What will be the voltmeter reading for the below given electrical network? ww 6Ω 4A 3Ω ΖΩ

Q: 17. Which of the following can be used to bond the metal parts at services? A. Ground clamps B.…

A: Note- According to our policy, we can answer only one question, please post other question as…

Q: Q1: MCQ 1- class-B push pull power amplifier has maximum efficiency (25%, 50.5%, 78.4%, 90%). 2- The…

A: We are authorized to answer three subparts at a time since you have not mentioned which part you are…

Q: 1. Determine whether or not each of the following signals is periodic. In a signal is periodic,…

A: In this question , we will find time period of given signal if they are periodic.

Q: Draw the output waveforms (S, U, and V) for the below sequential circuit b assuming the propagation…

A:

Q: The starting current of a 15-hp, 440 volt, and three-phase induction motor is 32 amperes when rated…

A: Three phase induction motor is convert the electrical input to mechanical output. Three phase…

Q: A PMMC instrument has a three resistor connected across it to design multi- ranges indirect method…

A: In this question we need to find the range of the ammeter and it circuit.

Q: Using linear D.E., find the response i. 14 Q2 2H www 28 u(t) V (+

A: To find the response i using Linear Differential equation

Q: 3: Design an asynchronous counter that divides the input clock signal by 5 then draw counter's logic…

A:

Q: Determine the voltage at resistor R1. (assume Zener voltage is 4 volts and Diode forward voltage is…

A: The voltage across the resistor can be calculated by using potential across the diode or the zener.

Q: 1. A spherical Gaussian surface surrounds a point charge (q), if the radius of the sphere is…

A: Gauss Law states that the total electric flux out of a closed surface is equal to the charge…

Q: 23: Find the Laplace transform for figure below. (3) (3)H ori mod samogaon sdi (3 ei tuqni -…

A:

Q: Calculate the reactive power delivered by the 5 V voltage source in the following circuit.

A: The given circuit is as shown below,

Q: Find h(t) Let H(s) = 1 S²(S-a) (use Couvolution theorem)

A:

Q: 1. The circuit below shows a three-phase system with two loads. The delta-connected generator has a…

A: Three phase system is transmission of bulk power of transmission. It consist of three phase voltage…

Q: Review Questions: 1- Design a 4x1 Mux. Using enable Pin line at low active?

A: As per the guidelines of bartleyby I need to answer first question only ¹so kindly repost other…

Q: Design an asynchronous counter that divides the input clock signal by 5 then drav counter's logic…

A: Asynchronous counters are counter whose triggering pulses are not dependent on the clock pulses.…

Q: 1. The networks in which the R. L. C parameters are individually concentrated or lumped at discrete…

A: We need to select correct option for given statement

Q: 9 Handwritten

A: Note: As per Bartleby guidelines, we are supposed to provide solution for 1 question only as there…

Q: for FIR digital LPF with following specifications . -1dB at 0.08x rad/sample . -38dB at 0.7%…

A: FIR refers to finite pulse response filter the impulse response of the filter is finite at finite…

Q: Make a comparison between the bath and state functions in the following points: 1) relation to path.…

A: The comparison between the path and state functions are given below, 1. Relation to path - State…

Q: 7. When a transmission line has a load impedance same as that of the characteristic impedance, the…

A: In this question,  We need to choose the correct options When a transmission line has a load…

Q: Q2 / Design asynchronous counter using negative edge J-K flip flop for the following sequence (3→ 4⇒…

A: In diagram at terminals of flip flop the connection is mentioned and not connected as it look a bit…

Q: The electric field at the origin due to electric potential V=(x-2)² + (y+2)² + (z-1)³ is (4ax - 4ay+…

A: Option B is correct Electricic field increses in the direction opposite to potential scalor function…

Q: Given G = 20a, + 50a, + 40a, at (1, π/2, π/6) the component of G perpendicular to surface = π/2 is…

A: Types of coordinates system  Cartesian coordinate system  Cylindrical coordinates system  Spherical…

Q: Q1: Plot the Bode for the following system using the Tabulation method on the attached log paper (s…

A:

Q: Q2:- An electrodynamometer type wattmeter has a current coil with resistance 0.202 and a pressure…

A: Given, Current coil resistance, Rc = 0.2 ohm  Pressure coil resistance, Rp = 7 kohm  Load current,…

Q: For static (time-independent) fields, which of the following current densities are possible? (a) J =…

A:

Q: A 240-V, short-shunt, cumulative compound generator is rated at 100 A The shunt field current is 3…

A: Efficiency: It tells that how much input power in applied to the machine and how much power is…

Q: the relation between armature and field currents in a series connected DC motor is O It = If + la O…

A:

Q: G/Verify the following identities Zanh ( x + y) = tanhx + tanky 1 + tanha tanhy

A:

Q: The phasor current I in the circuit shown PSPICE Fig. P9.36 is 25/0° mA. MULTISIM a) Find I₁, Ie,…

A:

Q: A spring balance calibrated in an environment of temperature 20°C has the following deflection-load…

A: Zero drift- it is the point where the zero reading changes under environmental conditions.…

Q: 7.2 Use the differential equation approach to find v(t) for t> 0 in Fig. E7.2. Plot the esponse. t =…

A: We need to find out voltage across capacitor in the given circuit

Q: A d.c. series motor is running whith a speed of 800 r.p.m. while taking a current of 20 A from the…

A: Given: N1=800 rpmIa1=20AIa2=50ARa=0.2ΩRse=0.3ΩV=250Volt

Q: B- Two 1-phase furnaces a and b are supplied at 80V by means of a Scott-connected transforme…

A: A Scott connected transformer is used for producing a two phase electrical circuit from a three…

Q: Find the voltage gain for this circuit. It uses an ideal operational amplifie R₂ www 6 kQ R₁ ww 21 3…

A: Given: Operational amplifier,

Q: Maximum end-end throughput. Consider the scenario shown below, with 10 different servers (four…

A: Throughput is measure the send data through a network. Delay depends the number of host and…

Q: Planes x = 2 and y = - 3, respectively, carry charges 10 nC/m^2 and 15 nC/m^2. If the line x = 0, z…

A: Charge density determine the how much charge stored in a field. Charge density measure in term of…

Q: |► Q)3(b) Draw the bode plot of G(S) = Sn

A:

Q: If H=0.2 z² ax, V x H is 0.4z ay O 0.4z ax O None of the above 0.4z az O

A:

Q: a) (5, 65.62°, 106.43°) b) (6, 66.62°, 107.43°) c) (7, 64.62°, 108.43°) d) (8, 64.62°, 107.43°)

A:

Q: Q2: A rectangular loop of wire in free space joins point A(1, 0, 1) to point B(3, 0, 1) to p C(3, 0,…

A: Solution- Given, μ0=4π×10-7 ,    I1 = 15A a) H1x=I12πx    for side BCB=μ0HB1x =I1μ02πx…

Q: ujt triggering of scr i need a circuit for my power electronics project

A: UJT refers to Unijunction transistor, it is a semiconductor device consisting of three leads with…

Q: Prove dx(t)/dt________Laplace_ _sX(s)

A: Laplace transform is used to analyze the continous time domain signal into s domain or frequency…

Q: Find Laplace transform of the function shown below:- 07

A: In this question,  We need to determine the Laplace transform of the given signals.  We know…

Q: What is the correct electric field vector at point P due to source charge q=-25C? Use…

A: Given diagram

Q: b Find ILT of S³-1 S²+s+1

A: In this question,  We need to determine the inverse Laplace transform of the given signals.  We know…

Q: Q2 A- The Following Reading Was Recorded for Voltage Measurement 10.11,9.6.9.2,9.5, 10.11, 9.2,…

A:

Q: maximum power. Figure 6 Fig. 6 for maximum power to the load, and find the 80:42 160 Ω -1302 120/60°…

A: Solution- for maximum power transfer theorem, RL=Rth for thevenin impedance across a& b is Zth,…

Q: Design an asynchronous counter that divides the input clock signal by 5 then draw counter's logic…

A: The initial values of the asynchronous counter are always "0" An Asynchronous counter can also be…

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.