When a 3-kg collar is placed upon the pan which is attached to the spring of unknown constant, the additional static deflection of the pan is observed to be 42 mm, determine the spring constant k in N/m, Ib/in and Ib/ft. 3kg 42 mm 4.00 N/m, 48.0 lb/in, 701 lb/ft O 701 N/m, 48.0 lb/in, 4.00 Ib/ft 48.0 N/m, 4.00 lb/in, 701 lb/ft O701 N/m, 4.00 lb/in, 48.0 Ib/ft

When a 3-kg collar is placed upon the pan which is attached to the spring of unknown constant, the additional static deflection of the pan is observed to be 42 mm, determine the spring constant k in N/m, Ib/in and Ib/ft. 3kg 42 mm 4.00 N/m, 48.0 lb/in, 701 lb/ft O 701 N/m, 48.0 lb/in, 4.00 Ib/ft 48.0 N/m, 4.00 lb/in, 701 lb/ft O701 N/m, 4.00 lb/in, 48.0 Ib/ft

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter10: Virtual Work And Potential Energy

Section: Chapter Questions

Problem 10.55P: Solve Prob. 10.54 assuming that A and B are connected by a spring of stiffness k = 0.3 W/b and free...

See similar textbooks

Similar questions

Given a product weight of 20 kg, determine the static deflection of a protective cushion with a spring constant of 500 kg/m.
The force-deflection relation of a steel helical spring used in an engine is found experimentally as F( x) = 200 x + 50 x2 + 10 x3, where the force (F) and deflection (x) are measured in pounds and inches, respectively. If the spring undergoes a steady deflection of 0.5 in. during the operation of the engine, determine the equivalent linear spring constant of the spring at its steady deflection.
1. A sling shot was released in a vertical direction using a rubber band having an equivalent spring constant of 2N/mm. If the deflection of the rubber band amounts to 10cm and the mass of the stone is 21g, determine the maximum height (above the undeflected position of the sling) the shot can reach. Derive with the formula below, show the cancellation, explain the step by step and DRAW a free body diagram/figure. Refer with this: PE1 + KE1 + U1 + WF1 + Q1 + W1 = PE2 + KE2 + U2 + WF2 + Q2 + W2 + E losses.
an object weighing 4lb, when hung from the ceiling, stretches a spring by 6in at equilibrium. the mass is attached to a viscous damper with a damping constant of 1.5lbsec/ft and is set in motion from its equilibrium position with an upward velocity of 3in/sec. taking the downward direction as the positive direction, fin the displacement y(t) in ft of the system from the equilibrium position at any time > or = to 0. ( g=32ft/sec^2)
A spring has a spring constant of k=18N/m, hung with a weight of mass m=½ kg. If the load is in an equilibrium position, then it is pulled and released with a speed of 3 m/s, then determine the equation of motion of the object if it does not experience friction or damping.
Three series springs have stiffness constant of 100 N/m each. Determine the spring stiffness equivalent of the springs. a.)100 N/m b.)300 N/m c.)0.01 N/m d.)33.3 N/m
A mass-spring-damper system has a l0ad 0f 2 kg, a spring c0nstant 0f 8 N/m, and a damping c0efficient 0f 8 N/s.m. The system is initially in equilibrium. At t=0, the mass is given an initial vel0city 0f 3 m/s d0wnwards. Determine the p0sition vs time (t) of the l0ad. Is the system underdamped, 0verdamped, 0r critically damped?
In the experiment on the spring-mass system, a mass of 1.8 kg is applied and the stiffness (k) of the spring is 207 N/m. Find the natural frequency () of the spring-mass system in rad/sec and the deflection of the spring (?) in mm.
Question 1 In order to reduce vibrations being transmitted to the floor, a machine of mass m = 150kg is supported on 4 helical steel springs together with 4 dashpots which all act in parallel with each other. The stiffness of each spring is given by k1= 3.7 MN/m, and the damping coefficient of each dash-pot is given by c1 = 6.1kNs/m. To test how well the isolation system works, the machine is turned off and a shaker that produces a driving force of 100N at a frequency of 65 Hz is attached to the machine, causing it to vibrate. The mass of the shaker is negligible compared to the mass of the machine. Use a phasor diagram to determine: The displacement amplitude X of the machine, The phase angle by which the driving force leads the displacement.
Three parallel springs have stiffness constant of 100 N/m each. Determine the spring stiffness equivalent of the springs. 300 N/m 0.01 N/m 100 N/m 33.3 N/m
27-(a) A body of weight 440 N body moving to the left with a velocity of 10 m/s collides with another body of weight 760 N body which is at rest. After impact the body which is moving before impact comes to rest. Find the final velocity of body after impact and the coefficient of restitution . (b)A vehicle of mass 21 tonnes runs into a buffer stop having two buffer springs connected in series each of 1750 kN/cm and 2200 kN/cm stiffness respectively. Find the maximum compression of the springs, if the vehicle is travelling at 90 km/hr. Also calculate the load acting on the spring. a,Solution The final velocity of body after impact in m/s is The coefficient of restitution is b,Solution The maximum compression of the spring in mm is The load acting on the spring in kN is
Determine the natural frequency of the spring-mass system as shown in Figure. The values of spring constants K1=K2=K3=K4=K5=K6=100 N/m. The mass m=10kg.Required to answer. Single choice. OPTIONS: 1.About 1.211 Hz 2.About 0.871 Hz 3.About 0.520 Hz 4.About 0.620 Hz 5.None