Answered: What must be the emf in the circuit so…

What must be the emf in the circuit so that the current flowing through the 7 ohm resistor 1.80 A ? Each emf source has negligible internal resistance.

Physics for Scientists and Engineers: Foundations and Connections

1st Edition

ISBN:9781133939146

Author:Katz, Debora M.

Publisher:Katz, Debora M.

Chapter29: Direct Current (dc) Circuits

Section: Chapter Questions

Problem 19PQ

See similar textbooks

Related questions

Q: A flash unit for a camera has a capacitance of 1700 μF. What resistance is needed in this RC circuit…

Q: A battery with emf 24.0 volts and internal resistancer=2.0 ohms is pictured in the thick-lined box…

A: When the switch is open then current flowing through the wire is zero.

Q: A loop circuit has a resistance of R1 and a current of 1.9 A. The current is reduced to 1.6 A when…

Q: The RC charging circuit in a camera flash unit has a voltage source of 295 V and a capacitance of…

A: voltage (v) = 295 volts Capacitance (C) = 141 μF a) t = 15.2 s charging = 90% of maximum charge

Q: A total resistance of 3.00 ohm is to be produced by connecting an unknown resistance to a 12.0 ohm…

Q: Consider a series RC circuit as in the figure below for which R = 7.80 M2, C = 8.90 µF, and Ɛ = 30.5…

A: a) The expression for find time constant of the circuit is τ=RC Substitute values in the above…

Q: An emf of 10 V is connected to a series RC circuit consisting of a resistor of 1.80 ✕ 106 Ω and an…

Q: If two 20uf capacitors in series were connected to two 1 k ohm resistors in parallel… what would the…

A: Given, Two capacitor of capacitance C = 20 μF Resistance R = 1 kΩ = 1000 Ω

Q: 4.00 MQ resistor and a 3.00 µF capacitor are connected in series with a 12.0-V power supply. What is…

A: Time circuit of RC circuit is the time required for the capacitor to charge to its 63.2 % of its…

Q: Consider a series RC circuit as in the figure below for which R = 9.00 MQ, C = 1.00 µF, and ɛ = 28.0…

A: a) Time constant = RC = 9000000 * 0.000001 = 9 seconds

Q: Consider a series RC circuit as in the figure below for which R= 7.40 M2, C= 1.70 uF, and E= 29.5 V.…

A: Given data: R=7.40 MΩ C=1.70 μF ε=29.5 V Calculating the time constant of the circuit as follows:…

Q: An ideal emf e = 12 V is wired into a circuit with resistors R1 = 4.0 N and R2 = 8.0 N, as %3D shown…

A: According to Ohm's law, V = I×R where, V = Voltage I = Current R = Resistance Also, equivalent…

Q: Consider a series RC circuit as in the figure below for which R = 9.00 MN, C = 7.00 µF, and E = 28.0…

Q: In the RC circuit shown, the battery has fully charged the capacitor. At t=0 the switch S is thrown…

Q: Consider a series RC clrcuit as in the figure below for which R 7,40 MQ, C= 1.70 uF, and &=29,5 V.…

Q: The circuit shows R= 1 ohm, Emf1= 12.2 V and Emf 2= 7.1 V. What is the power delivered to the 10R…

Q: What is the voltage between the ends of the 4Q resistor in the circuit shown in the figure? Note:…

Q: Knowing that the power delivered to resistor Rj is 20.0 W, the resistance (in 0) of the resistor R2…

A: Total current I = 3.50 A Current flowing through R1, I1 = 2 A Value of one of the resistance = 10 Ω…

Q: The figure below shows a simple RC circuit with a 3.30-µF capacitor, a 2.80-MΩ resistor, a 9.00-V…

Q: At time t = 0, an RC circuit consists of a 20.0-V emf device, a 50.0-N resistor, and a 146.0-µF…

A: The time constant for a series RC circuit is defined as the product of resistance and capacitance…

Q: The time, in seconds, for the current through a 652-ohm resistor in an RC circuit, with an initially…

Q: An RC circuit have 9 V source and lies at 54 seconds of time constant. Then, find the voltage across…

A: Given data: The source voltage is V=9 V. The time constant is τ=54 s. The time taken is t=153.5 s.…

Q: Consider a series RC circuit as in the figure below for which R = 8.10 MΩ, C = 2.40 ?F, and ℰ = 30.5…

A: Given: The resistance is R=8.10 MΩ. The capacitance is C=2.40 uF. The voltage is E=30.5 V. Part (a)…

Q: Calculate the equivalent resistance Rab at terminals a-b in the circuit of the figure below. 102 ww…

Q: A battery with an emf of 12.0 V has a terminal voltage of11.5 V when the current is 3.00 A. (a)…

A: a)Terminal voltage is given by

Q: Consider a series RC circuit as in the figure below for which R = 3.40 MN, C = 2.80 µF, and E = 33.5…

Q: The figure below shows a simple RC circuit with a 2.70-µF capacitor, a 3.20-MΩ resistor, a 9.00-V…

Q: The maximum resistance made by combining these resistors (450 Ω, 650 Ω, and 500 Ω) is 1600 Ω and the…

A: Given : R1= 450 Ω, R2 = 650 Ω, R3= 500 Ω

Q: A 16-ohm resistor is connected in series with a parallel combination of two resistor, one of which…

Q: tó resistor R is 20.0 W, the resistance (in 0) of the resistor R2

A: power delivered P= I2 R

Q: Consider a series RC circuit as in the figure below for which R = 5.00 MΩ, C = 1.00 µF, and = 35.0…

A: It is given that,

Q: The RC charging circuit in a camera flash unit has a voltage source of 285 V and a capacitance of…

Q: A loop circuit has a resistance of R1 and a current of 1.8 A. The current is reduced to 1.5 A when…

Q: A toy battery has an emf of 33.0 V. The terminal voltage of the battery is 15.50 V when it is…

Q: A 200-volt electromotive force is applied to an RC-series circuit in which the resistance is 1000…

Q: A 120 resistor is connected in parallel with a series combination of resistor of 8.02 and 16.00. If…

A: solution as

Q: F, R = 2.00 106 Ω, and = 10.0 V. At the instant 11.2 s after the switch is closed, calculate the…

A: We know that the relation between the charge and the capacitance is given as Q = CV where Q is the…

Q: The time constant in an RC circuit is the time it takes a. so that the current drops to zero. b.…

Q: Find the equivalent resistance Reg for the resistor combination circuit in Figure 3. 30 2 10Ω 18 Ω…

Q: What is the maximum voltage that can be applied to a 186 k ohm resistor rated at 16 watts? Give your…

Q: What power is dissipated by a 568 Ωresistor if 10.0 A flow through it?

Q: An emf of 10 V is connected to a series RC circuit consisting ofa resistor of 2.0 x 106 Ω and an…

A: Formula to calculate the time constant of the RC circuit is,

Question

What must be the emf in the circuit so that the current flowing through the 7 ohm resistor 1.80 A ? Each emf source has negligible internal resistance.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The power dissipated in a resistor is given by P = V2/R, which means power decreases if resistance increases. Yet this power is also given by P = I2R, which means power increases if resistance increases. Explain why there is no contradiction here.
Consider the circuit below. The battery has an emf of = 30.00 V and an internal resistance of r = 1,00 . (a) Find the equivalent resistance of the circuit and the current out of the battery. (b) Find the current through each resistor, (c) Find die potential drop across each resistor, (d) Find the power dissipated by each resistor, (e) Find the total power supplied by the batteries.
The timing device in an automobile’s intermittent wiper system is based on an RC time constant and utilizes 0.5.00F capacitor and available resistor. Over what range must R be made to vary to achieve time constants from 2.00 to 15.0 s?
The label on a battery-powered radio recommends the use of a rechargeable nickel-cadmium cell (nicads), although it has a 1.25-V emf, whereas an alkaline cell has a 1.58-V emf. The radio has a 3.20 resistance.(a) Draw a circuit diagram of the radio and its battery. Now, calculate the power delivered to the radio (b) when using a nicad cells, each having an internal resistance of 0.0400 , and (c) when using an alkaline cell, having an internal resistance of 0.200 . (d) Does this differenceseem significant, considering that the radio's effective resistance is lowered when its volume is aimed up?
The circuit shows R= 1 ohm, Emf1= 12.2 V and Emf 2= 7.1 V. What is the power delivered to the 10R resistor in W? Note: 1.0857 is the correct answer. Show.
A circuit loop containing an external resistor of value R = 25.0 (ohms) is connected to a real battery with an internal emf = 20.0 V that has an internal resistance of R = 1.50 (ohms). How much power is generated by the power supply in Watts?
In a series RC circuit shown, the switch is closed and after a short time, the charge q on the capacitor is 5.2 x 10-5 C. What is the current in the resistor at this time?
A 14[Ω] resistor is connected to a 8.0[V] battery with internal resistance of 2.0[Ω]. What is the power delivered by the emf source?
An emf of 10 V is connected to a series RC circuit consisting of a resistor of 1.90 ✕ 106 Ω and an initially uncharged capacitor of 3.4 ?F. Find the time required for the charge on the capacitor to reach 81% of its final value. s
An emf of 10 V is connected to a series RC circuit consisting of a resistor of 2.0 × 106 Ω and an initially uncharged capacitor of 3.0 µF. Find the time required for the charge on the capacitor to reach 90% of its final value.
In the circuit shown, the battery has EMF of c=32 V. At what rate is thermal energy being generated in the 60 resistor? (Ignore the internal resistance of the battery)
A flash unit for a camera has a capacitance of 1700 μF. What resistance is needed in this RC circuit if the flash is to charge to 90% of its full charge in 21 s?