Answered: What is the required bandwidth…

What is the required bandwidth according to the Carson's rule, when a 100 MHz carrier is modulated with a sinusoidal signal at 1KHz, the maximum frequency deviation being 50 KHz.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter14: Basic Trigonometry And Vectors

Section: Chapter Questions

Problem 1RQ: 1. Which trigonometric function is used to find the angle if the length of the hypotenuse and of the...

See similar textbooks

Related questions

Q: The effective armature resistance of a 3-phase, star connected, 500 kVA, 1100 V alternator is 0.1 £…

Q: Current source shown below is converted in to voltage source. Choose the correct voltage source…

A: Given data, Given circuit diagram is,

Q: Three capacitors 10 μµF, 20 µF, 30 uF are connected in series across 150V (sinusoidal). Then…

A: Given, Three capacitors are connected in series, C1=10 μFC2=20 μFC3=30 μF Supply voltage, Vs=150 V

Q: Design a second order LPF, with unity de gain, to realize the following natural modes P1,2 = 10¹…

Q: A numeric system (e.g. a numeric keypad) generates numbers 0 to 9 in binary. You are asked to design…

A: For the given problem the truth table must be derived and the same can be used for obtaining the…

Q: In a 66 KV system the phase is ground capacitance is 0.05 µF and inductance is 2H. The voltage (kV)…

A: Given a 66 kV system with, Capacitance, C=0.05 μF Inductance,k L=2 H Current that be interrupted,…

Q: In a two-wire distributor ABC, C passes a load of 120 A and B passes 60 A and both have a lagging…

Q: The amplifier in the figure below receives an input of 1 V DC. Calculate the output voltage, A. 100…

A: Given data, Input signal Vi=1 V Circuit diagram is given as,

Q: 25 MVA 13.8 kV generator with X"d=15% is connected through a transformer to a bus which supplies…

A: Fault currents that are symmetrical and asymmetrical. The system/synchronous machine's reactance is…

Q: A parallel circuit comprises of a resistor of 2002 in series with an inductive reactance 150 in one…

A: Given data, Impedance, Z1=20+j15 ΩZ2=30-j20 Ω Current, I=10∠-30° A=8.66-j5 A

Q: Design a microstrip line on a 0.5 mm alumina substrate (er = 9.9, tan o = 0.001) for a 50…

Q: How long does it take a 100 W bulb to consume 13 KJ of energy? [c]

A: Given data, Energy, E=13 KJ=13×103 J Power P = 100 W

Q: A potential difference of 100 volt exists between the ends of a conductor having length of 300 cm.…

A: We have a conductor having, Potential difference (V) = 100 V Length of conductor (l) = 300 cm = 3 m…

Q: cedb-e70a-017569bcae60/ecam kderi - Go OI Wallpaper Abyss-- Istanbul Online Ye. 8 am 1A MASTERCHEF…

A: Given- ε= 20 V L= 0.05 H R0 = 3 ohm R1 = 1 ohm R2 = 4 ohm R3 = 4 ohm R4 = 4 ohm R5 = 5 ohm R6 = 3…

Q: According to Carson's rule, Bandwidth B and modulating frequency fm are related

A: The correct option along with the explanation has been provided in the following section.

Q: (6) Find the Boolean expression for logic circuit shown in Fig.1 below and reduce it using Boolean…

A: We need to find logic expression of given circuit

Q: Calculate the maximum frequency deviation for the FM signal v(t) = 10 cos (6000t+ 5sin2200t)

A: Given information: The expression of the FM signal is vt=10cos6000t+5sin2200t The maximum frequency…

Q: In the circuit shown below, the maximum power transferred to the resistor R is 30 502 :5V 20 6 V 50…

A: Given circuit,

Q: A 2 MHz carrier signal is amplitude modulated (AM) by a high fidelity audio signal that has…

Q: 12. The speed of the rotating flux in Fig. 20.16 will be .......... (i) 1500 r.p.m. (iii) 750 r.p.m.…

A: Given data, Number of poles P=4 Frequency f=50 Hz Number of phase = 3

Q: Problem2 A source with a voltage of Vs = 5270° and an impedance of Z, = 50-j20 2 is connected to a…

A: Given, The source voltage VS=5∠70° The characteristic impedance of transmission line 1 Z01=50Ω The…

Q: Solve the linear ODE below using the Laplace transform technique: d²y dt² assume zero initial…

Q: Determine the z-transform of x(n): = n! for n20.

A: We have been asked to find z-transform of, x(n) = ann! for n ≥0 And we have been asked to find…

Q: A variable speed drive is reversing under no load. Figure shows the reversing torque and the speed…

A: We have an variable speed drive and reversing under no load with , Given data from figure, Speed…

Q: 120 v FR₂=15_12² Find the V1, V2, V3, V4, V5, V6, V7 24 = 20-2 W R₁ = 10-22 · R3 =1512 R5-=25/12 R6…

A: A circuit with one dc voltage source, 7 resistances in variety combinations. we have to find out…

Q: 9.10 Find the steady-state expression for vo(t) in the circuit shown by using the technique of…

A: For the given circuit calculation of steady state expression for v0(t) using source transformation:…

Q: The performance of a communication system can be affected by noise from both internal and external…

Q: 7v (+ 100 ww 4000 200

A: Given circuit diagram, I =? I100 =? I400 =? I200 =?

Q: 1. Write 10+j 20 in polar coordinates 2. Sein rectangular coordinates 3. 15-j 30 in polar…

A: Given data, 1. Function is given 10+j20 Converting it in polar form, 102+202∠tan-12010=22.36∠63.430

Q: ) The output of a system, y(t), is related to the input of the system, x(t), through the…

Q: Calculate the dissipation in power across 2002 resistor for the FM signal v(t)= 20 cos(6600t+…

A: The expression of the FM signal is given as vt=20cos6600t+10sin2100t The power dissipated in 20-ohm…

Q: 3.45. Show that if x() is a left-sided signal and X(s) converges for some value of s, then the ROC…

A: Region of convergence (ROC): For finite duration signal condition for right-sided signal or casual…

Q: Express the Boolean function F = C + A’B as a sum of minterms. The function has three variables: A,…

A: Given: F=C+A'B

Q: Infinite uniform line charges of 5 nC/m lie along the (positive and negative) x and y axes in free…

A: You have asked multiple questions, but in part, b) the data is insufficient so we will solve the…

Q: 0.3/(5) Marks Derive the closed loop gain of the op-amp circuit illustrated in figure below. Then…

Q: If a 4-pole induction motor has a synchronous speed of 1500 r.p.m., then, supply frequency is

A: Given an induction motor with, Total number of poles, P = 4 Synchronous speed, Ns=1500 rpm Supply…

Q: For an inductive load, inductor plus resistor, Vrms = 10 V Irms = 2 A PF = 0.8 Calculate the…

A: Given an inductive load, inductor pulse resistor with Voltage, Vrms=10 V Current, Irms=2 A Power…

Q: Calculate the seg based on the following information. Weight of carrier = 1.57 kg/m. Diameter of…

Q: 3. Calculate the mesh current 11 for the circuit below. *

A: The required mesh current can be calculated by using the mesh analysis of the given circuit. The…

Q: A 25 MVA, 13.2 kV alternator with solidly grounded neutral has a subtransient reactance of 0.40 p.u.…

Q: Q.15. The audio signal having frequency 500Hz and voltage 2.6V, shows a deviation of 5.2KHz in a…

A: Given data, Initial amplitude, Am1=2.6 V Initial frequency deviation, △f1=5.2 kHz Final amplitude,…

Q: Three resisters are used in a circuit, with resistances R1 = R, R2 = 2R, and R3= 3R, where R = 7.5…

A: Given: R=7.5Ω and R1=R, R2=2R, R3=3R

Q: Given a discrete-time system that is described by the following state-space equation: 2 [91(k)…

A: Given, q'=Aq+Bu y=Cq+Du Where A=3323-12, C=24, B=10, D=21 Here, we have to convert the state-space…

Q: Where did the -0,4V come from??

A: In the given circuit, one of the requirements is to achieve maximum gain and it can be achieved by…

Q: So-called analog computers use circuits to solve mathematical problems, particularly when they…

Q: Current I (amperes), voltage V (volts), and resistance R (ohms) in a cırcuit are related by Ohm's…

A: Given: Current= 'I' Amperes Voltage= 'V' Volts Resistance= 'R' ohms Ohm's law, I=V/R

Q: 100V Find: R₁=5_22 P₁, P2, P3, P4, P5, P6 and TOTAL POWER R4=1512 R₂ = 5-2 R3=10_2 26 = 2012 Rs=2012

Q: A ring of radius R has a charge distribution on it is given by = ncose + 8 where n and & are…

A: The given figure is shown below: It is given that: λθ=ηcosθ+δwhere,η and δ are constants.

Q: 2. For the voltage feedback network of Fig., determine: ܐܢ ܢ ܝܢ a) lc b) Vc c) VE d) VCE VI 10μF H…

Q: Question 2 View the chart on the characteristics of electromagnetic and mechanical waves and answer…

A: The given chart is shown below:

Question

What is the required bandwidth according to the Carson's rule, when a 100 MHz carrier is
modulated with a sinusoidal signal at 1KHz, the maximum frequency deviation being 50 KHz.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The directivity of an antenna is 12 dB. What will be the beam solid angle of the antenna? Express the answer in steradian.
At a certain time, the maximum usable frequency (MUF) for transmission at an angle of incidence of 75° is 20MHz. A) What is the critical frequency in MHz? (Use two decimal places for the final answer) B) What will be the optimum working frequency (OWF) in MHz? (Use two decimal places for the final answer)
If you check the voltage at one-half wavelength from the end of an RF transmission line, what voltage would you measure? A. Peak B. Infinite C. Minimum D. Zero
Show that the directivity of isotropic antenna is 1.
True or False. If the noise variance increases, the average power density of the Gaussian white noise increases
Pick a point on a Smith chart normalized to 60 Ω. What is the value of the complex impedance at 3 GHz?
Determine the directivity in dB for an antenna that produces a power density of 10 uW/m2 at a point in space when a reference antenna produces 0.4 uW/m2 at the same point.
A car is driven at the speed of 90 km/h on the road, CALCULATE the received carrier frequency if the mobile receiver is moving:(transmitter radiates a sinusoidal carrier frequency of 2400 MHz) (a) Directly towards the transmitter. (b) Directly away from the transmitter. (c) In a direction that is perpendicular to the direction of arrival of the transmitted signal.
Prepare a table of values for the change of maximum usable frequency when an incident angle [6M] change from 900 to 00 (calculate for every 10 degrees), and plot a graph, assume that the critical frequency is constant at 30MHz. and give your observation over the graph.
In a communication link, both the transmitting and the receiving antenna are having a gain of 40 dB. If the frequency of the transmitted wave is 10 GHz, then find out the received power by the receiving antenna located at 1 km away if the transmitted power is 10 W.
What circuit Q is required to give a bandwidth of 56 MHz at a frequency of 44 GHz? Round the final answer to three decimal places.
An antenna with a radiation resistance of 48 Q, a loss resistance of 20 and a reactance of 50 Q is connected to a generator with an open circuit voltage of 10 V and internal impedance of 50 through a transmission line with a characteristic impedance of 100 . Determine the power supplied by the generator and power radiated by the antenna.