What the pressure at point a in \16 mmHg, if liquid A has SG = 1.20 and %3D liquid B has SG = 0.75. The liquid surrounding point a is water, and the tank on the left is open to the atmosphere. Known SG for mercury=13.6

What the pressure at point a in \16 mmHg, if liquid A has SG = 1.20 and %3D liquid B has SG = 0.75. The liquid surrounding point a is water, and the tank on the left is open to the atmosphere. Known SG for mercury=13.6

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: The deepest point in the ocean is 11 km below sea level, deeper than Mt. Everest is tall. Part A…

Q: A soap bubble 50 mm in diameter contains a pressure (in excess of atmospheric) of 2 bar. Find the…

A: Given data Diameter of soap bubble= 50mm=0.050m Thus radius of bubble, r=0.025. Change in pressure,…

Q: Pascal = (0.01 bar, 0.001 bar,0.0001 bar, 1O 100.000 bar)and T= 500 rankine what is the value in…

Q: An oil of specific gravity 0.92 is flowing through the pipe of diameter 30cm. one end of the simple…

Q: 27. In fig. below, fluid A is water (PH = 62.1lb/ft), fluid B is mercury (PH 0.488 lbm/in'). Local…

A: Note Unit conversion- 1 ft =12 inch lbm-ft/s^2=lbf Lbf/in^2= psi

Q: 1. If the level of the liquid measured by using capacitive probe and buoyant force is same, find the…

A: Buoyant force: It is the force applied on the object when any object is fully or partially submerged…

Q: A tire has a volume of 3.0 ft3 and a ‘gage’ pressure of 32 psi at 75°F. If the ambient pressure is…

Q: A circular observation window, 6 feet wide in diameter is to be placed near the bottom of a pool 10…

Q: b) A cylindrical tank contains water at a height of 55 mm as shown in Figure 1. Inside is a smaller…

A: The gauge pressure PA and height of kerosene in the smaller tank is required to be calculated as…

Q: A certain gas at temperature equivalent to 24 degrees Celsius at 7 cu.m and 180 kPa is compressed to…

Q: A piece of lead (sp. Gr. 11.3) is tied to a 130 cc of cork whose specific gravity is 0.25. They…

A: Given: density of lead=11300 Kg/m3 density of cork=2500 Kg/m3 V=130 cm3 =0.000130 m3

Q: Example: If the pressure inside a storage tank is 0.9 atm at sea level , then what is the gauge…

Q: a. What is the specific weight of air above at a room temperature of 30°C and a pressure of 470 kKPa…

A: Ideal gas equation PV = nRT is used to get the solution.

Q: A U-tube manometer with one arm open to atmosphere is used to measure the pressure of kerosene…

Q: a piece if metal weighs 350 N in air nad 240 N in water. What is the specific gravity of the metal

Q: atmospheric pressure at sea level under standard condition is _ inches of mercury (Hg) or _ pounds…

A: Solution: Standard sea-level pressure, by definition, equals 29.92 inches of mercury, 14.70 pounds…

Q: Calculate the pressure of an oil of sp.gr. 0.8, and a mercury of sp.gr. 13.6 in N/cm3

Q: At 20 ° C gage A reads 350 kPa absolute. What is the heighth of the water in cm? What should gage B…

A: Given Data: Absolute pressure at A is PA = 350 kPa. Temperature of system is T = 20 °C. The height…

Q: Calculate the pressure difference between P1 and P2. The specific gravity of mercury is 13.6 and…

A: GivenSGhg=13.6SGgl=1.26

Q: A piece of lead (sp. Gr. 11.3) is tied to a 130 cc of cork whose specific gravity is 0.25. they…

Q: 5. A small bubble of air in water (y= 0.073 N/m) has a radius of 0.10 mm. Find the difference in…

A: The fluid problem may be solved as :

Q: A learn-us-east-1-prod-fleet02-xythos.content.blackboardcdn.com Content…

A: Calculated pressure difference ( PA - PB ).

Q: QUESTION 2 By using Figure 2, calculate the pressure at Point A. Given SG oil 0.85 and SG mercury…

Q: A nitrogen cylinder has a volume of 1 cu ft and a pressure of 100 psig @ 25 degrees C. What is the…

Q: 10. The glass tube in figure below is used to measure pressure p, in the tank. The tube diameter is…

Q: Example 2: If the atmospheric pressure is 760 mmHg, what is the gas pressure in the manometer: (a)…

A: Given Data Patm= 760 mmHg

Q: 2a. Define pressure in a gas (words and equation) and show that 1 pascal = 1 kg/m∙s2. b. The pascal…

Q: 3. A quart of SAE 30 oil at 68°F weighs about 1.85lb. Calculate the oil's (a)specific weight,…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: In Fig. , if pressure gage A reads 20 lbf/in 2 absolute,find the pressure in the closed air space B…

A: Given data as per question Reading of pressure gage A = 20 lbf/in 2 SG of oil = 0.827 Calculations…

Q: model of size 1/10 kN/m². The mod pressure drop in th Density of water =

Q: A certain gas at temperature equivalent to 24 degrees Celsius at 10 cu.m and 160 kPa is compressed…

A: Find the resulting pressure .

Q: 15. A boiler installed where the atmospheric pressure is 752 mm Hg has a pressure of 12 kg/cm2. Find…

Q: A piece of lead (sp. Gr. 11.3) is tied to a 130 cc of cork whose specific gravity is 0.25. They…

Q: Methane is stored in a tank at a pressure of 291,890 Pa and a temperature of 279 Kelvin. The ambient…

Q: A wooden buoy of sp gr 0.75 floats in a liquid with sp. gr 0.85 What is the percent of the volume…

Q: Q) Submarines use principle of 'neutral buoyancy' to go into * .the water

A: Neutral buoyancy means that the water displaced by submarine is equal to weight of submarine.

Q: A weather report indicates the barometric pressure is 29.75 in of mercury. What is the atmospheric…

A: Specific weight of water = 62.4 lb/ft3 Relative density of mercury= 13.6 Manometric height = 29.75…

Q: You are performing a pressure/elevation calculation is US units using the specific weight of water…

A: Pressure unit can be converted by putting 1ft = 12 inch

Q: An oil drop with the diameter of 1mm, is in the contact with the air with the pressure of 80 KN/m2.…

A: Basics of Fluid mechanics are used.

Q: 24. Fluid A is H2o (PH,, = 62.1 lb,m/ft³) while fluid B is mercury (Phg = 0.488 lbm/in³), compute…

Q: An open tank contains water up to a depth of 1.2m from the bottom and above it mercury for a depth…

Q: Example: The pressure inside a tank is 4.2 atm. What is the gauge pressure inside the tank?

Q: The center of pressure is equal to the total pressure force in case of a vertical plane surface…

Q: You have a cube, 1.0 meter on a side. It is submerged in a fluid of density of 1500 kg/m³. One side…

Q: If air is at pressure P of 3200 lb/ft2 and a temperature T of 800R degrees, what is the specific…

A: Given data: P=3200 lb/ft2T=800 °R Need to determine the specific volume.

Q: 1. A RESERVOIR OF CARBON TETHRACHLORIDE (CC14) HAS A MASS OF 500 kg. AND A VOLUME OF 0.315m3. FIND…

A: Given data Mass of Carbon Tetrachloride in reservoir= 500 kgVolume of reservoir = 0.315 m3We have to…

Q: A solid wood cylinder of specific gravity 0.6 is 600 mm in diameter and 1200 mm high. If placed…

Q: An object was submerged in water. Given the following parameters, calculate the buoyant force and…

Q: spherical contaln 5. A barrel contains a 150 mm layer of oil floating on water that is 300 mm deep.…

A: According to our guidelines, In case of multiple questions we are supposed to answer the first…

Question

نقطة واحدة
What the pressure at point a in \16
mmHg, if liquid A has SG = 1.20 and
liquid B has SG = 0.75. The liquid
surrounding point a is water, and the
tank on the left is open to the
atmosphere. Known SG for
mercury=13.6
Liquid A
0.9 m
-0.25 m
Water
0.125 m
0.4 m
-Liquid B
Less than 25 mmHg
Equal to 25 mmHg
Greater than 25 mmHg.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

pllllzzzz help me right nowww plzzz The belt moves at a steady velocity V and skims the top of oil tank. Assuming a linear velocity profile in the oil, what is the required belt-drive power P (watt) (P= power = force x Velocity) if the belt moves at 3.5 m/s over oil with specific gravity of S=3.6 and oil viscosity of 0.004 m2/s. Belt geometry L= 2 m, b = 60 cm, and oil depth is h = 3 cm?
plzz help meeeeeeeeee The belt moves at a steady velocity V and skims the top of oil tank. Assuming a linear velocity profile in the oil, what is the required belt-drive power P (watt) (P= power = force x Velocity) if the belt moves at 3.5 m/s over oil with specific gravity of S=3.6 and oil viscosity of 0.004 m2/s. Belt geometry L= 2 m, b = 60 cm, and oil depth is h = 3 cm?
To what height will 68˚F ethyl alcohol rise in a 0.005 in internal diameter glass capillary tube? The density of the alcohol is 49 lbm/ft3 note ? = 0.00156 ???/ ?? and ? = 0°.
U - tube is used to pressure the difference in water channel. p1= 1000 kg/m3. The orange fluid in the U - tube has a density: p2= 2000 kg/m3. The height a = 10 cm and h = 15 cm. If the pressure at point ① is 111 kPa, what is the pressure at point ② ?
A narrow, U-shaped glasstube with open ends is filled with25.0 cm of oil (of specific gravity0.80) and 25.0 cm of water on oppositesides, with a barrier separating theliquids (Fig.). (a) Assume thatthe two liquids do not mix, and find thefinal heights of the columns of liquid ineach side of the tube after the barrier isremoved. (b) For the following cases,arrive at your answer by simple physicalreasoning, not by calculations:(i) What would be the height on eachside if the oil and water had equal densities? (ii) What would the heightsbe if the oil’s density were much less than that of water?
Calculate the density of water vapor at 350 kPa abs and 20C if its gas constant is 0.462 kPa-m3/kg-K
A closed tank contains 1.5 m of SAE 30 oil, 1m of water, 20 cm of mercury, and an air pocket in its upper part, all of them at 20 ° C. The absolute pressure at the bottom of the tank is 60 kPa. What is the pressure in the air bag?
In a fluid 1 is oil (sg=0.87) and fluid 2is glycerine at 20 degrees Celsius (w=12360N/m cubed) if Patm=98kpa determine the absolute pressure at p1 Here is the diagram in the picture below
a scaled tank cintaining sea water to a height of 12m also contain air above the water at gage pressure of 5 atm, water flow out from the bottom through a small hole. calculaye the efflux speed of the water, psw = 1.03x10 kg/m
(D1) The client is considering the use of a manometer to measure the differential pressurebetween Tank A and Tank B for operational purposes.a) Given:s.g of A = 1.3s.g of B = 1.7s.g of manometric fluid = 1.9h1 = 1.45m, h2 = 0.75m and h = 0.4mExplain how the manometer depicted can be used to find the differential pressure between Tanks A andB. Additionally give two (2) limitations of using a manometer to measure pressure.
FLUID MECHANICS: HYDROSTATICSShow the complete solution.Any method maybe used for those problems which do not specify a methof Answer: 13.734 kPa
Consider a soap bubble of diameter 3 mm. If the surfacetension coeffi cient is 0.072 N/m and external pressureis 0 Pa gage, what is the bubble’s internal gage pressure?( a ) - 24 Pa, ( b ) + 48 Pa, ( c ) + 96 Pa, ( d ) + 192 Pa,( e ) -192 Pa