What quantity of charge must be delivered by a battery with a potential difference of 100 V to do 500 J of work ?

Q: (b) (x'y' + z)' + z + xy + wz (c) A'B(D' + C'D) + B(A + A'CD) (d) (A' + C)(A' + C') (A +B+ C'D) (c) ...

A:

Q: Given: Pt. Q (2,-3,6) and Pt. R(3, 0, -6) Solve for the following: a. Displacement vector (d1) from ...

A:

Q: What is the difference between Analog and Digital?

A: Discuss the difference between Analog and Digital Signals : Analog Signals : Analog signal are cont...

Q: 4. The circuit uses current- (or shunt-) feedback bias. The Si transistor has ICEO = 0, VCEsat =0, a...

A: For the current feedback bias circuit,ICE = 0VCE(sat)=0β=100RC=2kΩVCC=12V

Q: Problem For the circuit shown below, use KCL and KVL to find the current in all branches. A 50 60 13...

A: This question belongs to circuit theory . It is based on the concept of kvl and kcl for calculation ...

Q: (d) Determine the minimum value of Rz to ensure that the Zener diode is in the "on" state. Rs 220 N ...

A:

Q: For the following circuit, where gmV12 is voltage controlled cur source, which is controlled by the ...

A: The solution for the above problem is shown in below steps:

Q: 80 N 40 N 50 V 350N () 750 mA §200 N 1A. Suppose we kill the 50V source, leaving only the 750mA sour...

A:

Q: For the common-base network of Fig. 5.187 : a. Determine (Z i) and (Zo). b. Calculate( Av) and (Ai)....

A:

Q: 2) In the op-amp based difference amplifier shown below, the values of R1, R2, R3 and R. are as indi...

A:

Q: . Given h 2.4 kfl, h 100, h = 4 x 10, and h = 25 µS, sketch the following: Commonaitar hubrid eaival...

A:

Q: 9) The power factor of the 50 volts source is...: b) snity 0.707 lag b) 0.86 lag 00.707 lead c) 0.9 ...

A: For a 50 v source ( dc source) The reactive power is zero(  because the inductor becomes short circu...

Q: (d) Detemine the minimum value of R to ensure that the Zener diode is in the "on" state.

A:

Q: .She dilevered the letters The letters were dilevered The letters was dilevered O The letters is dil...

A: The letters were delivered  Option A  

Q: - VEE Rc RE Cc RL Cc

A: The given circuit diagram is shown below: It is given that: β=100VCC=15 VVEE=4 VRE=3.3 KΩRC=7.1 KΩ

Q: Using a 4-bit signed input P=P3P2P1P0 and a control input Z, use a 4-bit adder and any logic gates t...

A: According to the question, for a 4-bit signed input P=P3P2P1P0 and a control input Z, we need to des...

Q: Define the unit step function find out its Laplace transform.

A: In this case, the unit step function needs to be defined and then the Laplace transform of the unit ...

Q: Example Question 1 A dynamometer-type AC ammeter made of moving coils and fixed coils with a shunt i...

A: Graph-

Q: The voltage across a capacitor with capacitance of 0.05 µF is given by v(t) = cos(27 × 2000t) u(t) V...

A: It is given that: C=0.05 μFvt=cos2π×2000tut

Q: Code: COFFEE. A single-core cable has a conductor diameter of 13.5 mm and insulation thickness of 8....

A: For a single-core cable,The diameter of the conductor is,d=13.5 mmThe thickness of the insulation is...

Q: 1. Importance of studying earth resistance and resistivity. 2. Importance of bringing the earth resi...

A: Given, About the earth resistance.  

Q: Vc RC Q1 NPN RB RE VEE

A: Given

Q: 3. The electric potential caused by a charged disk. A flat disk, radius R, carries a uniformly distr...

A: In the given figure we have assumed a ring of thickness dr with radius r having charge dQ. The charg...

Q: Vcc RB RC Q1 NPN +88 8 Volts VC

A:

Q: Vcc RB RC Q1 NPN +88.8 RE Volts VE

A: We need to find Vcc for given circuit .

Q: A poor conductor is characterized by a conductivity 200 (S/m) and permittivity € = 460. At what angu...

A: We need to find out angular frequency for given condition

Q: The force acting on a pole of 4 Wb is 16 N. Determine the magnetic intensity of the magnetic field a...

A: Magnetic field  (H=)Force/(magnetic flux) Unit of H is (AMP-TURN)/METER. Unit of magnetic flux=weber

Q: Problem For the circuit shown below, use KCL and KVL to find the current in all branches. A 4 12 60 ...

A:

Q: What is the mass of an electron?

A: We need to tell about mass of an electron .

Q: а) If the input to a linear time invariant system d²y(t) + 5 dt dy(t) + 4y(t) = x(t) dt2 Use the Fou...

A:

Q: Use  A.  KVL (include and draw the direction of loops)  B. KCL (include and draw the direction of ...

A: In this question,  We need to determine the current in the load resistance ZL . i.e current io   All...

Q: I need the answer quickly for 10 minutes In clear and understandable handwriting please

A:

Q: Calculate the value of RB in ohms. at VE=4V, RE=363 ohm, IB=13uA, RC=2176ohm and VCE=11V

A:

Q: The nameplate of a squirrel-cage induction motor has the following information: 25hp, 220V, 3-phase,...

A:

Q: Define the unit step function

A:

Q: Simplify the following Boolean expressions to a minimum number of literals: (a) ABC + A'B + ABC' (c)...

A:

Q: A SOMA

A: The number of NAND/NOR gates required for a full adder will be 9. that is why NAND/NOR gate also cal...

Q: 1. Design a Common Emitter Amplifier with Voltage Divider Bias for the following parameters: vccC = ...

A:

Q: ym emf = p(u x B) - dl (motional emf). (6.26) %3D Only those segments of the circuit that cross magn...

A: To analyze the electrical and magnetically circuit, Motional emf ,Ampere circuital law, Lenz law, Fa...

Q: .She dilevered the letters The letters were dilevered O The letters was dilevered O The letters is d...

A: The letters were dilevered.  Option A .  

Q: 1. What is the barrier potential of a silicon diode when the temperature is 100°C. ANS. Vf = 0.55V 2...

A: Given, Two problems with answer. We have to find the steps and write. Please find the below attachme...

Q: Question 2 A circuit has a voltage of 5020 V and a current of 52-10 A. The angle of the circuit's im...

A: Given, Voltage, V=50∠0° V Current, I=5∠-10 A  

Q: S01 and 02 base

A: Diode- When diode is forward biased it is short circuited in a circuit ideally. When diode is revers...

Q: Using three D flip-flops and a PLA implement a 3-bit Gray code up/down counter. The single- bit inpu...

A: The solution is given below

Q: 6. A 6-pole DC generator with duplex lap winding has 48 slots and four elements per slot. The flux p...

A: Given, In a DC generator Poles, P=6 Duplex lap winding with 48 slots and four elements per pole. Flu...

Q: Battery

A: On bread board if we move horizontally then the voltage will be different. On bread board if we move...

Q: ime invariant/ I ime variant

A:

Q: 56. Determine Ig and Vc for the network of Fig. 4.152. +8 V 3.3 ka B- 110 3.9 ka 0-12 V Ve FIG. 4.15...

A:

Q: The 50 turns is connected to a 240V, 60Hz ac source. A load of 26 ohms is connected across the whole...

A: The autotransformer with the given specification is shown below:  The parameters of the input side ...

Q: 1-DO you need a repeater station if we used optical cable under the sea level? And why?

A: If we used optical cable under sea level then there is a chance that it lose or reduce its signal. R...

Dielectric Breakdown

A dielectric is a material with low electrical conductivity and so is classified as an insulator. Dielectric materials are used to block the flow of electricity through them, allowing them to behave as an insulators. They can also be used to store electric charge or improve capacitance.Dielectrics have no free electrons for conduction because electrons are tightly bound to the nucleus. Because dielectrics contain a small number of electrons for electrical conductivity, they have a dipole. The two primary roles of dielectrics in electrical devices are insulation and electrical energy storage. An electric field polarizes the dielectric, and the polarization of the molecules allows dielectric materials to store charge.