aluminum tube with the cross section shown has a constant wall thickness of 2 mm. A torque T = 400 N·m is applied to the tube. Use G= 28 GPa What is the area of the tube? a. 957.08mm2

Q: Determine the gravitational force F which the titanium sphere exerts on the copper sphere. The value…

A:

Q: A metallic rod made of steel as shown below is used as support for a signage with length equal to…

A:

Q: echanical Engineering cable is 5000 m long eighs 49kg/m has a diameter of 133 mm nd a maximum…

A:

Q: Replace the three forces shown by an equivalent force-couple system at point A. If the forces are…

A:

Q: A) Water at 70 °C flows up a 50-ft-long conical pipe with its centerline sloping at 5° to the…

A:

Q: A 27m3 CUBICAL TANK IS FULL OF TWO DIFFERENT FLUIDS OF EQUAL PARTS. AN OBJECT WAS THROWN AND WAS…

A: When a body is submerged partially or fully in a fluid then, it experience the upward buoyancy force…

Q: 4. Find the horizontal force F to keep the gate closed. The gate is 2 m wide and 1.5 m in height.…

A: The horizontal force required to keep the gate closed: F = 7.63 kN

Q: The weight of one dozen apples is 2.9 lb. Determine the average mass of one apple in both SI and US…

A:

Q: A piston moves with constant velocity Up in a cylinder having radius R. A liquid having density p…

A:

Q: B) Water flows in 50 mm pipe, 100 mm long whose roughness is 0.013 mm. If the pressure drop across…

A: Given data -  Pipe diameter = 50mm. Length of pipe = 100mm. Pipe roughness = 0.013mm. Pressure drop…

Q: Which of the following is the correct statement?   a. Irreversible engines have maximum efficiency…

A: 1 Irreversible engines have maximum efficiency. In the irreversible engine, there are various types…

Q: Two pipes 1 and 2 having the following properties are connected in series: Pipe 1 - Length = 1500m,…

A:

Q: A heat pump with the COP of 2.2 supplies heat at the rate of 219 kJ/min. Determine the rate of heat…

A: GIVEN DATA- COP=2.2 HEAT SUPPLY=219KJ/min WE HAVE TO FIND RATE OF HEAT TRANSFER FROM ATMOSPHERE

Q: stress-strain diagram of a certain material is shown below. Determine the modulus of toughness of…

A:

Q: Find the absolute acceleration of slider in m/s². 8 rad/s 24 rad/s 2 m 12 m/s² 5 m/s 4 Slider

A:

Q: regenerative Rankin cycle

A:

Q: elastic curve

A: dVdx=-w(x)=-wox2V=-w0x33+C1Apply boundary conditionx=L;V=0C1=w0L33…

Q: Determine the distance h for which the spacecraft S will experience equal attractions from the earth…

A:

Q: Which among the following is/are scalar quantities? (No partial points.) Force Acceleration Weight…

A: Concept: 1) Vector quantity has both magnitude and direction.  2) Scalar quantity has only…

Q: Q1: Find the result of the system of converging forces in Figure (1).

A:

Q: Bodies A and B are connected by a flexible cable as shown in the figure below. The weights of bodies…

A:

Q: ceilings

A: Sea level maximum R/C condition Lift coefficient for maximum rate of climb CL=-TW+TW2+12CD,OK2K…

Q: Determine the reaction components for the rigid body in the figure. 4 B 6 ft 10 ft 40 k 31 112 12 ft

A: To determine the reactions.

Q: Thermodynamic problem. Determine the work necessary to compress a gas from an initial volume VI=90L…

A:

Q: Water with flow rate of 12 lps from ground level is delivered to upper levels using the 50-mm…

A: Given,  The water flow rate, Q = 12 L/s The diameter of pipe, d = 50 mm The angle between inlet and…

Q: Thank you, I understand it now! What value of g did you use?

A:

Q: A cylindrical cold storage facility with an inner diameter of 4m and height of 2m is constructed.…

A:

Q: Find the moment of mass from the x-axis for y = x ln(x) - 3x and y = 1 bounded by x = 3 and x = 6.…

A: Write the given data. f(x)=xlnx-3xg(x)=1limits, x=3 to x=6ρ=0.37  kg/unit2

Q: Q\ Compare between Permanent Magnet Synchronous motor and Reluctance motor and single phase…

A: Introduction: Synchronous aversion This is a synchronous electric motor with no field windings or…

Q: What is the difference between centrifugal pump and reciprocating pump ? Give at least eight points.

A: Following is the comparison between the centrifugal pump and the reciprocating pump : Centrifugal…

Q: Determine the absolute weight and the weight relative to the rotating earth of a 103-kg man if he is…

A:

Q: Q4/The outside wall of a building 6 m high receives an average radiant heat flux from the sun of…

A:

Q: The 30-lb package A has a speed of 5 ft>s when it enters the smooth ramp. As it slides down the…

A:

Q: At what altitude h above the north pole is the weight of an object reduced to 75% of its…

A: Given question: At what altitude h above the north pole is the weight of an object reduced to 75% of…

Q: It is proposed to have carbon dioxide (CO2) gas pass through an uninsulated nozzle.  The CO2 is to…

A:

Q: Repeat the previous problem with a closed FWH w/ the same turbine efficiency of 85% but with only…

A: Introduction: All major steam power plants rely on the Rankine cycle. High-temperature,…

Q: mila = 3 = 15 kg/s . H = 6 km T₁ = 249 K Mo = 0.6 P04 = 0.96P03 d = 0.95 CC = 0.98 Pa = 47.2 kPa…

A: ma=3=15kg/s˙Ta=249KMo=0.6P04=0.96P03ηd=0.95ηC.C=0.98ηg=0.95CpC=1.01kJ/kg KQR=43,000…

Q: A single-acting two-stage air compressor deals with 4 m³/min of air at 1.013 bar and 15°C with a…

A: At 1.013 bar and 15 degrees C, we have a single acting two stage air compressor that can handle 4…

Q: a box of mass 2.6 kg, starting from rest falls a vertical distance of 55 cm before striking a…

A:

Q: A single block brake, as shown, has a tangential braking force of 2500 N and normal force of 9000 N…

A:

Q: The University of Ice Hockey Club is working on a practice drill where two players try to precisely…

A: Before impact: Write the velocity in direction of impact. vAn=4cos15°=3.86 m/svBn=-4sin15°=-1.035…

Q: what is the minimum initial velocity a rocket must be fired if it is to be able to reach the target…

A:

Q: A refrigeration system is to be used to constantly maintain a space at -12°C in an industrial…

A:

Q: words what is safety?

A:

Q: Steam turbines received 400000 kg/hr of steam throttled in actual reheat Rankine cycle with two…

A: Given: The mass flow rate of steam, m = 40,0000 kg/hr = 111.11 kg/s The temperature at the turbine…

Q: Q3: Find Req. between points (A&B) in the network in fig.(3). (25 mark) 2√2 $6₁ 4.2² lon 8r Fig.3 A…

A:

Q: From the given s-t graph below, construct the v-t and a-t graphs. Show your complete solution. S…

A:

Q: In an undisturbed airstream, where pressure is 14.7 lb/in² and temperature is 59F, the velocity is…

A: Given dataPressure = 14.7 lb/in2 = 101.3529 kPaTemperature = 59°FVelocity = 520 ft/s = 158.496 m/sWe…

Q: Read, analyze and solve for the following. Express your answers as decimals rounded off to two…

A:

Q: what is the packaging materials, by product, waste, and common utilities used in distillery plant of…

A:

Pressure Vessels

The term pressure vessel refers to a closed container that contains gas or liquid at a different pressure than environment pressure. The pressure vessels have a wide scale of applications in our day-to-day lives and other industrial places. Some common examples of pressure vessels are gas cylinders, autoclaves, compressor vessels, etc.