What unique type of electrical protection is required for all 120-volt, single-phase, 15- and 20-ampere branch circuits in certain habitable rooms and areas in new dwellings? Where in the NEC is this requirement found?

What unique type of electrical protection is required for all 120-volt, single-phase, 15- and 20-ampere branch circuits in certain habitable rooms and areas in new dwellings? Where in the NEC is this requirement found?

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter9: Lighting Branch Circuit For The Master Bedroom

Section: Chapter Questions

Problem 2R: What unique type of electrical protection is required for all 120-volt, single-phase, 15-and...

See similar textbooks

Related questions

Q: 4. What terms describes an overcurrent protective device having an interrupting rating in compliance…

A: According to article 110.9 of the NEC, Circuit breaker describes an over-current protective device…

Q: If a recessed fixture without an approved junction box is installed, what extra wiring must be…

A: According to NEC code 410.115(C), a recessed fixture with an approved junction box is used for…

Q: What color fluorescent lamps are recommended for residential installations?

A: A good problem on types of fluorescent lamps used in various places. Have a look at the below…

Q: When installing a telephone system in a building, a conduit is installed in a riser. Is it okay to…

A: The most preferable method used in horizontal cable Installation for communication cabling is by…

Q: What switch type and rating is required to control five 300-watt tungsten filament lamps on a 120-…

A: Suppose all the bulbs are connected in parallel to the 120 V supply. The resistance of each bulb is,

Q: Why is it important, when soldering connectors onto a piece of electronic circuitry, to leave no…

A: Given: Soldering of connectors

Q: What color fluorescent lights are recommended for residential installation?

Q: Show the connections for a ceiling outlet that is to be controlled from any one of three switch…

A: The given figure consists of the 120 V source, two three-way switch, and one four-way switch. it is…

Q: Assume a bank of heating strips is rated at 22 KW and is connected to 240 volts. The heat strips…

A: Obtain the total current flowing through the heat strips. I=PV=22×103240=91.67 A

Q: Are plug fuses(Type S) permitted to be installed in a switch that disconnects a 120/240-volt clothes…

A: Yes, Type S fuse is permitted to be installed in a switch that disconnects a 120/240 volt clothes…

Q: Which fuse amperage scheme is suitable for selective protection, starting with a home's electrical…

A: In home electrical power table, fuse rating should be around 100A. Because now days we are generally…

Q: What is the 277-volt–single-phase–60-hertz system used for? Select one: A. RECEPTACLE BRANCH…

A: 277-volt–single-phase–60-hertz system has the voltage of 277 volt- and frequency of 60 hertz it is…

Q: What is the purpose of the NEC®?

A: NEC stands for National Electrical Code. It was developed in 1897.

Q: What code sets standard for the electrical installation work?

A: We habe to find code for electrical installation work

Q: If you are going to choose between a fuse and a circuit breaker as a disconnecting means, what will…

A: - Fuse and circuit breakers are the components used in electrical power system for protections…

Q: The nec requires what type of unique protection for all 120-volt 15- and 20- ampere branch-circuit…

A: NEC stands for National Electrical Code. The National Electrical Code is part of the National Fire…

Q: Does the code permit bare fluorescent lamp luminaries to be installed in closets?

A: Given, Does the code permit bare fluorescent lamp luminaries to be installed in closets?

Q: what wire size is needed on a one 20 amp, 120-volt bathroom circuit? what wire size is needed on a…

A: Proper wire size is an important fact to be considered in any of the electrical wiring installation.…

Q: How many cables enter the wall switch box located next to the side garage door?

A: Appliances installed in garages are generally controlled by switches that are located at three…

Q: How does the NEC specify that the high leg of a four wire delta connection be marked?

A: The circuit of the four wire open delta connection transformer with one winding secondary centre…

Q: What is the branch circuit protective device?

A: Branch circuit protective device is used to protect the motor winding and insulation if due to some…

Q: Does compliance with the NEC always result in an electrical installation that is adequate, safe, and…

A: NEC stand for National electrical code which is basic standard code and it sets the standards for…

Q: what switch type and rating is required to control five 300 watt tugsten filament lamps on a 120…

Q: What is the largest voltage drop in the wires that is allowed by the code?

A: As per the NEC keeping in mind about the performance issue. The NEC recommends the largest voltage…

Q: what wire size is needed on a one 20 amp, 120-volt water pump circuit?

A: Cable size for to carry 20 amp, 120v

Q: Identify and explain the safety procedures and precautions that should be followed for fire…

A: Procedure that is used to install cable in buildings are as follows:- Electrical conduction for…

Q: What is the scope and Limitation of fence lighting with Alarm circuit?

A: It is a type of electro-electric device which is use to trigger the relay for the operating the AC…

Q: List THREE examples of situations/conditions in which a Neutral wire (Grounded Circuit Conductor) is…

A: A neutral wire is installed at specific lighting switch location to pass the excess current to the…

Q: How many conductors are required to address eight devices? Do those devices need to connect with the…

A: Three conductors are required to adress 8 devices because by using three bits we can form 8…

Q: 8. What are the common protective links for electrical control lines and what electrical components…

A: Various protective devices or links are used in the electrical control line of the power system.…

Q: How far must mechanical protection be provided when underground service conductors are carried up a…

A: The Underground Conductor are electric conductor insulated and placed under the surface of the…

Q: Where is the Service Entrance Panel located?

A: A residential lighting layout plan is shown in the question. We need to find out in which area is…

Q: what wire size is needed on a one 30 amp, 120/240-volt electric clothes dryer branch circuit? what…

A: The proper selection of wire size is an important factor to be considered in any electrical wiring…

Q: The Code places a maximum open-circuit voltage on lighting equipment in or on homes. This maximum…

A: The maximum open circuit voltage on lighting equipment in homes are 1000 V.

Q: How many spaces does a 3-pole circuit breaker take up in an electrical panel?

A: Three pole circuit breaker is mostly used in commercial facilities, workshops and factories where…

Q: What code sets stabdard for the electrical installation work?

A: In the following section, the code which sets standards for electrical installation work has been…

Q: Which room makes use of Split-Circuit receptacles?

A: A lighting layout for a residential floor plan is shown in the question. We need to find out which…

Q: What is the purpose of the NEC?

Q: A ____shall be used to connect the equipment grounding conductors, the service equipment enclosures,…

A: Given, 3 multiple choice questions related to national electrical code.(NEC). Please find the below…

Q: Which method is BEST practice to prevent unknowing individuals from energizing an electrical circuit…

A: The electrical power is transferred from the generation side to the consumer end. The power which is…

Q: Who has the responsibility for Code interpretations? When are rules in the PEC mandatory and when…

A: 1. Who has the responsibility for Code interpretations? Answer : As per NEC, section 90.4 and…

Q: Airframe Electrical System Question: What is the maximum acceptable voltage drop from the voltage…

A: The maximum acceptable voltage drop from the voltage source to the utilization equipment's ground in…

Q: Electricla Wiring Residential How many bell wires terminate at the transformer, the front hall…

A: a). At the transformer, the number of bell wires terminating is 2. b). The number of bell wires…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

The NEC requires what type of unique protection for all 120-volt, 15- and 20-ampere branch-circuit outlets in bedrooms of residential homes? In which section of the NEC is this requirement found? _____________________
what wire size is needed on a one 20 amp, 120-volt laundry branch circuit? what wire size is needed on a one 20 amp, 120-volt garbage disposal circuit?
The nec requires what type of unique protection for all 120-volt 15- and 20- ampere branch-circuit outlets in bedrooms of residential homes?
what wire size is needed on a one 20 amp, 120-volt bathroom circuit? what wire size is needed on a one 40 amp, 120/240-volt electric range branch circuit?
For laundry equipment in basements, what sort of electrical circuitry is required by the Code? ________________
a. The Code requires a minimum of two small-appliance circuits in a kitchen. Is it permitted to connect a receptacle in a dining room to one of the kitchen small-appliance circuits? _______________ What Code section applies to this situation? _______________ b. Are outdoor weatherproof receptacles permitted to be connected to a 20-ampere small-appliance circuit? _______________ c. Receptacles located above the countertops in the kitchen must be supplied by at least _______________ 20-ampere small-appliance circuits.
What is the Code requirement for receptacles connected to circuits of different voltages and installed in one building?_____________________
Where in the NEC would you look for the installation requirements regarding flush and recessed lighting luminaires?
How many lighting branch circuits are provided in this dwelling? __________ a. What is the minimum load allowance for small-appliance circuits for dwellings? See NEC 220.52(A). __________ b. An individual 15-ampere branch circuit is run to the receptacle outlet behind the refrigerator instead of connecting it to one of the two 20-ampere small-appliance branch circuits that are required in kitchens. For this separate circuit, an additional 1500 volt-amperes (shall) (does not have to) be added to the load calculations for dwellings. (Circle the correct answer.)
Which of the following installations for a kitchen waste disposal that operates on a 15-ampere, 120-volt branch circuit requires AFCI protection? (Circle the correct answer.) a. The disposal operates by a switch that is installed above the kitchen counter. b. The disposal operates by a switch that is installed under the counter next to the disposal. c. Both (a) and (b) d. Neither (a) nor (b).
What is the 277-volt–single-phase–60-hertz system used for? Select one: A. RECEPTACLE BRANCH CIRCUITS B. LIGHTING BRANCH CIRCUITS C. MOTOR BRANCH CIRCUITS D. RESIDENTIAL BRANCH CIRCUITS
Are plug fuses(Type S) permitted to be installed in a switch that disconnects a 120/240-volt clothes dryer? If so why or why not?