 V1 10 V2
A: The given circuit diagram is shown below:
Q: 2. A small island community in the Northern part of our country does not have electricity. However, ...
A: Resources of energy Coal for thermal power plant Wind speed for wind energy Kinetic energy of water...
Q: Using the following information; H =- (cos az - cos a,) a, 4m p a, = a, x a, Find magnetic field int...
A: "According to the Company's policy we will solve only the first part of the question as the second p...
Q: 2. Refer to the graphics appendix. What current is most near the current through R2? .200 A .046 A ....
A:
Q: A coil is supplied from a 200 volt and takes a current of 2 amperes at 0.707 power factor agging. Th...
A: Quality factor =WL/ resistance = inductive reactance/ resistance. From given vo...
Q: Q4/ Use Source Conversion technique to find the load current IL in the circuit below. IL R1 R2 R3 V1...
A: The given circuit is shown below: The 12 volts voltage source with the series resistance of 6 Ohms...
Q: A single phase circuit is supplied from a 220 volts 60 Hz source draws 2000 watts of power and 10 am...
A: Power drawn by single phase circuit = voltage ×current ×power factor. Given power drawn from the so...
Q: In a step-down converter, consider all components to be ideal. Let v, V, be held constant at 5 by co...
A:
Q: 4. Use the circuit shown in Figure P4.4 to find the indicated quantities. a) Find the power delivere...
A:
Q: Problem 2 A capacitor is used to correct the power factor of the load of the following figure. Deter...
A: Capacitance value not given It might be 50 Hz or 60 Hz So taking both the cases... It is a simple s...
Q: 9. An electric field of 3.6 x 10° N/C passes through an area of 4.1 cm? perpendicular to the surface...
A: In this question, If electric field is 3.6× 10-3 N/C Area = 4.1cm2 Find the electric flux =?
Q: A hydroelectric power station is supplied from a reservoir having an area of 50 km2 and a head of 5...
A: Here, we have provided some information about the hydroelectric power station, The area, head and t...
Q: Two impedance coils A and B are connected in series to a 111-volt ac source. Coil A has a resistance...
A:
Q: 3.63 Use nodal analysis to determine the node voltages defined in the circuit in Fig. P3.63. Vs ЗА 0...
A:
Q: Which statement is wrong ? High load factor of a generating equipment Ogives more profit to owner le...
A: LOAD FACTOR :- The Load Factor is defined as a ratio of the average load ...
Q: Question 4b Magnetic fields are characterized by the existence of a detectable magnetic force at eve...
A: According to the question, we need to discuss one of the industrial applications of the magnet.
Q: A person draws 3 balls in succession from a box containing 5 red balls, 6 yellow balls and 7 green b...
A: The solution is given below
Q: 25. In the circuit of Figure P27.25, the switch S has been open for a long time. It is then suddenly...
A: Brief description: In the above given question they have mentioned an electrical circuit which cons...
Q: A series circuit conducting of a 30-uf capacitor and a 0.155-henry inductor is connected to a 120-vo...
A:
Q: A pacemaker has an RC circuit that control the time of voltage giving out. A suitable time constant...
A:
Q: Q2/ Calculate the effective resistance of the following combination of resistances (Req) and the vol...
A: Effective Resistance Effective resistance in series is equal to the sum of the resistance. The recip...
Q: A coil that is wound around an iron bar with 5 m length, and are of 2.5 m2, creates a field intensit...
A: From given reluctance calculate permeability and relative permeability. Mmf = H × mean length of th...
Q: IS it a requirement to have a light ixture outside the garage door for a vehicle? O No Yes For two c...
A:
Q: 5. For the given circuit below, determine (a) the voltage across each capacitor and (b) the energy s...
A: Here, we have given an electrical circuit having, no. of capacitor connected in series and parallel ...
Q: Power generation cost reduces as diversity factor decreases and load factor increases diversity fact...
A:
Q: Problem 2: Thermal Units with Linear Cost functions (Linear Programming) Given two ONLINE thermal un...
A: The thermal units are given below,For Unit1-F1=500+5P1 300MW≤P1≤200MWFor Unit2-F2=300+3P1 20MW≤P...
Q: 30 Ω -j10 2 1202 40° V rms j10 2 10Ω Figure 3(b)
A: 10 Ω and j 10 Ω are in parallel. Their equivalent impedance will be 10 (j10)10 + j 10 = 5 + j 5 Ω Su...
Q: WDEL BT I = 30[mJ]e La; for t> 0. shown below where the energy is 12 A revolutionary new device call...
A:
Q: A boost converter has an input voltage Vb=5V. The average load current is lo=0.5A. The switching fre...
A: The ripple current in the inductor is ∆I = Vb(Vo-Vb)f L Vo ... (1) Where f is the switchi...
Q: 1. A 1Ø, 2 wire distribution line, 1280m long has an impedance per conductor per km of 1+j2.52. The ...
A:
Q: The ATM protocol has a CRC for the payload * True *False What is the payload data rate of an enco...
A: According to the question, The ATM protocol has a CRC for the payload * True *False What is the payl...
Q: If the electric field intensity in Region 1 is given as E1 = 35 a, + 25 ax- 15 a, V/m, calculate two...
A:
Q: 3. For the following problems there is no need to consider the position vector. Simply find the magn...
A: Note: It is mentioned in question answer 3 so i am answering 3rd question. (a) Given data, Point cha...
Q: Clippers and Clampers. Determine the output waveform for each circuit. Show your solutions.
A:
Q: Question-1: Consider the circuit in Figure below (Answer five only): 1. What the circuit type is? 2....
A:
What is the importance of compensator in control systems?
Step by step
Solved in 2 steps
- What is the importance of compensator in control systems? NOTE: EXPLAIN ONLY STRAIGHT TO THE POINT2. Discussed briefly the effects of the different types of compensators in control systems.Why transient response? What is the importance of the transient response of a control system? ples write in deatil
- Techniques used to calculate stability 2. Discussed briefly the effects of the different types of compensators in control systems.What is difference between Open-loop and Close-loop control system? give note on bothThe main advantage of two-position control systems is that it is simple and ______________.