What kind of cable utilises a connection shaped like a F

Q: (a) A = 150,000 A = 100,000 EPE 47 ΚΑΙ www Find the closed loop gain for these circuits R₂ * 4.7 ΚΩ…

A:

Q: Consider the root locus of the system shown in Figure Q11. O The angles (in degrees) for the…

A:

Q: A voltage source is feeding a capacitive complex load as shown. Given: v(t) = 12cos(2000t) V, R = 20…

A:

Q: X. دو Clock- Q₂ D₂ D using AND delay = 2 ol D₁ D determine the maximum clock frequency in…

A:

Q: Problem eight. Determine and sketch the root locus for the following characteristic equation. 1+…

A: In this question We need to draw the root locus of the given system.

Q: Q-A 200 V, 10 A, 1000 rpm, separately excited d.c. motor has an armature resistance of 30. The motor…

A:

Q: For the following circuit find currents through each light bulb in then find the source current Is…

A: For the given circuit, we need to find current through each bulb and the value of source current.

Q: Calculate voltages V1, V2 and V3 in the circuit of Fig below. (Ans: 10V; 4.933V; 12.267V) SA Μ 4 Ω 8…

A: The circuit diagram,

Q: 4) Calculate the maximum transmission distance for a fiber link with attenuation of 0.5db/km if mput…

A: For a fiber link with, Attenuation of 0.5 dB/km. Input launch power is 200 μW. Optical output power…

Q: A single-input, single-output system is described by 1 - x = [-26 -²₁ ]x + [ 1² ] 4. -a y=[ 10 ]x…

A: Here , single input, single output system is given  We need to find a value for the system exhibits…

Q: 18 ΚΩ V₁ 20μν 2 510 ΚΩ 22 ΚΩ 680 ΚΩ 33 ΚΩ 750 ΚΩ V₂

A:

Q: R₁ W V2 R₂ ww The circuit parameters are as follows: R1 = 2 KQ, R2 = 5 KQ, RL = 1 KQ, v1 = 2 V, and…

A:

Q: What is the period of a 2kHz signal?

A:

Q: Binary data @2.4 Mb/s Multinary baseband encoding Carrier modulator Modulated output Consider the…

A: The bandwidth of an M-ASK signal is given by: Bandwidth = M2 x Symbol Rate In this case, M = 2 since…

Q: Q-1) There exists a conducting ABC triangle wire given in Figure 1. Corners of the triangle have the…

A: The above question is based on the magnetic field due to a current flowing wire of finite length.…

Q: 3 Show that (a) 8(n) = u(n) - u(n-1) (b) u(n) = Σ= δ(k) = Σ0 δ(n – k)

A:

Q: Find the response of the second order system with Parabolic input. R(S) - wy S[S+23W) (5)

A: A system is said to be second order if the power of s in denominator is 2 in transfer function The…

Q: Consider two incandescent light bulbs, with resistances of 240 2 and 480 How much power do they each…

A: It is given that: V=120 VR1=240 ΩR2=480 Ω

Q: Find poles and zeros then draw the corresponding pole-zero diagram.

A:

Q: What is the main advantage of autotransformers over conventional power transformers? Explain…

A: Dear student, Since you have posted multiple questions, we will provide the solution only to the…

Q: Determine the impulse response for the system + y(n) + 4 y(n_l) + 3y(n=2) = X(n-1).

A: In this question we need to find the impulse response of the given system

Q: An ADC is sampling at 32kHz. What is the frequency of the alias of 10kHz that has its frequency…

A: Given ADC sampling frequency= 32kHz Signal frequency=10kHz   To determine: Alias frequency…

Q: For the feedback control system given in the figure on the right, R(s) + (a) Find the closed-loop…

A: To plot the step response for the input of 1.5u(t) when K = 22, we need to find the closed-loop…

Q: 2. Determine C/R₂ for the system given R₁ G₁ H₂ G₂ H₁ H₂ G₁

A: given block diagram of the control system is

Q: 1. The plane z=0 separates air (≥0, µ= µ) from iron (z≤0, µ=250µ). a) Find B in iron and the angle…

A: Given Data: A plane of z=0 separating air and iron has magnetic field intensities of,…

Q: A class B amplifier connected to a VCC=9V source and providing its power at RL=8 ohms, what will be…

A: SOLUTION: GIVEN DATA: 1.Class - B amplifier 2.VCC=9V 3.RL=8ohm DETERMINE: =>here find Maximum…

Q: Find the current in R₁. E1 12V R1 ww 120 R3 600 R2 w 3002 E2 32V

A: here we have to find the current in the resistor R1.

Q: QUESTION 3 a) Determine the Fourier series ao, an and b₁ of the periodic signal, x(t), illustrated…

A:

Q: Q-2) A non-uniform surface current density flows as: = {ªlor'sin (r) over S': (a≤r'≤ 2a, 0 ≤ 4' <…

A: According to the question, for the given geometry as shown below A non-uniform surface current…

Q: Problem Three A closed loop feedback control system for a DC motor with speed control is shown…

A:

Q: Using a Karnaugh map, convert the following expressions into a minimum POS expression, and a minimum…

A: For the given boolean function the minimum product of sum and sum of product need to be obtained by…

Q: Vin страни 300 5 ww 400-52 IMF CON No зорін

A: I'm going to apply sinusoidal analysis for both A.C input and D.C input separately accordingly we…

Q: Find the reluctance for a core with effective length of 7 cm and cross section of 0.001 .and…

A: Effective thickness l=7cm=0.07m.Cross sectional area a=0.001m2.Magnetic permeability μr=0.01855Wb/A…

Q: The op amp in the circuit shown in (Figure 1) is ideal. Figure 15 ΚΩ 30 ΚΩ 48 ΚΩ w +● {45 ΚΩ 10 V…

A: As per our company guidelines we can answer only first three sub parts please submit remaining sub…

Q: Problem two Given the following open loop block diagram, determine Y(s) when R(s) is a unit step…

A:

Q: The average voltage of a single-phase full controlled bridge converter is measured to be 103.5 V.…

A: A single phase full controlled bridge converter with, Average voltage, Vavg=103.5V Supplied voltage,…

Q: Problem seven Using Routh- Hurwitz array, determine the range of K for a stable system for…

A: In this question,  We need to determine the range of K for stability of the system using the routh…

Q: 1. Determine the equivalent impedance across 'a' and 'b'. j12Ω 5Ω W Cod 4Ω j9Ω ad be W 4Ω (0) j13Ω…

A:

Q: Problem Three A closed loop feedback control system for a DC motor with speed control is shown…

A:

Q: P.6-4 In Fig. 6-10 assume a constant current i, = 1o, but that the rectangular loop moves away with…

A:

Q: In the electrical circuit shown, the components have the following values: V = 120 volts R₁ R₂ = 69…

A: For the given circuit the total current in the circuit needs to be calculated. The total resistance…

Q: 2. Determine V and I of a short transmission line, if Z is... a) 600+ j2002 and 200 + j300 are in…

A:

Q: 1. A causal LTI system has the frequency response: j200 1+ j0.50 Determine the output y(t) if the…

A: A causal LTI system has the frequency response, H(ω)=j2ω1+j0.5ω To determine the output y(t) if the…

Q: 1. Find the frequency (f) of the sine wave shown on the oscilloscope trace below: Oscilloscope M f=…

A: 1) we need to calculate frequency(f) of the sine wave in the oscilloscope . 2) we need to calculate…

Q: A 380 KW load is connected in parallel a 30 kvars traffic bank. The Food input reflects a power…

A:

Q: The transfer function of a system is The corner frequencies will be 10(1+0.2s) (1+0.5s)

A: Transfer function of a system:G(s)=10(1+0.2s)(1+0.5s)

Q: A single-phase controlled bridge rectifier is supplied from 120-V (rms) at 60-Hz utility. What is…

A: Solution: Given data: Supply voltage=120B F=60Hz R(L)=24-OHM angle=121(degree) Determine : here find…

Q: 5. contains.. The bit sequence 10011100 is serially entered (right-most bit first) into an 8- bit…

A: Given Data: A serial-In-Parallel-Out (Right-most bit first) has an input sequence of, 1001 1100…

Q: The plate area of a parallel-plate capacitor is 0.01 m². The distance between the plates is 2.5 cm.…

A: Given- The plate area, A = 0.01 m2. The distance between plates, d = 2.5 cm. The insulating medium…

Q: The magnetic field phasor of a wave traveling in a medium with intrinsic impedance n = 120 2 is…

A:

Fiber Optics

Fiber optics is a technology used to transmit the facts such as light or pulses with fiber or plastic over long distances. Visual fibers are about the width of a human hair strand and, when tied directly to a fiber-optic cable, can transmit multiple long-distance records and faster in different ways.