Which equipment can tell how much a cable has been overused and how far it has been stretched?

Q: 3. A test is being run in a wind tunnel when a sensor on the trailing edge of a wing produces the…

A: The given response curve is shown below.From the graph we can write that the response starts from 0…

Q: Power supplies used in medical devices and in the vicinity of patients must pass several stringent…

A: The circuit diagram,The value of resistors, The value of the cpacitor will be,The supply frequency,

Q: Determine the drain-to-source voltage (VDS) in the circuit shown in Fig. 17 if VDD = +18V and RD =…

A: It is given that:

Q: 3V 100 Ω Q www t=0 s S1 1µF: 1μF • 200 Ω S2 a b t=10 ms 1μF 50 Ω www 1 mH

A:

Q: Three unequal, single phase inductive loads are connected between the lines 1-2, 2-3 and 3-1 of a 3…

A: A three-phase system contains three unequal, single-phase inductive loads that are connected between…

Q: finde the thevenin equavalent

A: In this questionWe need to determine the Thevenin equivalent across the terminal. We are solving…

Q: The equivalent circuit for a 100-MVA, 7.97kV:79.7kV transformer is shown below.

A: The equivalent circuit for the 100 MVA transformer is shown is Here we have to calculate (a) Base…

Q: A sampling operation will be carried out. We want to sample z(t)= 6, 6e-0,8t cos(22t) continuous…

A: Sampling frequency Asked to find which of the given samples is not a valid sample.

Q: Question No. 11: Sketch the layout of hydroelectric power plant and explain the functions of each…

A:

Q: Question 2 Determine v (t) for all t in the circuit of Figure Q2. Sketch the response, v(t). 392 24…

A: To determine v(t) for all t in the given circuit. Sketch the response, v(t).Here, the given circuit…

Q: determine Vo:

A: It is given that:

Q: Consider a crystal made of silicon atoms. All 14 electrons in each silicon atom participate in…

A: The static dielectric constant, often denoted as εr(0) or simply ε, is a fundamental property of a…

Q: 2. The switch in the following circuit has been closed for a long time and it is opened at t=0. Find…

A:

Q: what is the problem with measuring a sample with polychromatic light using a single beam instrument

A: Step-1->When measuring a sample with polychromatic light using a single beam instrument, there…

Q: 2. Using nodal analysis, find v, and i, in the circuit of Fig. 3.79. 100 V 40 42 102 2012 120 V 24,…

A: Asked to find vo ,io by using Nodal analysis

Q: Vin + D₁ . 19 - + RL Vout The rectifier above drives a 950- load with a peak voltage of 3.15V. For a…

A:

Q: Translation: Given that the Beta value is 80 and the IC current is 1mA as stated above, what is the…

A: Here given a circuit and asked to calculate the collector resistance value.

Q: 37. A 500 MW, 3-phase, Y-connected synchronous generator has a rated voltage of 21.5 kV at 0.85 p.f.…

A: It is given that:

Q: It is required to measure a flow Q with an accuracy of ± 0.01 gpm by using flow sensor that has a…

A: It is an electronic circuit that allows low-frequency signals to pass through while attenuating…

Q: P4.2 It is important to ensure passenger comfort on ships by stabilizing the ship's oscillations due…

A: It is important to ensure passenger comfort on ships by stabilizing the ship's oscillations due to…

Q: 7. For the circuit below, determine v₂ (t) if L = 4 H, R=24 02, and C = 31.25 mF for an input of 4V.…

A:

Q: Task 3 The circuit shown is used to rectify the AC voltage u(t). The characteristic curve of the…

A: To approximate the value of m from the characteristic curve for , we can use the diode equation:

Q: Find the Thevenin equivalent with respect to the terminals a,b in the circuit in Figure. 2100 Ω 20 Ω…

A:

Q: 1) A 230-V, 50-Hz. 6-pole, single-phase induction motor has the following constants. ₁ 0.12 2.₂…

A: A pole, single-phase induction motor has the following constants,.If the slip is given as , then to…

Q: 3-phase transformer, ratio 33/6.6-kV, A/Y, 2-MVA has a transformer has a primary impedance of 6 + j…

A:

Q: Find the power dissipated by resistor R₁. R3 = 3.00 2 www R₁ = 3.00 R₂ 3.00 Ω - V₁ = 24.00 V - +11/F…

A:

Q: ind the currents and V0

A: Given:A network, To find:The currents I1, I2, I3 and V0.

Q: If the current gain of a BJT Transistor is 200 and the collector current is 100mA, What is the base…

A: Current Gain (β) is defined as the ratio of collector current and base current.i.e.,     β =…

Q: Q1. For the following circuit, K₂ = K₂= 1 mA/V², VTN = 1 V, VIP = -1 V, and λ = 0. Find the DC drain…

A: For the following circuit, To find the DC drain currents ID1​ and ID2, the small signal voltage…

Q: 3. Design a circular aperture antenna with a field distribution over its opening of E = C[1-(p/a)²],…

A: According to the question, we need to design a circular aperture antenna with a field distribution…

Q: 7. Find ID and V₁ of the diode D₁ and D₂ by using the CVD diode model (Assume Von = 0.7V for both…

A: The circuit is

Q: A unity negative feedback system has the open-loop transfer function: K(s+1) s² + s +1 What value of…

A: In this questionWe need to choose the correct options. What is break in point of the given system.

Q: You are given three resistors of values 1, 2 and 3 ohms respectively. How many unique resistance…

A: Given three resistors, values are 1,2,3ohms respectively. Asked to explain all possible combinations…

Q: A sampling operation will be carried out. We want to sample x(t) = 9, 1e-0,3 cos (23t) continuous…

A:

Q: A surface charge density Ps= Pso C/m² lies on surface defined by a ≤ R≤ b, 0≤ 0 ≤ 1/2 and p =0 as…

A: According to the question, for the given surface as shown belowWe need to find the electric field at…

Q: Q) Find V out in this circuit using Thevenin theorem. V(t)=6sin(20000t)

A:

Q: 4.For the circuit below, consider that the switch is in the "a" position only, for a long time…

A: The circuit diagram,

Q: 10.- For the circuit shown in the following figure, find the current through and the potential…

A:

Q: Can you give me matlab code this question please ?

A: The MATLAB code to sketch the polar plot and Bode diagram representation of the frequency response…

Q: Question No.13: A central power plant has annual factors as follows. Load factor = 60%, capacity…

A:

Q: 2. Do the following: (a) Obtaing differential equation of in terms of Electrical field by using…

A: The above question is based on Maxwell's equations for electromagnetic fields.

Q: What is the maximal pixel size allowable for a CCD to achieve Nyquist sampling for GFP using a 65x…

A: It is asked to determine the maximal pixel size allowable for a CCD to achieve Nyquist sampling for…

Q: Three long parallel wires carry currents of magnitude I, I, and 21. One wire carries current into…

A: At point P, the magnetic fields generated by the three wires can be determined using the right-hand…

Q: The closed-loop position control of a direct current motor is shown in the block diagram below. The…

A: The transfer function of DC motor system is given asWe need to design a PID controller to meet the…

Q: 1. An air core toroidal ring with a mean diameter of 25 cm and a circular cross sectional diameter…

A: The diameter of the toroidal ring, The circular cross-section diameter, Number of turns, The…

Q: b. Using Butterworth approximation method, obtain the gain function for a filter described by the…

A: To obtain the gain function of the filter described using Butterworth approximation, we need to…

Q: A single channel digital storage oscilloscope uses a 12 bit, 10° samples/sec ADC. For a 1 kHz sine…

A: A single-channel digital storage oscilloscope uses a 12-bit, 109 samples/sec ADC.The input frequency…

Q: 1. Obtain only the zero sequence diagram and your ZBUS. Put the Complete diagram, including the…

A: In the given questions we need to draw the zero sequence diagram and calculate the Zbus matrix.

Q: Task 1: Manual Control of Duqum Railway Gate Figure 1 depicts a gate controller for Duqum railway.…

A: According to the question, we need to design a manual control of Duqum railway gate.For the manual…

Q: Given the circuit in figure. Derive the formula of voltage gain and current gain using complete…

A: For the given emitter follower circuit the value of voltage gain and current gain needs to be…

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.