What is the rated amps city per phase for six No. 3 THHN copper current-carrying conductors with two conductors per phase (parallel) and all conductors installed in the same conduit

Q: What will happen to the ammeter reading when switch S is closed? a) The reading will increase as…

A:

Q: A simple point-to-point microwave transmission link has no redundancy. Failure of the link will…

A: Very high-frequency radio or television signals are used by microwave devices to transport data over…

Q: For the system shown in Figure 1 find the range of values of k for which the system is stable by…

A:

Q: 56. An amplifier has an open loop voltage gain of 10%. With negative voltage feedback, the voltage…

A: Given: An amplifier has open loop voltage gain, Av=105 With negative voltage feedback, the voltage…

Q: Let x[n] = {x[0] = 1,0, 1, 2, 0, 2). Interpolate x[n] by a factor of 2. a) Use the filter h[n] =…

A:

Q: Discuss the significance  current limiting reactor in power system

A: A current limiting reactor consists of a large inductance compared to its ohmic resistance

Q: Ex. 3) a 3-phase, 50Hz generator running at 1500 rpm, the stator inside diameter is (0.5m) and its…

A: It is given that: F=50 Hzn=1500 rpmD=0.5 mL=1.2mBm=0.62T

Q: Q1. Using the concepts delivered in Maxwell's equation, develop an explanation of uniform plane wave…

A: All four equations of Maxwell in the phasor form are shown below:…

Q: If the primary line voltage rating is 3.3 kV (Y side) of a 25 KVA, Y-A transformer (the per phase…

A: Given: A Y-∆ transformer has, Line voltage rating at Y side, VL=3.3 kV Power rating, P = 25 kVA…

Q: V BB RB 10 ΚΩ VIB + V BE Ich Vcc= 10V = Rc = 1 kn ΚΩ VCE Fig

A: Given data : The given circuit is shown below,

Q: Design and construct/draw a low-pass Butterworth filter with a roll-off of rate of -60 dB/decade and…

A: Given: A 3rd order low-pass Butterworth filter whose cutoff frequency is 10 kHz. Required: Design of…

Q: osition b. ) -) Calculate Vo for t > 0+. What percentage of the initial energy stored in the…

A: Solution- from the above figure, Switch is at position a for t < 0, for the steady state at t =…

Q: 8-32. For copper waveguide walls (o = 58 MS/m), evaluate the wall-loss attenuation factor for the…

A: Attenuation : Attenuation means a loss in power signal due to disturbance, the waveform at output…

Q: A power station has a maximum demand of 2500 kW and number of kWh generated per year is 45 x 105.…

A: Given a power station with, Maximum demand = 2500 kW Number of kWh generated per year = 45×105

Q: What are the characteristics of an ideal operational amplifier?

A: The solution is provided in the following section.

Q: Name and explain the process to join any electrical component on strip board

A: A circuit board known as a "stripboard" has parallel strips of copper material along the length of…

Q: the resistance

A:

Q: 7- Define the term OFDM?

A: Given: OFDM

Q: Compute for the current flowing at Z2 using superposition and thevenins theorem. Answer must be in…

A: The superposition theorem states that, "A linear, bilateral network consists of more than one…

Q: Q2:- Determine the value of voltage (V1) in figure (2-31)by using voltage divider rule. 64 V- 20 Ω…

A: Given data, Vin=64V R1=20ohm R2=60ohm

Q: Solve the following questions regarding the BJT transistor circuit shown below What is lg in HA?…

A: Given, A BJT transistor

Q: A 10 Q2 resistor is connected in series to a parallel combination of a 60 resistor and a 20 resistor…

A: Given data, R1=10ohm R2=60ohm R3=20ohm V=220V

Q: A heater is required to give 1000 cal/min on a 200V dc circuit. What length of wire is required for…

A: Given, P=1000 cal/minV=200 VR=3 Ω/m

Q: What are the characteristics of an ideal operational amplifier?

A: In the following section, the characteristics of an ideal operational amplifier have been described.…

Q: 01:- electrical heater (500w) (250V) calculate the current will draw by the heater and its…

A:

Q: Introduction for a Wheatstone bridge Circuit and your understading

A: Wheat stone bridge: Wheatstone bridge is an electrical circuit which uses the resistances arranged…

Q: B- The height of a wind turbine is 32.13m. Find the wind speed in K/h needed to generate 4641.7Kw if…

A: Given: Generated power P=4641.7 KW Height of the wind turbine h=32.13 m Density of air…

Q: 1) The message signal m(t) as shown in the figure is phase modulated to generate the PM signal (t) =…

A: The instantaneous angular frequency will be obtained by differentiating the instantaneous phase as:…

Q: 1. Find and draw the Fourier Transform of the signal shown if figure below: f(t) -T coswot T

A: 1) To find and draw the Fourier transform of the signal f(t) = cos(wot)

Q: 1. Find the ammeter current in Fig. 2.57 by using loop analysis. 2V 10 ww ww 103

A: Given circuit,

Q: (5 minutes) A sine voltage signal is zero at t = 0.1s, and increasing to the succeeding zero at t =…

A: Given, Sine voltage signal with zero at t=0.1 s And increasing to the succeeding zero at t=0.3 s

Q: Calculate the form factor and peak factor of a triangular wave in which the voltage rises uniformly…

A: Form factor: It is the ratio of the RMS value and average value. It gives information about the…

Q: A platinum RTD PT100 measures 100 Q at 0 °C and 139.1 Q at 100 °C. Calculate temperature in °C if…

A:

Q: If A = 1001 1001 0000 0010, show the result of the arithmetic shift right operation in hex

A: Given, binary number is A = 1001 1001 0000 0010, The arithmetic shift right operation in hex= ?

Q: A transformer coupling is used in the final stage of a multistage amplifier. If the output impedance…

A: Given data, Speaker load (Ri)=10ohm Output Impedance on the secondary side (RL)=1000ohm

Q: Three charged particles are placed on the corners of an equilateral triangle of side 1.20 cm. The…

A: It is given that: d=1.20 cmQ1=+4μCQ2=-8μCQ3=-6μC

Q: Vo= 1 + 2R RR) (V₁ – V₂) = k(V₁ – V₂) Rp

A:

Q: Use minimum number of NAND gates only to represent the Boolean operation of an XOR gate.

A:

Q: Find the value of the v across 6H 120 cos co V 10 H sm OF -OV

A:

Q: P 12.7-5 A three-phase Y-connected source simultaneously supplies power to two separate balanced…

A:

Q: Sketch the root locus diagram for a unity feedback system G(s) = K(s+3)/s(s2+2s+2) (s+5)(s+9). Thus…

A:

Q: Q3 (a) Describe the rules how to construct (draw) the root locus if the angle of asymptote are +60°…

A:

Q: If the inertia constant H = 8 MJ/MVA for a 50 MVA generator, the stored energy is?

A: Given, Inertia constant, H = 8 MJMVA MVA rating, S = 50 MVA

Q: 1. a) What is the amplification ratio (expressed in dB) of a DC amplifier with input DC voltage of…

A: 1. a)  The amplification ratio is given by the expression as shown below: Av=VoutVinVout=10 VVin=100…

Q: electric current

A:

Q: round intermediate calculations. Round your answer to 2 decimal places.) y, the PCB machine produces…

A:

Q: When a load is applied to a three-phase squirrel cage induction motor, the rotor speed will…

A: If load on three phase induction motor is applied then the power demand is increases and if power…

Q: 2 -1 0¹ w(t) Figure Q1(b) 2

A:

Q: Calculate the Fourier Transform of the signal x(t) = cos(2*pi*t) + cos(5*pi*t) and draw the signal…

A: Given: xt=cos2πt+cos5πt Required: (1)Fourier Transform of the signal x(t).                 (2)draw…

Q: Find i, in the circuit in Fig. P5.3 if the op amp is ideal Figure P5.3 0.5 mA nobi ribos Va + Change…

A:

Methods of Wiring

Electrical wiring is the way of integrating cables and wires to interconnected equipment such as fuses, switches, sockets, lights, fans, and so on to the main distribution board, which is a specific structure attached to the utility pole that ensures a constant power supply.