what switch type and rating is required to control five 300 watt tugsten filament lamps on a 120 volt circuit? show calculations

Q: What color fluorescent lamps recommended for residential installation

A: White color fluorescent lamps recommended for residential installation .

Q: tch 1 ++ Switch 2 Switch 3

A:

Q: 1. Explain why the bedroom light becomes a bit dimmer when an air- conditioning unit is turned on?

A: Bedroom  lights become a bit dimmer when an air conditioning unit is turned on  because when when AC…

Q: List down the different types of Cables.

A: Dependig on the purpose of use cables are classified in to five types1)Shielded cables2)Fibre optic…

Q: There is a 3 way switch in the bedroom hallway leading into the living room. Show your calculations…

A: Using NEC table 314.16(A) Total number of conductor used for the 3 way switch in the bedroom hallway…

Q: What switch type and rating is required to control five 300-watt tungsten filament lamps on a 120-…

A: Suppose all the bulbs are connected in parallel to the 120 V supply. The resistance of each bulb is,

Q: What current does a 3/4-hp air conditioning unit draws when it plugged to a 220-volt outlet?

A: The detailed answer is solved below according to the given parameters and instructions in the…

Q: Assume a bank of heating strips is rated at 22 KW and is connected to 240 volts. The heat strips…

A: Obtain the total current flowing through the heat strips. I=PV=22×103240=91.67 A

Q: Are plug fuses(Type S) permitted to be installed in a switch that disconnects a 120/240-volt clothes…

A: Yes, Type S fuse is permitted to be installed in a switch that disconnects a 120/240 volt clothes…

Q: A ____________is the name given to a switch- ing circuit when the feed is brought to the lighting…

A: A switching arrangement where the feed is brought to the lighting outlet first and a two-wire cable…

Q: A long, inexpensive extension cord is connected from inside the house to a refrigerator outside. The…

A: The resistance of the extension cord depends on, R=ρlA Here, ρ is the resistivity of the cord, lis…

Q: Calculate the ammeter reading in the electrical circuit?

A: Use Kirchhoff’s current law,

Q: what is  the largest size overcurrent protection device (fuse or breaker) allowed to protect the…

A: Concept: The circuit which is used to electrically describe and model either continuous materials or…

Q: A single-phased load is located 2800 ft from its source. The load draws a current of 86 A and…

A: Maximum voltage drop is 3% Edrop=480×3100=14.4 V So maximum allowed resistance is…

Q: Refer to the National Electrical Code or the working drawings when necessary. Where applicable,…

A: We are authorized to answer one question at a time, since you have not mentioned question you are…

Q: Technician A says electronic transmission controls can malfunction if not provided with a good…

A: The electronic controls are governed by a good voltage source which plays an important role in…

Q: DETERMINE THE PROPER SIZE CONDUCTORS for a 500 watt load that is located 100 ft from a 250 volt…

A: Given,THe output power is,Pout=500 WAt panel board the voltage is,V=250 VThe distance between load…

Q: A cable has a VSWR of 10. If the minimum voltage along the cable is 20 volts, what is the maximum…

A:

Q: Draw wiring layout for controlling Lamp A and Lamp B by Switch AB .

A: This type of layout is used in top and bottom of a staircase at homes , corridors or wherever…

Q: Using the image above, what type of contact is used to turn on the "LIGHTS"?

A: here as shown in the ladder diagram two switch S1 and S2 are used to turn off or on the Lights.

Q: Conductors other than service conductors must not be installed in the same____. A. Service raceway…

A: From Article 230 of National Electric Code (NEC), the following information can be…

Q: List THREE examples of situations/conditions in which a Neutral wire (Grounded Circuit Conductor) is…

A: A neutral wire is installed at specific lighting switch location to pass the excess current to the…

Q: If you were to place your meter in parallel with a set of closed switch contact that had 120 volts…

A: Assuming there is no resistance in the path, the situation has been shown in the circuit diagram…

Q: Is the connection to a circuit breaker wired in series or parallel? Explain

A: This question belongs to power system . It is based on the protection system . Circuit breaker is an…

Q: When seeking to measure the voltage of a wall outlet (120 Volts AC) an electrician needs to do the…

A: Simpson 260 is an analog volt ohm milliammeter  that can used to measure voltage current and…

Q: 10. Where a single-phase, 240-volt air-conditioning unit has a full-load current rating of 35…

A: AWG means American Wire Gauge, It is the standard form of selecting wire gauges based on different…

Q: what wire size is needed for a one 20-amp, 240-volt water pump

A:

Q: How much resistance should be connected in series with a 50-ohm lamp rated 2A if it is to be used in…

A:

Q: Is it possible to use one way switch in Two location control of lamp? Explain.

A: To explain  Is it possible to use one way switch in two location control of lamp?

Q: What code sets stabdard for the electrical installation work?

A: In the following section, the code which sets standards for electrical installation work has been…

Q: Calculate the minimum copper conductor size needed for 120/240 V electric range branch circuit the…

A: Given data:                Voltage rating=120/240 VPower rating P=12kWMinimum voltage rating…

Q: 10. Where a single-phase, 240-volt air-conditioning unit has a full-load current rating of 35…

A: From the AWG standard chart,

Q: 20.a. What's the maximum number of switches or circuit breakers the service-disconnecting means may…

A:

Q: Fuses are intended to protect the house wiring, not people.

A:

Q: difference betwwen fuse and circuit breaker ?

A: Fuse : A fuse can be defined as an electrical safety device which protects an electrical circuit…

Q: Which type of switch is used to connect the bell circuit? O a. SPDT Detent ype O b. One way switch…

A: In this question , we will write the switch uses in bell circuit...

Q: Electrical Wiring (Wiring Diagram and Schematic Diagram) 1.Create or draw a  wiring layout ( wiring…

A: Wiring Diagram

Q: 5.a. Typically, the bonding conductor installed between the panelboard equipment grounding terminal…

A: 5.a) Typically, the bonding conductor installed between the panelboard equipment grounding terminal…

Q: Determine the proper size of copper wire conductor necessary to apply a 750 W electric motor that is…

A: It is given that: P=750 WL=100 feetVpanel=120 voltsVdrop=1.2 volts

Q: What code set standard for electrical installation work

A: The NEC provide code set standard for electrical installation work. NEC- National Electrical Code

Q: determine the correct box size for each of the following conditions: 1. A conduit run serving a…

A: As per the given condition, A conduit run, that connects three circuits and serves a series of…

Q: 18. A suitable disconnecting means for a fixed appliance is a A. pigtail cord. B.light switch that…

A: Pigtail cord is used for terminating the end of long run wire hence option A is incorrect. The light…

Q: A three phase electric motor is located 1000 feet from the panel. The motor draws 20 amps and is…

A: Adding length to a conductor has the same effect as connecting resistors in series. The longer the…