Answered: what is the pressure (in pascals) at a…

what is the pressure (in pascals) at a depth of 1 m below the water surface? a) 11100 Pa b) 111100 Pa c) 110 Pa d) 1110 Pa

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter11: Fluid Statics

Section: Chapter Questions

Problem 56PE: What is the gauge pressure in millimeters of mercury inside a soap bubble 0.100 m in diameter?

See similar textbooks

Related questions

Q: 5. How much force is acting on the triangular plate submerged 3ft under water shown in the diagram…

A: i think you given wrong density value please do check. but still i solved question according to…

Q: Steve Rogers was found frozen 2.0 meters below sea level. How much pressure was exerted on his body…

Q: 4. Water flows through a pipe shown below at the rate of 30 liters per second. The absolute pressure…

A: Rate of water flow from A to B = 30 liter per second The absolute pressure at point A = 200 kPa…

Q: What fraction of a piece of lead will be submerged when it floats in mercury? The density of lead is…

Q: Water flows through a circular pipe with a constant radius of 10 cm. The speed and pressure at point…

Q: Calculate the pressure on the top lid of a chest buried under 4.25 meters of mud with density 1.75 x…

A: The pressure exerted on an object is calculated by using the formula P=hρ g , where h is the depth…

Q: у (ст) 100 - 75 - A 50 25

Q: Nail tips exert tremendous pressures when they are hit by hammers because they exert a large force…

A: The area of the circular tip of the nail is, A=πd24=3.141.65 mm10-3 m1 mm24=2.14×10-6 m2

Q: 4. Consider a pirate boat in a pond with the anchor on the boat. When the pirates throw the anchor…

A: We have a boat on which there is an anchor having mass say m, density ρ and volume V. This anchor is…

Q: A ball has a diameter of 3.70 cm and average density of 0.0837 g/cm3. What force is required to hold…

A: d=Diameter of ball=3.7 cmr=Radius=3.72=1.85 cmρb=Density of ball=0.0837 g/cm3=83.7 kg/m3ρw=Density…

Q: The pressure in a water tower is 23,472 Pascals (N/m2) higher than at an open faucet. The density of…

A: Pressure difference, ∆P=P1-P2=23472 Padensity of water= 1000 Kg/m3height difference,∆h=h1-h2=5.1 m

Q: A cube, with sides of 2m, is completely submerged in water. What is the buoyant force acting on the…

Q: hollow, plastic sphere is held below the surface of a freshwater lake by a cord anchored to the…

Q: (2) In the following Figure below, determine the gauge pressure at point A. Density of mercury =…

A: We know that the specific weight of water = 62.4 lb/ft3, The specific gravity of water is equal to…

Q: How much pressure do you experience when you balance a 0.63 kg basketball on the tip of your finger…

Q: The pressure in a water tower is 35,634 Pascals (N/m²) higher than at an open faucet. The density of…

A: Pressure difference (∆P) = 35634 Pascals density of water = 1000 kgm3∆h = 6.4 meters

Q: What is the pressure gradient in this narrower portion of the tube in kPa/m

Q: A juniper-wood plank measuring 0.46 ft by 1 ft by 17 ft is totally submerged in water. (a) What is…

A: a) The required weight is, b) The required buoyant force acting on it is,

Q: QUESTION 6 Which of the following is the correct expression for pressure ? m=mass, v=speed,…

Q: Nail tips exert tremendous pressures when they are hit by hammers because they exert a large force…

Q: Determine the absolute pressure exerted by the seawater in kPa on the body of the diver if he…

A: We have givenDiver descends to depth (h)=139.21 mDensity (ρ)=1029.326 kg/m3Barometric pressur…

Q: Vhat is the pressure on a horizontal surface with an area of 3 m that is 4 m underwater? Use 1000 kg…

Q: 8. Gauge pressure is the total pressure minus the atmospheric pressure or P - Po. The gauge…

Q: 6. A block of wood floats in fresh water with two-thirds of its volume V submerged. The dimensions…

Q: A submarine can dive to 300 m depth. Find the pressure at that depth in Pascal. Give the exact…

A: Pressure is rho*gh

Q: A category 4 hurricane comes on shore with wind speeds of approximately 61.8 m/s. Take the density…

Q: The container shown is filled with mercury. It is open to atmosphere on the left and closed on the…

A: density of mercury (d) = 13600kgm3Atmospheric pressure = 100 kPa g = 10 ms2

Q: QUESTION 4 An open-tube manometer is used to measure the pressure in an oxygen tank. when the…

A: Atmospheric pressure = 1040 milli bar = 1040×10-3×105 pascals = 104000 Pascals H = 20.4 cm = 0.204 m…

Q: A ball has a diameter of 3.70 cm and average density of 0.0837 g/cm3. What force is required to hold…

Q: The depth of water behind the Hoover dam is 393 m. The density of water is 1,000 kg/m³. What is the…

A: Given Depth h = 393 m Density = d = 1000 kg/m3 Acceleration due to gravity g = 9.8 m/s2

Q: A 38-cm-tall, 5.0-cm -diameter cylindrical beaker is filled to its brim with water.What is the…

Q: A ball has a diameter of 3.77 cm and average density of 0.0835 g/cm3. What force is required to hold…

A: Given information: Here, d is the ball’s diameter, ρball and ρwater are the density of the ball and…

Q: A friend can inhale to create a gauge pressure of -70 mm Hg (Hg density = 13.6 g / cm3). The height…

A: Since, the pressure are same then, p1gh1=p2gh2p1h1=p2h2

Q: A manometer using oil (density 0.9-- g/cm^3) as a fluid is connected to an air tank. Suddenly the…

A: Assume a manometer using oil as a fluid is connected to air tank. The density of the oil is ρoil =…

Q: What is the pressure inside a 8.0-um-diameter air bubble that is 10 m below the surface of a lake?…

A: Given: Diameter of the bubble, d=8μmd=8×10-6 m Radius of the bubble, r=d2r=8×10-6m2r=4×10-6m Surface…

Q: 7. Find the hydrostatic force on one side of the submerged plate shown below. Force Recall that…

A: Given density of water ρ = 1000 kg/m3 d = 5m we have to find out hydro-static force

Q: Determine the pressure at the bottom of a drum 0.50m deep and filled with water.

A: Solution: Given that deep h=0.5 m the filled liquid is water

Q: 7. Find the hydrostatic force on one side of the submerged plate shown below. Force Recall that…

Q: The container shown is filled with a mystery liquid with density 15,000 kg/m3. It is open to…

Q: The main water line enters a house on the first floor. The line has a gauge pressure of 1.90X10 5…

A: Given : Gauge pressure = 1.90 × 105 Pa Height h = 6.50 m

Q: What is the absolute pressure at the bottom of the container? ?Pa

Q: 4. Aninclined pipe 10 cm in radius has a smooth reduction to a pipe 5 cmin radius as shownin figure.…

Q: 19) A submarine dives to a depth of 52.5 meters in deep lake. (water density = 1030 kg/m3). What is…

A: Pressure at depth h in fluid of density ρ is, P=ρgh Here, g is acceleration due to gravity. Given…

Question

what is the pressure (in pascals) at a depth of 1 m below the water surface?

a) 11100 Pa

b) 111100 Pa

c) 110 Pa

d) 1110 Pa

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

What fraction of an iceberg floating in the ocean is above sea level? Assume the density of the iceberg is 917 kg/m3.
A table-tennis ball has a diameter of 3.80 cm and average density of 0.084 0 g/cm3. What force is required to hold it completely submerged under water?
A container is filled to a depth of 20.0 cm with water. On top of the water floats a 30.0-cm-thick layer of oil with specific gravity 0.700. What is the absolute pressure at the bottom of the container?
What is the gauge pressure in millimeters of mercury inside a soap bubble 0.100 m in diameter?
Gauge pressure in the fluid surrounding an infant's brain may rise as high as 85.0 mm Hg (5 to 12 mm Hg is normal), creating an outward force large enough to make the skull grow abnormally large. (a) Calculate this outward force in newtons on each side of an infant's skull if the effective area of each side is 70.0 cm2. (b) What is the net force acting on the skull?
Oil having a density of 930 kg/m3 floats on water. A rectangular block of wood 4.00 cm high and with a density of 960 kg/m3 floats partly in the oil and partly in the water. The oil completely covers the block. How far below the interface between the two liquids is the bottom of the block?
A tank with a flat bottom of area A and vertical sides is filled to a depth h with water. The pressure is P0 at the top surface. (a) What is the absolute pressure at the bottom of the tank? (b) Suppose an object of mass M and density less than the density of water is placed into the tank and floats. No water overflows. What is the resulting increase in pressure at the bottom of the tank?
Oil having a density of 930 kg/m3 floats on water. A rectangular block of wood 4.00 cm high and with a density of 960 kg/m3 floats partly in the oil and partly in the water. The oil completely covers the block. How far below the interface between the two liquids is the bottom of the block?
Explain why the fluid reaches equal levels on either side of a manometer if both sides are open to the atmosphere, even if the tubes are of different diameters.
Pascal’s Principle and Hydraulics 59. How much pressure is transmitted in the hydraulic system considered in Example 14.3? Express your answer in atmospheres.
Figure 11.35(a) shows the effect of tube radius on the height to which capillary action can raise a fluid. (a) Calculate the height h for water in a glass tube with a radius of 0.900 cm—a rather large tube like the one on the left. (b) What is the radius of the glass tube on the right if it raises water to 4.00 cm?
Calculate the Reynolds numbers for the flow of water through (a) a nozzle with a radius of 0.250 cm and (b) a garden hose with a radius of 0.900 cm, when the nozzle is attached to the hose. The flow rate through hose and nozzle is 0.500 us. Can the flow in either possibly be laminar?