What similarities and differences exist between Japan's methods for managing both hazardous and municipal solid wastes?

Q: This occurs when the body rotates about an axis that passes through the body or about an axis at…

A: If the object motion in the form of spinning with respect to the fixed imaginary strain line called…

Q: A 30⁰ 30° radius B At the instant shown, the roller has velocity and acceleration of 3 m/s downward…

A:

Q: 3) The overhanging beam supports the loads as shown in the figure. Determine the value Ely at point…

A:

Q: It is the study of motion without reference to the forces which cause the motion.

A: given data: it is the study of motion without reference  to the forces which cause motion.

Q: Urquhart Castle in Scotland; research a specific element of defensive fortifications,

A: When it was completely intact, Urquhart Castle was one of the biggest castles in Scotland.

Q: Q3/ Water flows through a pipe at 5 L/s, as shown in Fig. 3. If the gauge pressures of 12.5 kPa,…

A: Q = 5L/s = 0.005 m3/s  A1 = A2 = A = π/4x 0.052 = 0.00196 m2 A3 = π/4x0.032 = 0.0007 m2 v1 = v2 =…

Q: Compute the vertical offset at a point on the curve 100m from the PVC.

A: Answer Based on the given data, we can determine the Vertical offset at a point on the curve 100 m…

Q: When a round bar material with diameter of 37.5 mm, length of 2.4 m, Young's modulus of 110 GN/m²…

A: Given:Young's modulus of elasticity, E=110 GN/m2Shear modulus, G=42 GN/m2diameter of bar, d=37.5…

Q: Two gage marks are placed exactly 250 mm apart on a 12-mm diameter aluminum rod. Knowing that, with…

A:

Q: Consider the following data for concrete with mild exposure Water-cement ratio = 0.50 Water = 191.6…

A:

Q: horizontal th

A: solution of above problem is below.

Q: 2. Water exits into the atmosphere (Patmos=101kPa) through a split nozzle as shown in figure 2. Duct…

A: Given data:-  The area of the duct in section (1), A1=200 cm2=0.02 m2 The area of the duct in…

Q: 8.a. Equipment rated at 1200 A or more and more than six feet wide that contains overcurrent…

A: Given data- 8(a) 1200 A rating6 ft or more in width

Q: 4) An overhanging beam supports the loads as shown in the figure. If EI = 3000.65 kN - m², determine…

A:

Q: The solid shaft is fixed to the support at C and subjected to the torsional loadings and axial load…

A: Hi! Thank you for the question As per the honor code, We’ll answer the first question since the…

Q: A cantilever beam with length L = 4 m carries a concentrated load P =29 kN at the free end. The beam…

A:

Q: 3.5 m A C 5.5 m 0.2 m B D G In the figure above, the jib crane is supported by a pin at C and rod…

A: As per guidelines we need to answer only first 3 subparts of questions so please repost rest…

Q: The ends of the compound shaft are attached to rigid walls. The maximum shear stress is limited to…

A:

Q: A system of four loads 80, 160, 160 and 120 kN crosses a simply supported beam of span 25m with the…

A: Given Data P1=120 KNP2=160 KNP3=160 KNP4=80 KNAll the given loads are equally spaced at 1m.The span…

Q: downstream is observed to be 4.5 ft. Estimate the manning n cofficient of this channel.

A: Given: Discharge, Q=300 cfs Width ,b=10 ft Depth, d=6 ft Slope, S=0.0005 ft/ft Manning coefficient,…

Q: Calculate the speed of the tip of a 67m blade on a horizontal axis wind turbine rotating at 20…

A:

Q: A density fluid phas filled through a tank of diameter, D at a constant rate of V. The bottom of the…

A:

Q: A thin polymer plate PQR is deformed such that corner Q is displaced downward 0.0525-in. to new…

A: Given data a = 9 in. , b = 1 in.,  c = 3 in., and Δ= 0.0525 in.

Q: What are the points of convergence and divergence in the approaches to waste management hazardous…

A: Convergence and divergence in the approaches to waste management  Even in the developed countries…

Q: The log is being towed by two tractors A and B. Determine the magnitudes of the two towing forces FA…

A: Given :

Q: 3) The simply supported beam with the cross-section as shown supports a total uniformly distributed…

A:

Q: Gentry Waterjet до Bexit figure 1. The horizontal reaction on the deflector (in Newton) is_ The…

A: Given values: Velocity of jet = V m/s  Flow rate, Q = 70 l/sec= 0.07 m3/s θentry = 8°θexit = 24°…

Q: As a train accelerates uniformly it passes successive 800 meter marks while traveling at velocities…

A:

Q: It is formed between the horizontal (earth) and the rope a) twisting b) angle of attack c)Incidence…

A: Brief concept introduction- When a rope is placed at an angle to the horizontal surface of the…

Q: A tensile test is conducted on a bar whose cross-section is 12mm thick by 100mm wide. An axial…

A:

Q: Q1/ For the setup shown in Fig. 1, what is the gauge pressure PA, if the specific gravity of the oil…

A:

Q: Two gage marks are placed exactly 250 mm apart on a 12-mm diameter aluminum rod. Knowing that, with…

A:

Q: The culturable command area of a canal is 10,000 ha. The area grows only two crops-rice in the…

A:

Q: A force P = 70 kN is applied at the plate-bolt connection shown. Determine the required diameter in…

A:

Q: For item 1 to 4. The following data represent a set of 10 experimental runs in which two independent…

A: Solution: Y X1 X2 61.5 2400 54.5 61.2 2450 56.4 32 2500 43.2 62.5 2700 65.2 31.5 2750…

Q: Determine the magnitude of the pin force at A. Assume W - 665 lb, a-2.6 ft. b-2.2 ft, r- 9 in. W…

A: GIVEN DATA:-⇒W= 665 lb⇒a= 2.6 ft⇒b= 2.2 ft⇒r= 9 in

Q: Example 8.10 For a head of 25 cm on a 90° V-notch, what error in the measured heac produce the same…

A:

Q: 2) The structure as shown supports the horizontal force F = 30 kN. Determine the safe diameter of…

A:

Q: Simple Curve A railway curve is to connect intersecting tangents with the following design data:…

A:

Q: 250 cu.m-Column, 185 cu.m-concrete pavement, how many samples? And what type of sample? 2. 750…

A: 1. 7samples of column and 6 samples of concrete pavement

Q: A 6m simply supported beam carries four equal wheel loads of 15kN each spaced at 1.5m, 2m and 15.m…

A: For rolling load passing over simply supported beam maximum ordinate of ILD of shear force is…

Q: A a B V P b X h

A:

Q: Draw the shear and bending moment diagram of each beam loaded as shown. Show complete solutions for…

A: Given data in question  UDL  Point load  Concentrated moment  Span member length  To find out  SFD…

Q: ar has diameter di = 15 mm and mm. Forces P1, P2 and P3 act on hi. IC D

A:

Q: ameter 100 mm is us essure at inlet is 0.18 he throat is 280 mm

A:

Q: Example 7.17 A sub-marine moves horizontally in sea and has its axis 15 m below the surface of…

A:

Q: 4kN/m 4m 2kN/m

A:

Q: The alimak construction elevator starts from rest at the first floor of the building. It can…

A: The given data is as follows: Acceleration=5 ft/s2Deceleration=2 ft/s2Total distance traveled by…

Q: An intersection has a three-phase signal with the movements allowed in each phase and corresponding…

A: Given Data: The number of phases is 3. The lost time per second is 4 seconds. The v/c ratio for the…

Q: Rigid beam AB is supported by three bolts at A and a pin at B. The bolts at A are in double shear…

A:

Collection Systems

The collection systems form a part of sanitary engineering, which is a sub-branch of civil engineering. It is also known as public health engineering and wastewater engineering. It is a methodology followed to remove and properly dispose of human waste, along with creating systems to provide safe and clean usable water. These measures ensure a hygienic and disease-free community. Sanitary engineering, apart from building sewer disposal units, is also involved in plumbing, fire protection, hydraulics, life safety, environmental protection, information technology, microbiology, pathology, and so on.