What is the value of reverse recovery charge developed in diode which is having the rate of fall of diode current 34.7 A/us and t is equal to 5.6 us. O a. 1088.19 µC O b. 971.60 µC O c. 313.60 µC O d. 544.10 uC

What is the value of reverse recovery charge developed in diode which is having the rate of fall of diode current 34.7 A/us and t is equal to 5.6 us. O a. 1088.19 µC O b. 971.60 µC O c. 313.60 µC O d. 544.10 uC

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.2P: The temperature dependence of resistance is also quantified by the relation R2=R1[ 1+(T2T1) ] where...

See similar textbooks

Related questions

Q: helf guiz fast solutionz Determine the static or dc resistance of the commercially available diode…

A: According to question:

Q: Given the circuit below, What is the output voltage in volts on the positive half cycle of the…

A: This circuit have 2 diodes and 2 battery connected as shown in the figure. Find the output voltage…

Q: A diode is doped with NA=1018/cm3 on the p-type side and ND=1018/cm3 on the n-type side. (a) What…

Q: For the circuit shown below: Vs assuming ideal diode.if the load is 112 0 and the rms voltage of the…

Q: (a) Find the worst-case values of the Q-point current for the diode shown using the ideal diode…

A: (a) Draw the circuit, when the diode is forward biased, and the resistors with the added values of…

Q: A diode is tested at the presence of dc+ac source, where the diode's average current level (dc…

Q: Consider given choices. Solve the current flowing to silicon diode of the given circuit below.

Q: In the circuit shown, determine the current flowing through the resistor R1. (Use 2nd approximation…

Q: 1. Determine the dynamic (ac) resistance of the diode at a forward current of 15 milliAmpere using…

A: consider thegiven question;

Q: 1. Let us plot the Shockley diode equation. Suppose you are required to use In () as the vertical…

A: Intrinsic semiconductors have very low conductivity at the room temperature. Hence, extra charge…

Q: In the circuit shown, determine the voltage across resistor R1. ( Use 2nd approximation and assume…

Q: (a) What is the forward voltage of a diode operating at a current of 48.6 A at 300 K if IS =10−15 A?…

A: Given data: ID is: 48.6 A Is is: 10-15 A k = 38×10-23 J/K q = 6×10-19 C The expression for the…

Q: From the circuit shown in the figure below determine the following: 1. How much load current is…

Q: Q1. For the Zener diode circuit below calculate the minimum input voltage required for stable…

A: As per our company guidelines we are supposed to answer only first question kindly repost other…

Q: A diode has a doping of ND = 1015/cm3 on the n-type side and NA = 1017/cm3 on the p-type side. What…

A: The built-in potential of the given diode is given by the expression as shown below: Plugging the…

Q: In the circuit shown, determine the circulating current. (Use 2nd approximation and assume all…

A: Circuit diagram is given as,

Q: A FWBR with an RL load is connected to a 120 V source. If the load resistance is 10 22 and L » R,…

Q: A diode is operating with iD = 2 mA and vD = 0.82 V. (a) What is IS if n = 1? (b) What is the diode…

A: Given data, The value of diode current iD = 2 mA. The value of diode voltage vD = 0.82. The value…

Q: (a) Consider a pn junction diode biased at Ipg = 1 mA. A sinusoidal volt- age is superimposed on Vpg…

A: Given Data: pn junction biased current IDQ = 1 mApeak to peak sinusoidal = 0.05 IDQThermal voltage…

Q: In the practical diode model, which one does the diode current not depend on? a-Voltage applied to…

A: In this question we need to choose a option in which diode current not depend on.

Q: a) List the main factor in determining the value of the reverse saturation current in the diode.…

A: a) Answer: Temperature (and minority charge carriers concentration)

Q: Determine the state of diode for the circuit shown and find ID, VD. Assume simplified model for the…

A: Given data : simplified model for the diode,

Q: Q4. (a) Explain in detail how p-type and n-type semiconductors of a diode are formed. (b) Explain…

A: a) By combining p type and n type semiconductor we get PN junction diodeThe layer which separates…

Q: In the circuit shown, determine the circulating current. D1 R1 D2 1K 6V

Q: For an ideal diode which of the following is true? a) It allows the passage of current in the…

A: In the following sections, among the given statements, which are true for an ideal diode will be…

Q: The output of a diode used as a solar cell is given by IC =1−10−15[exp(40VC)−1] amperes What…

A: Given data: IC=1-10-15e40VC-1 A The output of a diode used as a solar cell is given by…

Q: Homework # 1: The manufacturer of a selected diode gives the rate of fall of the diode current di/dt…

A: In this question 1 , reverse recovery time is given and rate of fall of diode current is given..We…

Q: A diode is operating at a current of 250μA. (a) What is the diffusion capacitance if the diode…

A: a) Calculating diffusion capacitance CD=IDτTVTCD=250×10-6 A10-1025×10-3CD=1 pF

Q: A 1N4733 zener diode has a Zz of 7 ohms. Considering the data of the manufacturer's hona, the Vz =…

A: Here the circuit will be work as voltage regulator So, the output voltage will be VZ=VZO+RZIZ

Q: In the circuit shown, determine the voltage across resistor R1. (Use 2nd approximation and assume…

Q: Using ideal diode with a Vi = 40 Vpp and V = 12 volts; the output waveform of the circuit has its…

A: Given: Note : In the question they have to ask the value of voltage on the capacitor whenever diode…

Q: Use Load-Line analysis to solve for the diode current and the diode voltage in the following…

Q: 4. Given: Rs 2202 Determine the range of Vi to maintain the Zener diodes in the "ON" state Vz R5…

Q: 1. Determine the dynamic (ac) resistance of the diode at a forward current of 10 milliAmpere using…

A: 1) To find the dynamic resistance of the diode Given, forward current through the diode = 10 mA

Q: Solve for the diode current Ip and the voltage across the load R using the three diode model: below:…

Q: A diode has a reverse saturation current of 5 x 10-15 A and an ideality factor of 1. If its DC…

A: Given that, Is=5×10-15Aη=1VD=0.70VVT=0.026V at T=300K First calculate diode current…

Q: 24 A 30-volt forward voltage is applied to a silicon diode in series with a load of 3 kf2. Draw the…

Q: Consider the diode circuit shown below. If in the given circuit, Vs is replaced by a 12V battery…

A: Diode starts conducting when anode voltage is greater than cathode voltage and ideal diode maintains…

Q: A 1N4748A zener diode has a ZZ of 23 Ω. Taking the data from the datasheet VZ = 22 V with a test…

A: Case 1: Current is 6mA The change in current from the test current IZ = 11.5 mA is; ΔIz=6mA-11.5mA…

Q: 1. For an ideal diode which of the following is true? a) It allows the passage of current in the…

A: The correct option along with the necessary explanation is provided in the following section.

Q: If a diode exhibits a zero resistance between its two terminals in either direction, what conclusion…

A: 1)If a diode exhibits a zero resistance between its two terminals in either direction conclusion-…

Q: In PN junction in series with a 100 ohms resistor, is forwarded biased. So that a current of 100 mA…

A: Circuit diagram is given as, In first case diode is forward bias replacing the diode as short…

Q: Q11) For the shown figure below .Explain the state of the given diodes .Calculate the current and…

A: Find the current in the each diode. Let's forward bias diode voltage across each diode = 0.7V

Q: 4k2 2V 1kN.

Q: With the given circuit below, if the input voltage is 10 volts peak-to-peak and the diode is…

A: For the given circuit , to find the output voltage in the negative half cycle This is a negative…

Q: A 1N4738A zener diode has a ZZ of 4.5 Ω. Taking the data from the datasheet we have VZ = 8.2 V with…

A: Given Zz=4.5 ohmVz=8.2 VIzT=31 mA

Q: 1.) Consider the following voltage regulation circuit employing three diodes in series, assuming the…

A: According to the question we have to (a) Nominal output voltage vo with no load; (b) Line…

Q: Suppose you have a diode whose junction cross sectional area is 100µm? and has the following…

A: Given: Suppose you have a diode whose junction cross sectional area is 100 µm2 and has the following…

Q: Find the Vout of the Circuit below during the Positive half cycle. Consider the Diodes as a Silicon…

A: In this question, Find output voltage waveforms of the circuit for the positive half cycle? If…

Question

What is the value of reverse recovery charge developed in diode
which is having the rate of fall of diode current 34.7 A/us and t, is
equal to 5.6 us.
O a. 1088.19 µC
O b. 971.60 µC
O c. 313.60 µC
O d. 544.10 uC

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Three Phase Controlled and Uncontrolled Rectifiers

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

How is a solid-state diode tested? Explain.
What is CEMF?
The temperature dependence of resistance is also quantified by the relation R2=R1[ 1+(T2T1) ] where R1 and R2 are the resistances at temperatures T1 and T2, respectively, and is known as the temperature coefficient of resistance. If a copper wire has a resistance of 55 at 20C, find the maximum permissible operating temperature of the wire if its resistance is to increase by at most 20. Take the temperature coefficient at 20C to be =0.00382.
A 1N4738A zener diode has a ZZ of 4.5 Ω. Taking the data from the datasheet we have VZ = 8.2 V with a test current, IZ, of 31 mA. What is the voltage across the zener terminals when the current is 15 mA? When the current is 55 mA? Make the representation of the values by means of their curve characteristic.
Since , C= 47 micro farad, RL= 1Kohm, Vs= 90cos2000t V What is the diode current in the one-time fill time range of the capacity?
A silicon diode is in connected to a DC voltage source with Forward biased, the net currentflowing through the diode is (25mA) where the applied voltage across the terminals of thediode is (820mV). Determine diode temperature, if Is "dark saturation current", the diodeleakage current density in the absence of light is 3.4 × 10−10 A
The output of a diode used as a solar cell is given by IC =1−10−15[exp(40VC)−1] amperes What operating point corresponds to Pmax? What is Pmax? What are the values of ISC and VOC?
Consider the diode circuit shown below. If in the given circuit, Vs is replaced by a 12V battery and diodes D1 & D2 are considered ideal, what is the potential Vout equal to?
Consider the diode circuit shown below. If Vs is a sinewave with a peak amplitude of 12 Volts at 60Hz, and diodes D1 & D2 are considered ideal, sketch the appearance of the waveform at node voltage Vout . Sketch the appearance of the waveform at Vout .
A diode is doped with NA=1018/cm3 on the p-type side and ND=1018/cm3 on the n-type side. (a) What are the values of pp, pn, np, and nn? (b) What are the depletion-region width wdo and built-in voltage?
Make a sketch of the I–V characteristic curve for a diode with Is = 0.02 pA for VD values from zero to 0.7 V. Use the approximation ID = Is e^(Vd/VT) What is the slope of a line tangent to the curve at ID = 2 mA?
A diode whose internal resistance is 20 ohms is to supply power to a 1000-ohm load from a 110V(rms) source of supply. Calculate the peak load current, dc load current. and determine the percent regulation from no load to the given load. a.) Peak Load Current= 120.8mA; DC load current=25.5mA b.) Peak Load Current= 133.3mA; DC load current=29.4mA c.) Peak Load Current= 144.3mA; DC load current=34.7mA d.) Peak Load Current= 152.5mA; DC load current= 48.5mA