What will be the MOSFET operation if Vth = 1.2V and k = 0.5 mA/v^2?

Q: Compare between squirrel cage rotor and drag cup-rotor

A: 5

Q: Rs Vs R₁=1K beta = 100 Vbe = 0.7 V Vce,sat = 0 V a. What is Vo if Vs = 3 V and Rs = 0 b. What is Vo…

A:

Q: junction is forward biased and If the emitter-base the collector-base junction is reverse biased,…

A: There are mainly four types of regions such as Active region, Saturation region, Cutoff region and…

Q: 9) Which type/types of Amplitude Modulation signal/signals can be detected by the Envelope Detector?…

A: We can detect double side band (DSB) signal by envelope detector. Also DSB-SC, SSB and VSB signals…

Q: 3. What the value of Phasor shift if R=3000 L=400mH with f = 50 Hz. discuss the increase or decrease…

A: Determine the value of the angular frequency as, ω=2πf=2π50=314 rad/s Determine the value of the…

Q: If the average daily load is 67.78 MW what is the weekly load (MWh)?

A:

Q: find capacitor voltage (calculate please) Let us compute the voltage across the capacitor for t20…

A:

Q: 15. Consider this ideal transformer circuit: i(t) 10 Ω W 5:4 v (t) = 155 cos (5t) V 10 H vo(t)…

A: The solution is given below

Q: Vs O Rs M +5V S Vo itu R₁=1K

A:

Q: 11. In Electrocogligraphy (ECOG) the signal of interest is similar to what is shown below, x(t) (the…

A: It is the technique for the measurement of the corneo retinal standing potential hat occur between…

Q: BJT acts as a switch in Oin saturation region in cut off region in saturation and cut off region in…

A: The correct option is

Q: BJT has a current gain Beta of 100.If base current is 2 μA,what is c collector current = 200 micro…

A: Given: A BJT has a current gain, β=100 Base current, IB=2 μA=2×10-6 A

Q: Given the schematic below, assume D1 and D2 are silicon with forward voltages of 0.7V. Find the…

A:

Q: ransfer function and show that the high-frequency gain is (-R₂/R₁) and the 3-dB frequency co-1/CR₁.…

A:

Q: Implement the Function 'Y = ACB + BC + E' using a 4-Input, 2-Address Bit Multiplexer. What are the…

A: It is asked to implement the function 'Y = ACB + BC + E' by using a 4-Input, 2-Address Bit…

Q: 9) An ac circuit takes a load of 160 kva at a lagging power factor of 0.75 when connected to a 460…

A: Given  Apparent power=160 kva  Power factor =0.75 Source voltage=460 v  We need to find real…

Q: 11.24 In a balanced three-phase wye-wye system, the source is an abe-sequence set of voltages. Zine…

A:

Q: The switch in the circuit has been in position b for a long period of time and at t = 0 it moves to…

A: In this question we will find inductor current and voltage etc....

Q: B-Derive the expression for the measurement of the unknown resistance using Kelvin's double bridge.…

A: The Kelvin Bridge is a modification of the Wheatstone bridge and provides greatly increased accuracy…

Q: - 8V R₁ = 1.2 k√√2 O u +12v R2= 2.5K O R3=5602 Analyze the circuit using any circuit analysis method…

A: In this question,   We need to calculate the diode current and voltage across the diode?  Voltage…

Q: What is the phasor representation of I(t)=IOcos(ωt) at half-period? A.← B.↑ C.→ D.↗

A:

Q: Communication Fundamentals Second Year Homework 1 // AM transmitter has a total power (480kw) and…

A:

Q: Q1):- Find the T.F of DE (h[n]) Y[n] 2X[n] +3X[n-1] - X[n-2] + 17X[n-3] - 6X[n-4]+Y[n-1] -3Y[n-2]

A:

Q: Find the capacitance of a parallel plate in (uF) capacitor if the charge is 589.8 µC .and the…

A:

Q: Determine V, and I for each circuit in Fig. 2-5. Assume that each of the diodes in these circuits…

A: We need to find out voltage and current for given circuit.

Q: A power station consists of two synchronous generators A & B of ratings 250 MVA and 500MVA with…

A: Given a power station consists of two synchronous generators A & B, Synchronous generator A…

Q: How long does a 20-4F capacitor charged to 150 V take to discharge through a 3-MQ resistor? Also, at…

A:

Q: In a tansistor, IC = 100 mA and IE = 100.2 mA. The value of ß is O 100 O 200 50 O about to1

A: Given, Collector current, IC=100 mA Emitter current, IE=100.2 mA

Q: Write the mesh equations for the network of Fig. 18.69. Determine the current through the resistor…

A:

Q: Example4/ A telephone cable with R=52.5 KQ/Km, C=62 nF/Km, G=0 and L=1.1 mH/Km, find,x,ß,Vp and λ,…

A: Given a telephone cable with, Resistance, R=52.5 kΩkm Capacitance, C=62 nFkm Conductance, G = 0…

Q: Q#3. For a CMOS inverter assume, C=150 ff and VDD-5V. The inverter is cycled through the low and…

A: Given  For a CMOS inverter , C=150 fF  Vdd=5 v  F=75 MHz. We need to calculate the dynamic power…

Q: Q2VA-An Owen Bridge is used to measure the properties of a sample of shee at 2 KHZ. At balance, arm…

A: In this question we have given owens bridge....We have to derive it's balance conditions and find…

Q: 9

A:

Q: The current '1' and '1₂' in the circuit s

A:

Q: Find the step responses t) and (t) to vs = 5 u(t) V in the circuit of figure below. 12 92 792 i(t) |…

A: We need to find current and voltage for given circuit.

Q: . Construct the vector diagram that would represent the voltage and current of each parallel…

A: In this question,   We need to construct the vector diagram if voltage is reference and current as…

Q: uestion - Ignoring any mutual inductance, what is the equivalent inductance of two inductors…

A: (a) Equivalent inductance for series connection For series connection current through inductors are…

Q: A system is characterized by the differential equation: y(n) = y(n-1)-y(n-2) + x(n) + x(n-1). Sketch…

A: here they given a differential equation and asked to sketch the direct form 1 and 2 structures.

Q: 2.126 For an amplifier having a slew rate of 40 V/us, what is the highest frequency at which a 2-V…

A:

Q: 2 K + D₁ + 1 K Vo Vi D₂ 2.6 V 0 Diodes D1 and D2 are Silicon with forward voltages of 0.7 volts. v.…

A:

Q: An aerial having a directivity of 90 is operating at a wavelength of 2 m. The maximum effective…

A: Given an aerial having, Directivity, D = 90 Operating wavelength, λ=2 m

Q: QA.3 A 380 V, 50 Hz, 6-pole, 960 rpm, star connected induction motor has the following parameters:…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: he switch in the circuit has been in position b for a long period of time and at t =0 it moves to…

A:

Q: + Vi 2 K D₁ 2.6 V D₂ A 1 K Vo

A: D2 conducts only  when,if the input voltage (Vi) is lessthan zero volts. Here in this case  Output…

Q: 2. Explain why Phasor and impedance diagrams have the same angles. 2 II/L of Phacon shift if D 2000…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: BJT acts as a switch in O in saturation region O in cut off region in saturation and cut off region…

A: There are mainly four types of regions such as Active region, Saturation region, Cutoff region and…

Q: The input power to a 3-phase a.c. motor is measured as 5 kW. If the voltage and current to the motor…

A:

Q: 2.63 Find the voltage gain vo/via for the difference amplifier of Fig. 2.16 for the case R₁ = R3 = 5…

A: Given: R1=R3=5kΩR2=R4=50kΩ

Q: The switch in the circuit has been in position b for a long period of time and at t = 0 it moves to…

A:

Q: Assume beta = 100, V, = 0.7 V, V = OV. BE CE,sat a. If R = 0 and V₁ = 3 V, determine the value of V.…

A: