What is the output frequency of a cascade counter with three stages [MOD-15, MOD-12, and MOD-8] if the input square wave frequency is 9 MHz

Q: In order to light a LED: O send a HIGH signal and this will be written in the Loop function send a…

A: In order to light a LED what we will do in a program : options : Send a HIGH signal and this will…

Q: Explain and if possible with graph. What happens to the oscillation when R4 is varied to a larger…

A: According to the question, we need to explain the effect on oscillation if R4 is varied to a larger…

Q: Construct MOD 12 asynchronous counter. What will be the output frequency, if the input frequency is…

A:

Q: For the given circuit, what is the minimum peak value of the output waveform if the input waveform…

A: Negative Clamper Circuit: A Negative Clamper circuit is one that moves the output signal to the…

Q: What is the noise figure when the input signal and the noise values are 200 and 20uW and the output…

A: Noise Figure is defined as the ratio of input SNR to the output SNR. The calculation is shown in the…

Q: What will be the output voltage of this opamp circuit?

A: The voltage Vb  will be :

Q: The choke of Figure has a d.c. resistance of 25. What is the d.c. voltage if the full-wave signal…

A: Given: Vin(peak)=25.7 volt RC=25 ohm RL=750 ohm

Q: What is the output when the input voltageisless than, greater than, andequaltothe refence voltage?

A: Assuming the given device to be an OPAMP comparator i.e.,

Q: Design the circuit of the following synchronous counter defined by the state transition diagram and…

A:

Q: The full-adder in the figure given below is tested under all input conditions with the input…

A: A full-adder block diagram can be split-up into two half adders as below.

Q: The most common technique to caneg analog to digital data is called Pulse Code Modulation(PCM). What…

A: The most common technique to caneg analog to digital data is called Pulse Code Modulation(PCM).…

Q: Explain and if possible with graph. What happens to the oscillation when R4 is varied to a larger…

A: According to the question, for the Wein bridge oscillator, we need to discuss the effect on the…

Q: Given: a) analyze and draw the output waveform of Vo. Vi = 15 V E = 8 V b) identify what type of…

A:

Q: It is connected to the input of a transistor (BJT) amplifier circuit with a gain of "-50" with a…

A: Given Vin = 100 mV P-P Gain Av = -50  Voltage gain is negative so it should be common emitter…

Q: Draw the necessary waveforms. Inverting op-amp Rr +10V Ri Vo Square Wave 3 741 Vi -10V GND

A: Given circuit is -

Q: Q1) What type of signal does the circuit in Figure produce? Determine the frequency of the output.…

A: The given circuit diagram is shown below:

Q: R1 R3 R5 R2 R4 R6 Vo Vin Determine the output peak voltage, Vo R1=18190 ohms, R3=18190 ohms,…

A: We need to find out output voltage for given circuit

Q: A discrete-time signal x[n] is shown as in Figure 1; Figure 1 Plot and label carefully each of the…

A:

Q: Design the circuit of the following synchronous counter defined by the state transition diagram and…

A: In this question we need to design a synchronous counter. We use D flip flops to design a counter.

Q: Draw the v0 output signal according to the given input signal (R=160Ω)

A: The solution can be achieved as follows.

Q: . is tested under all input conditions with the input waveforms The full-adder in Figure shown. From…

A: The truth-table for the full adder shown in question is: A B Cin ∑ Cout 0 0 0 0 0 0 0 1 1 0…

Q: In a Sample and Hold circuit  a. one input is analog, another input is digital, output is a pulse…

A: In a sample and hold circuit   To answer proper option related to the sample and hold circuit

Q: Given the four statements, which of the following statements are true about an op-amp integrator?…

A: Given RC op-amp integrator Output voltage, Vo = (-1/RC) (integral of Vi)  1. When input is sine…

Q: Design and draw an electronic circuit that will produce the following output signal using only…

A: Clippers: Clipper is a circuit by using which we can clip part of a signal,we have positive end,…

Q: Determine V, Vs(pk), VL(pk), Vdc, PIV, and fout- Draw also the output waveform with the voltage…

A: Given Np = 6 turns Ns = 1 turn Fin = 54 Hz Vp =215 V

Q: 3) The input waveforms for a negative edge triggered D FF are shown below. Draw the waveform for Q.…

A: As per company guidelines, only 1st question will be solved, if the solution to any other question…

Q: Vdc please show the circuit in the figure as a Chaotic Oscillator. Show it using one of the…

A:

Q: What is the output signal voltage for a gain of 20 and input voltage of 30mV? O 600mV O 6V O 60mV O…

A:

Q: (3) A sinusoidal signal of frequency 200 Hz is sampled at a rate of 1200 samples per second. Draw…

A:

Q: For the output waveform shown, if the input peak voltage is 230V then find the output AC and DC…

A:

Q: Draw the AM waveform, if the modulating signal is a square pulse waveform:

A: Given:  Brief description: In the above question they want to know the amplitude modulation waveform…

Q: What is the value of peak overshoot in output of a second order system with unit step input in…

A: Given values are - Damping ratioζ=0.89Frequencyωn=4radsec Given system is second order system with…

Q: Plot the input/output characteristic of the circuit shown assuming a constant-voltage model. D1…

A: PLOT the input and output characteristic of the circuit shown assuming a constant voltage model

Q: 7(A) Design an op-amp waveform generating circuit to produce the waveform given in figure 10 below.…

A: Operation of this given waveform- This is an Op-amp based Square wave generator.   In this wave…

Q: In all of the circuits, the voltage of the Vin input signal is 200mVp and the frequency is 1KHz.…

A: Given circuit

Q: For the given circuit, what is the minimum peak value of the output waveform if the input waveform…

A:

Q: Q7: What is differentiator? For the circuit shown in figure below if input voltage vị = 3t V ,…

A:

Q: 4. The following Data input and data select waveforms are applied to a Multiplexer. Determine the…

A:

Q: The given waveforms are inputs to a two inputs Multiplexer. Determine the output.

A: Given  2 inputs and one selection line of 2:1 multiplexer  Need to find output of mux .

Q: Given Vi = 20V peak-to-peak, draw the output waveform for the said clamper circuit below:

A:

Q: Q7/ Draw the output waveform of the differentiator whose R=1MN, and C=100µf for the input waveform…

A: Output waveform of the Differentiator  Vo=-RC dVi /dt The given waveform is square with 20u Sec time…

Q: 10. Show that (9) A signal which maintains constant amplitude over fnfinite duoation is a pawer…

A: Power signal : A signal is said to be power signal , if it has finite value of power. Eg: All…

Q: w the output waveform for the circuit in figure E ax) = -10V.

A:

Q: In a counter based on the direct measurement of the period, the effect of the noise superimposed on…

A: So the correct option is using the attenuator.

Q: For the given circuit, what is the minimum peak value of the output waveform if the input waveform…

A: In this question we need to find a minimum peak value of output voltage

Q: Q3: Find the count sequence of the following digital circuit B A SA Q SB Q CLK FF FF A- BDL RA B…

A:

Q: What is the output peak voltage during the positive alternation of the input signal for the circuit…

A:

Q: Draw a Differentiator circuit with value of R = 1 KQ and C = 0.01 µF. If waveform shown in figure B1…

A:

Q: Draw output waveform of circuit . C 20 V Ideal R 5 V -20 V

A: The diode is ON when the voltage across anode is more than the cathode voltage. It is known as…

Graph theory

It is that part of network analysis where the configuration is called graph or structure of the network system when all of the elements (e.g., R, L, and C) in a network system are substituted with lines having circles/rings or dots across both endpoints. The study of the solution of the networks and circuits with the help of graphs is known as graph theory. The objective is to know the mathematics behind the network analysis.