Three blocks where suspended in the air using massless strings and passing through massless and fixed pulleys as shown. The middle mass m3 = 5.00 [kg]. When the system achieved equilibrium, it was found out that a = 60.0° and y= 30.0°. MA What is the magnitude of m? What is the magnitude of me? α тв What would be the magnitude of mA and me when a = y = 45.0°? O mc

Three blocks where suspended in the air using massless strings and passing through massless and fixed pulleys as shown. The middle mass m3 = 5.00 [kg]. When the system achieved equilibrium, it was found out that a = 60.0° and y= 30.0°. MA What is the magnitude of m? What is the magnitude of me? α тв What would be the magnitude of mA and me when a = y = 45.0°? O mc

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter12: Static Equilibrium And Elasticity

Section: Chapter Questions

Problem 68P: An aluminium (=2.7g/cm3) wire is suspended from the ceiling and hangs vertically. How long must the...

See similar textbooks

Similar questions

Your task is to design a light‐weight tie of length L with a circular cross‐section of radius R. It must carry an axial force F, without stretching by more than δ. You will need to choose the material (with Young’s modulus E and density ρ) and the corresponding crosssection radius to suit your choice of material, i.e. R is a “free variable”,a) Show that the extension of the tie is given by δ = FL/AE, where A = πR2
Find the elongation of a rod made of aluminum and copper under a tension of 5.8×103 N. The dimensions of the rod are R=0.5 cm, LAl=10.5 m, LCu=5.5 m (Young moduli are 7.0×1010 Pa for Al and 11×1010 Pa for Cu)
An axial pull of 1.5 kN is acting on a bar of consisting two equal lengths as shown but of diameter 10cm and 20 cm respectively. What will be the stresses in the two sections respectively in N/mm2? A. 0.153 and 0.0036 B. 0.290 and 0.046 C. 0.190 and 0.0046 D. 0.124 and 0.124
Two parallelepipeds connected by a rope of negligible mass are pulled by a horizontal force, as shown in the figure. Assume that F = 964 N, m1 = 26.1 kg, m2 = 43.4 kg, that the coefficient of kinetic friction between each block and the surface is 0.4 and that the modulus of the gravity acceleration is g = 10 m /s^2. What is the magnitude of the acceleration of the system m/s^2? a. 2,67 b. 13,23 c. 21,42 d. None of the other alternatives are correct. e. 32,67 f. 16,98 g. 9,87 h. 8,78
A 200.- kg load is hung on a wire of length 4.00 m, crosssectional area 0.200 x 10-4 m2, and Young’s modulus 8.00 x 1010 N/m2. What is its increase in length?
In the Challenger Deep of the Marianas Trench, the depth of seawater is 10.9 km and the pressure is 1.16×10^8 Pa, (about 1150 atmospheres). If a cubic meter of water is taken to this depth from the surface (where the normal atmospheric pressure is about 1.0×10^5 Pa), what is the change in its volume? Assume that the bulk modulus for seawater is the same as for freshwater 2.2×10^9 Pa. Report in cubic meters.
A 200-kg load is hung on a wire with a length of 4.00 m, a cross-sectional area of 0.200 x 10-4 m2,and a Young’s modulus of 8.00 x 1010 N/m2. What is its increase in length?
Three electrical charges isolated from the rest of the universe are located at the vertices of an equilateral triangle. Charge 3 attracts charge 1 with a force of modulus F1(3) = 4.3 N and repels charge 2 with a force of modulus F2(3) = 6.7 N. What is the modulus of the sum of the reaction forces on the charge 3 in Newtons? a. 10,95 b. 8,45 c. 9,60 d. None of the other alternatives are correct. e. 12,39 f. 2,21 g. 15,17 h. 0,86
overhead view of a rigid rod that turnsabout a vertical axle until the identical rubber stoppers A and B are forced against rigid walls at distances rA = 7.0 cm and rB = 4.0 cmfrom the axle. Initially the stoppers touch the walls without beingcompressed.Then force of magnitude 220 N is applied perpendicularto the rod at a distance R = 5.0 cm from the axle.Find the magnitudeof the force compressing (a) stopper Aand (b) stopper B.
Suppose that we have two hanging rods of the same length 2.8 m. However, their cross sections are a circle with radius 3.5 mm and a square with sides ( 2•3.5 ) mm. Both rods have the same Young’s Modulus of 1.5 × 1011 N/m2. a) If we attach a heavy ball of mass 24 kg at the end of the first rod (the one with the circular cross section), how much would it stretch in millimeters? b) If we attach the same ball of mass 24 kg at the end of the second rod (the one with the square cross section), how much would it stretch in millimeters?
A shaft having length equal to 10 m and diameter equal to (50 + 21) mm is simply supported at both ends. The shaft carries four masses (150 + 21) kg, (200 + 22) kg, (250 + 21) kg and (300 + 21) kg. These masses are located at a distance of 1.5 m, 2.5 m, 5.5 m and 7.5 m from the left hand side support, respectively. The modulus of elasticity, E, for the material of the shaft is 200 GN/m2 and mass density for the shaft material is 7500 kg/m3. Determine critical speed of the shaft in revolutions per minute for the following two cases: i. Effect of the mass of the shaft is neglected. ii. Effect of the mass of the shaft is considered. What is the usefulness of the answers determined in this problem?
Some people modify cars to be much closer to the ground than when manufactured. Should they install stiffer springs? Explain your answer.