If the pressure value of a monatomic gas is 296.063atm, what is the value of the constant Rif the volume of the container is 2L, the temperature is 25C, and the heat capacity is constant volume is 2.98?

If the pressure value of a monatomic gas is 296.063atm, what is the value of the constant Rif the volume of the container is 2L, the temperature is 25C, and the heat capacity is constant volume is 2.98?

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter3: The First Law Of Thermodynamics

Section: Chapter Questions

Problem 61P: The temperature of an ideal monatomic gas rises by 8.0 K. What is the change in the internal energy...

See similar textbooks

Related questions

Q: A horizontal power line carries a current of 4140 A from south to north. Earth's magnetic field (85....

Q: frictionless pulley at the top of the inclines as shown, so the blocks can slide together. The mass ...

Q: A weather satellite is to be placed in a circular orbit around the earth at an altitude of 300 miles...

Q: A 45 kg boy whose leg bones are 5 cm² in area and 50 cm long falls through a height of 2 m without b...

Q: Given data : Work done=120 J Displacement=22 m Find force

A: Given data : Displacement=d Work done=W To find : Force

Q: A hydraulic press for compacting pov large cylinder which is 10.0 cm in dia linder with a diameter o...

A: We know that the relation between the pressure and the force is given as Pressure =Force Aera P = F...

Q: 3. A car skids to a stop on an icy road. The car has an initial velocity of 25.0 m/s and skids for a...

A: In this question we have to find the deceleration of the car. Please give positive feedback if the a...

Q: A Nichrome heater dissipates 520 W when the applied potential difference is 110 V and the wire tempe...

A: Let Rh be the resistance at the higher temperature (800°C) and let Rl be the resistance at the lower...

Q: In a downhill ski race surprisingly little advantage is gained by getting a running start. This is b...

Q: Two billiard balls are initially traveling toward each other at speeds of 2.30 m/s for ball 1 and 4....

A: In an elastic collision, the total linear momentum and the total kinetic energy of the system is con...

Q: On a level ground, a meter sticks and a building cast shadows of 1.8 m and 90 m respectively. What i...

Q: Why are two wires used to carry electric current instead of a single one? Explain in not less than 3...

A: Given For electric current to pass we use two wires We have to find the answer, why do we not use si...

Q: To produce a vibration, what three (3) properties of a body must a force overcome?

A: In this question we have to answer the three properties of a body must a force overcome. Please give...

Q: A bullet of mass 11.7 g is fired into an initially stationary block and comes to rest in the block. ...

Q: A student makes a short electromagnet by winding 450 turns of wire around a wooden cylinder of diame...

Q: 1. Find the work done on a 48,500 g object to move it on a 22.55 m up a 25.50 degrees incline. - 397...

Q: Breakdown and explain the motion of a projectile enumerating the relation of its components to a rec...

A: In this question we have to explain the motion of a projectile enumerating the relation of its compo...

Q: QUESTION 40 A 3.7 kg box on a horizontal plane is pulled to the right using a string. The tension in...

A: mass of box (m) = 3.7 kg tension in the string = 25 N coefficient of kinetic friction = 0.4 coeffici...

Q: In a gas that is a mixture of water (two H and one O) and carbon dioxide (one C and two O), if the w...

Q: This time the magnet has mass 6.08 kg and the force pulling it to the right is 110.3 N. When the mag...

Q: Classical Doppler Effect Problems DE-1 Two trais, A and B, are approaching each other on adjacent tr...

Q: 1. What is the capacitance of a parallel plate capacitor with metal plates, each of area 1.00 m², se...

Q: Given data : Voltage=30 Volt Resistance-4 ohm Find current

Q: Three negative point charges lie along a line as shown in the figure below. Find the magnitude and d...

Q: force pulling it to the right is 108.0 N. The length of the cord is 1.13 m, and the ceiling is 2.75 ...

A: Previous question:- The same situation as in the previous two problems this time the magnet s mass ...

Q: After fixing a flat tire on a bicycle you give the wheel a spin. Its initial angular speed was 5.40 ...

Q: A bag falls from an airplane flying horizontally at an altitude of 490 meters. When will it strike t...

Q: A short vertical transmitting antenna erected at the surface of a perfectly conducting earth transmi...

Q: ollege.com/course.html?courseld%3D172213328OpenVellumHMAC=D9208e34104b2ff07559f86fc719d680a#10001 A ...

Q: What is the smallest separation between two slits that will produce a second-order minimum for 720 n...

Q: wo blocks are positioned on surfaces, each inclined at the same angle of 47.7 degrees with respect t...

A: GivenAngle, θ=47.7°Mass of black block, M=7.01 kga=1.5 m/s2

Q: er, a distance 10 m from a burning building, directs a stream of water from a fire hose at an angle ...

A: GivenDistance between firefighter and building, d=10 mAngle of stream of water above horizontal, θ=4...

Q: QUESTION 4 Same situation as in the previous problem this time the magnet has mass 7.83 kg, the for...

Q: Given data: Mass=3 kg Velocity-4 m/s Find momentum

A: Given data : Mass=m Velocity=V To find : Momentum

Q: angle of 54.5 degrees with respect to the horizontal. The blocks are connected by a rope which rests...

Q: What velocity (m/s) must a 10.7 kg object be moving in order to possess a kinetic energy of 1.38J?

A: Given data: Mass (m) = 10.7 kg Kinetic energy (KE) = 1.38 J Required: Velocity in m/s

Q: In the figure circuit section AB absorbs energy at a rate of 47 W when current i = 0.88 A through it...

Q: Two blocks are positioned on surfaces, each inclined at the same angle of 46.2 degrees with respect ...

A: Given: θ=46.2°μ=0.540mass of black block M1=2.56 kgmass of white block M2=?both slides right, with c...

Q: 2. A 10 kW drilling machine is used to drill a bore in a small aluininium block of mass 8-0 kg. How ...

Q: LIFT WING AIR TU111 Pressure exerted by slower-moving air

Q: 1.) For a given voltage, as the resistance in the circuit increases the current: a.) Increases b.)...

Q: A temperature-stable resistor is made by connecting a resistor made of silicon in series with one ma...

Q: A dielectric-filld po allel-plate copacitor Las plate A=10.0cm², plate separation d= 3.00mm and diel...

A: Given, plate area A = 10.0 cm2, plate separation d = 8.00mm dielectric constant k = 4.00 voltage V =...

Q: Part A A dentist wants a small mirror that, when 1.80 cm from a tooth, will produce a 4.5× upright i...

A: Please note : As per answering guidelines I can answer the first question only. Since, this is not a...

Q: Car B gaps Car A by 90 ft as they travel along neighboring highway lanes at t = 0. Determine (a) whe...

A: Part a) Initial time is at t= 0 sec. Let the time taken for the overtake is 't'. The initial velocit...

Q: A student makes a short electromagnet by winding 450 turns of wire around a wooden cylinder of diame...

Q: Same situation as in the previous two problems this time the magnet s mass is 7.20 kg and the magnet...

Q: Two conductors are made of the same material and have the same length. Conductor A is a solid wire o...

Q: A bullet of mass 11.7 g is fired into an initially stationary block and comes to rest in the block. ...

Q: Consider the same situation as in the previous problem. This time the magnet has mass 6.02 kg and th...

A: Option (a) 191.4 N

Question

If the pressure value of a
monatomic gas is 296.063atm,
what is the value of the constant
Rif the volume of the container is
2L, the temperature is 25C, and
the heat capacity is constant
volume is 2.98?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A company advertises that it delivers helium at a gauge pressure of 1.72107 Pa in a cylinder of volume 43.8 L. How many balloons can be inflated to a volume of 4.00 L with that amount of helium? Assume the pressure inside the balloons is 1.72105 Pa and the temperature in the cylinder and the balloons is 25.0 .
A car tile contains 0.0380 m3 of air at a pressure of 2.20105 Pa (about 32 psi). How much more internal energy does this gas have than the same volume has at zero gauge pressure (which is equivalent to normal atmospheric pressure)?
The temperature of an ideal monatomic gas rises by 8.0 K. What is the change in the internal energy of 1 mol of the gas at constant volume?
Under what circumstances would you expect a gas to behave significantly differently than predicted by the ideal gas law?
Suppose a gas-filled incandescent light bulb is manufactured so that the gas inside the bulb is at atmospheric pressure when the bulb has a temperature of 20.0 . (a) Find the gauge pressure inside such a bulb when it is hot, assuming its average temperature is 60.0 (an approximation) and neglecting any change in volume due to thermal expansion or gas leaks. (b) The actual final pressure for the light bulb will be less than calculated in part (a) because the glass bulb will expand. Is this effect significant?
A mole of an ideal gas at pressure 4.00 atm and temperature 298 K expands isothermally to double its volume. What is the work done by the gas?
In a quasi-static isobaric expansion, 500 J of work are done by the gas. The gas pressure is 0.80 atm and it was originally at 20.0 L. If the internal energy of the gas increased by 80 J in the expansion, how much heat does the gas absorb?
Consider a cylinder with a movable piston containing n moles of an ideal gas. The entire apparatus is immersed in a constant temperature bath of temperature T kelvin. The piston is then pushed slowly so that pressure of the gas changes quasi-statically from p1 to p2 at constant temperature T. Find the work done by the gas in terms of n, R T, p1 , and p2 .
A system consisting of 20.0 mol of a monoatomic ideal gas is cooled at constant pressure from a volume of 50.0 L to 10.0 L. The initial temperature was 300 K. What is the change in entropy of the gas?
What is the internal energy of 6.00 mol of an ideal monatomic gas at 200 ?
When 400 J of heat are slowly added to 10 mol of an ideal monatomic gas, its temperature rises by 10 . What is the work done on the gas?
If the rms speed of oxygen molecules inside a refrigerator of volume 22.0 ft.3 is 465 m/s, what is the partial pressure of the oxygen? There are 5.71 moles of oxygen in the refrigerator, and the molar mass of oxygen is 32.0 g/mol.